• 한국연소학회:학술대회논문집
• /
• 2002.06a
• /
• pp.237-246
• /
• 2002

가압유동층연소로(bed dia. 0.17m, freeboard dia. 0.25, total height 5m)에서 국내무연탄을 연소시켜 이에 대한 탈황특성을 고찰하였다. 실험은 압력($2{\sim}6atm$), 요동층온도(($850{\sim}950^{\circ}C$), 과잉공기(10, 20, 30,%)등의 조건과, 탈황을 위한 Ca/S몰비(($0.8{\sim}4.8$)가 탈황특성에 미치는 영향을 고찰하였다. 결과적으로, 본 연구의 실험범위에서 연소효율은 $80{\sim}99%$를 보였고, 연소온도, 압력 그리고 과잉공기가 증가 할수록 증가하였다. 배가스중의 $SO_2$배출농도는 압력, Ca/S몰비가 증가함에 따라 감소하였다. 탈황율은 상압에서 층(bed)온도의 증가에 따라 감소하였다. 운전압력이 증가함에 따라 탈황율의 감소폭이 둔화되었다. 과잉공기가 증가함에 따라 탈황율은 증가하는 경향을 나타냈다. 각각의 운전압력에서 과잉공기의 증가에 따라 약 10%의 증가폭을 보였다. 국내무연탄을 연소하는 경우 운전압력 4atm일 때 Ca/S몰비는 4이상 주입하여야 하고, 6atm일 때 Ca/S 몰비가 2.5이상주입하여야 150ppm이하를 보여 배출규제치를 만족하는 것을 보였다.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2009.11a
• /
• pp.213-216
• /
• 2009

In order to see the flame behavior in the gas turbine combustor, combustion test was performed by using sector combustor. Ignition test with torch ignition system was carried out at the various combustor inlet velocity and air fuel ratio. Also, flame blow out limit was measured by changing fuel flow rate with fixed air mass flow rate. In the test results, stable ignition is possible at air excess ratio of 6 and this limit is gradually increased with combustor inlet air velocity. The minimum blow out limit is about 4 at 40 m/s of combustor inlet velocity. This blow out limit is also increased up to about 10 with increasing combustor inlet velocity.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.15 no.4
• /
• pp.11-17
• /
• 2011

In order to see flame behavior in the annular reverse gas turbine combustor, sector combustion test was performed. Ignition test by using torch ignition system was carried out at various combustor inlet velocity and air fuel ratio. Also, flame blow out limit was measured by changing fuel flow rate with constant air mass flow rate. In test results, stable ignition is possible at air excess ratio of 6 and this limit is gradually increased with combustor inlet velocity. The minimum blow out limit is about 4 at 40 m/s of combustor inlet velocity. This blow out limit is also increased up to about 10 with increasing combustor inlet velocity. Test result shows that lean blow out limits are increased with air velocity. The highest blow out limit was found at the combustor inlet velocity of 65 m/s.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2010.11a
• /
• pp.153-159
• /
• 2010

In order to see the flame behavior in the annular reverse gas turbine combustor, sector combustion test was performed. Ignition test by using torch ignition system was carried out at the various combustor inlet velocity and air fuel ratio. Also, flame blow out limit was measured by changing fuel flow rate with constant air mass flow rate. In the test results, stable ignition is possible at air excess ratio of 6 and this limit is gradually increased with combustor inlet velocity. The minimum blow out limit is about 4 at 40 m/s of combustor inlet velocity. This blow out limit is also increased up to about 10 with increasing combustor inlet velocity. Test result shows that lean blow out limits are increased with air velocity. The highest blow out limit was found at the combustor inlet velocity of 65m/s.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.39 no.1
• /
• pp.45-51
• /
• 2015

In order to meet the enforced emission regulations and reduce fuel consumption, various new technologies are employed in engines. The problem of NOx emissions under a lean mixture condition should be solved, because a lean-burn direct-injection engine can realize stable lean combustion with a stratified mixture, which results in improvements in fuel economy and emissions. This study investigated the effects of intake and exhaust valve timing changes on the performance and emission characteristics of a lean-burn LPG direct-injection engine. Under a partial-load operating condition without throttling, an increase in the intake valve opening led to an increase in NOx emissions due to an increase in the amount of excess air. The fuel consumption deteriorated with an increase in the exhaust valve opening due to a decrease in the expansion work and an increase in the pumping loss.

• Journal of the Korean Institute of Gas
• /
• v.24 no.6
• /
• pp.28-33
• /
• 2020

In this study the possibility of hydrogen as a fuel in a small-sized two-stroke SI (Spark ignition) engine was investigated. For this purpose, experimental setup including an engine, a dynamometer, equipments for hydrogen and lubricant oil supply was prepared. And then preliminary experiments for the hydrogen-fueled engine combustion were conducted. In the case of hydrogen-fueled engines comparing to gasoline backfire occurs when the excess air ratio is lower than a specific value. This can cause engine power reduction and damage to the engine parts. The engine was controlled to operate at lean conditions to prevent backfire. Through the control of excess air ratio, the maximum engine brake power output of 3 kW was achieved in a 210 cc engine, while it was 6 kW in case of gasoline fuel.

• Journal of the Korean Institute of Gas
• /
• v.17 no.1
• /
• pp.7-12
• /
• 2013

As emission regulation for vehicle has been reinforced, many researches carried out for HCNG(hydrogen-natural gas blends) fuel to the conventional compressed natural gas (CNG) engine. However, abnormal combustion such as backfire, pre-ignition or knocking can be caused due to high combustion speed of hydrogen and it can result in over heating of engine or reduction of thermal efficiency and power output. In the present study, improvement of combustion performance was observed with HCNG fuel since it can extend a flammability limit. Knocking characteristics for CNG and HCNG fuel were investigated. Feasibility of HCNG fuel was evaluated by checking the knock margin according to excess air ratio. The operation of engine with HCNG was stable at minimum advance for best torque(MBT) spark timing and knock phenomena were not detected. However, it is necessary to prepare higher knock tendency since possibility of knock is higher with HCNG fuel.

• Journal of the korean Society of Automotive Engineers
• /
• v.6 no.3
• /
• pp.58-67
• /
• 1984

공간적 화염전파에 대한 실험적인 파악을 통하여 오토엔진에서의 연소과정과 진행을 위한 깊은 통찰을 할 수 있다. 그것을 통하면 매우 희박한 공기, 연료 혼합기의 경우 실린더에서 직접소염 과정을 확인할 수도 있고 hydrocarbon의 불완전 연소와 나타나는 qunching zone간의 관계를 조사할 수도 있다. 광전도 섬유기술(Lichtleit-fasertechnik)을 사용하여 새로 개발된 측정방법을 이용하여 단기통 오토엔진에서 화염면의 공간적인 전파과정과 매우 희박한 공기 연료 혼합기 에서의 quench zone의 출현을 조사하였다. 측정결과들은 공기연료 혼합기가 희박해 질수록 화 염전파 과정이 점점 느려지는 것을 보여준다. 아주 높은 공기 과잉율을 갖는 엔진 운전에서는 화염속도와 연소속도가 매우 급하게 감소한다. 그리하여 화염면은 팽창 단계에서 상대적으로 증가하는 피스톤속도 때문에 더이상 피스톤을 따를 수가 없으며 그로 인해 직접 피스톤상부에 소염대가 형성된다. 그에 의해 배기가스에서의 hydrocarbon 방출의 급격한 증가와 효율이 급격히 감소하는 엔진 운전과 관련이 지어진다.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.39 no.7
• /
• pp.609-615
• /
• 2015

In this study, the combustion and exhaust emission characteristics in a gasoline direct injection engine with variations of the bio-ethanol-gasoline blending ratio and the excess air factor were investigated. To investigate the effects of the excess air factor and the bio-ethanol blends with gasoline, combustion characteristics such as the in-cylinder combustion pressure, rate of heat release (ROHR), and the fuel consumption rate were analyzed. The reduction of exhaust emissions such as carbon monoxide (CO), unburned hydrocarbon (HC), and nitrogen oxides ($NO_x$) were compared with those of gasoline fuel with various excess air factors. The results showed that the peak combustion pressure and ROHR of bio-ethanol blends were slightly higher and were increased as bio-ethanol blending ratio is increased. Brake specific fuel consumption increased for a higher bio-ethanol blending ratio. The exhaust emissions decreased as the bio-ethanol blending ratio increased under all experimental conditions. The exhaust emissions of bio-ethanol fuels were lower than those of gasoline.

• Journal of Power System Engineering
• /
• v.6 no.2
• /
• pp.12-17
• /
• 2002

Recently, the world is faced with very serious problems related to the air pollution due to the exhaust emissions of the diesel engine. So, many of researchers have studied to reduce the exhaust emissions of diesel engine. This study was investigated for various exhaust emissions according to operating conditions in a turbocharged D.I. diesel engine. As a result of experiments in a test engine, the $CO_2\;and\;NO_x$ increased with increasing load, the $CO_2$ and CO decreased with increasing charge air pressure in manifold, the CO decreased with increasing cooling fresh water temperature, and the $NO_x$ decreased with worming cooling fresh water before engine start.