Abstract
In this study an effective stress analysis was performed to evaluate liquefaction potential and ground settlement for reclaimed sites. The effective stress model can simulate the stiffness degradation due to excess pore pressure and resulting ground deformation. It is applicable to a wide range of strain. An equivalent linear analysis suitable for low strain levels was also carried out to compare the effective stress analysis. Shear stress ratio calculated from an equivalent linear analysis was used to determine SPT blow count to prevent liquefaction. Depending on the magnitude of potential earthquake and fine contents, the SPT blow count was converted into an equivalent cone tip resistance. It was compared with the measured cone tip resistance. The measured elastic shear wave velocity and cone tip resistance from two reclaimed sites in Incheon were used to perform liquefaction analyses. Two liquefaction evaluation methods showed similar liquefaction potential which was evaluated continuously. The predicted excess pore pressure ratio of upper 20 m was between 40% and 70%. The calculated post-shaking settlement caused by excess pore pressure dissipation was less than 10 cm.
본 연구에서는 흙의 미소변형에서 대변형까지 고려할 수 있는 유효응력해석을 이용하여 매립지반에 대한 액상화 및 진동으로 발생하는 침하량을 예측하였다. 유효응력모델은 진동 중에 발생하는 과잉간극수압을 계산하여 이에 따른 흙의 강성저하와 수반되는 지반의 변위를 모델링하였다. 진동으로 인한 지반의 변형률 수준이 작은 경우에 적합한 등가선형해석을 이용한 액상화 평가를 실시하여 유효응력모델을 이용한 예측법과 비교하였다. 등가선형해석에서 계산된 전단응력비에 해당하는 표준관입시험치를 국내에서 발생 가능한 지진규모와 실트질 함유량에 따라 콘관입저항치로 환산한 값과 현장에서 계측된 콘관입저항치를 서로 비교하여 액상화 가능성을 예측하였다. 두 곳의 인천지역 매립지에 대한 액상화 해석을 위하여 매립지에서 계측된 콘관입저항치와 전단파 속도를 이용하여 입력 물성값을 결정하였다. 인천 매립지에 대한 두 액상화 해석 방법의 결과는 액상화 발생 여부에서 유사하였으며 깊이에 따른 연속적인 액상화 판정과 얇은 층의 액상화 예측이 가능하여 액상화 예측의 정밀도를 높였다. 유효응력모델을 이용한 액상화 해석 결과는 지표면 아래 20m 이내에서 초기 유효수직응력의 40%~70% 정도의 과잉간극수압이 발생하였으며 이로 인하여 지표면에서 10cm 미만의 침하가 발생하였다.