• Journal of the Korean Geographical Society
• /
• v.45 no.3
• /
• pp.342-359
• /
• 2010

The Bangudae Petroglyphs locate at Bangudong, Daegok-ri, Eonyang-eup, Ulju-gun, Ulsan and was designated as the No. 285 national treasure since 1995. After the construction of Sayeon-dam in 1965, there were many controversies of the rock weathering problems by the periodic immersion for approximately a few months. The isopleths of water content on the rock are drawn and the result shows relationships between the isopleths and distribution of joints or exfoliations. The distributions of water content rates in the Petroglyphs show the downward increasing pattern. This may suggest that the rates of water content are further influenced by the duration of immersion. Also, the upper part of the Petroglyphs with dense joints shows high rates of water content. If the water content rates in rocks increase, the water absorption rates increase too, because of the increasement of coefficient of permeability and porosity. The weathering damages of the Petroglyphs in which the pores are saturated by the periodic immersion are in the critical conditions.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.20 no.5
• /
• pp.66-74
• /
• 2016

The objective of this study is the investigation of the influence of carbonation on the penetration of chloride ions in reinforced concrete sections for different mix proportions and environmental conditions. A comprehensive numerical model based on the change of the pore structure and the chemical equilibrium was used for this combined action of carbonation and chloride ingress. The empirical formulae of some parameters in this model are estimated according to numerous experimental data. And, a set of data analysis is carried out to simplify the estimation of model variables to reduce the computational cost. A coupled simulation of the transports of carbon dioxide, chloride ions, heat and moisture is carried out. Then, the parametric analysis is given and the numerical results show that the effect of carbonation of the free chloride ingress is significant and depends on the binder types and concrete mix proportion.

• Horticultural Science & Technology
• /
• v.29 no.2
• /
• pp.95-101
• /
• 2011

The influence of physicochemical properties of root substrates on the growth of mother plants and occurrence of daughter plants in 'Seolhyang' strawberry propagation were investigated through plastic bag cultivation. Six different formulations of root substrates were coir dust + perlite (5:5, A), coir dust + perlite (6:4, B), coir dust + perlite (7:3, C), coir dust + coconut chip (7:3, D), coir dust + coconut chip (6:4, E), and peatmoss + vermiculite (5:5, v/v; F). The total porosities (TP) and container capacities (CC) of all root substrates were higher than 85% and 55%, respectively, indicating that all substrates were in the acceptable range. But the TP and CC of F substrate were 91.5% and 60%, respectively, which were the highest among the root substrates tested. In the soil chemical properties analyzed before planting and after harvesting of 'Seolhyang' strawberry mother plants, the root substrates of A, B, C, and F had higher electrical conductivity and $NO_3$-N concentrations than those of D and F. The root substrates of A, B, C, and F had heavier runner fresh and dry weights, longer runner lengths, and more daughter plant occurrence than those of D and F. The treatment F had higher tissue N content than any other treatments at 120 days after the transplanting of 'Seolhyang' strawberry and statistical differences were not observed among remained 5 substrates. The treatment of F also had the higher tissue contents of other nutrients except N analyzed at 120 days after transplanting. These results indicated that soil chemical properties rather than physical properties severely influenced the growth of runners and occurrence of daughter plants.

• Journal of the Korea Concrete Institute
• /
• v.16 no.3 s.81
• /
• pp.311-318
• /
• 2004

This study was performed to examine engineering properties for planting of porous concrete block containing rice straw ash. Tests for void ratio, compressive and flexural strength, pH by neutralization treatment time and curing method were peformed. As results, the void ratio tends to decrease with increasing rice straw ash content. But, the compressive and flexural strength tends to increase with Increasing rice straw ash content. When the neutralization was treated at the curing age 6 days, the greatest strength was showed. The pH of porous concrete without neutralization treatment in dry and water curing are shown in 10.32 ${\~}$ 10.55 and 9.41${\~}$9.59, respectively. The pH of porous concrete by neutralization treatment in dry and water curing were shown in 9.74${\~}$10.10 and 8.13${\~}$9.32, respectively. The porous concrete block size was 23 ${\times}$ 23 ${\times}$ 4 cm, and species of planting were Tall fescue, Lespedeza cyrtobotrya and Lespedeza cuneata. At the 6 months after seeding, germination ratio and grown-up length of Tall fescue, Lespedeza cyrtobotrya and Lespedeza cuneata were shown in 90, 60, $50\%$, and 40${\~}$50, 90${\~}$110, 65${\~}$75 cm, respectively. These porous concrete block containing rice straw ash could be used for planting.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.38 no.11
• /
• pp.1309-1315
• /
• 2014

The switch for a maglev vehicle should be designed such that the vehicle safely changes its track without touching the guiderail. In particular, a medium-to-low-speed EMS -type maglev train relies heavily on a U-type electromagnet where it generates levitation force and guidance force simultaneously. Therefore, it is necessary to evaluate the safety of the vehicle whenever it passes the switch, as it lacks active control of the guidance force. Furthermore, when the vehicle passes a segmented switch, which is a group of curves made up of connected lines with a small radius of curvature, it may come into mechanical contact with the guiderail owing to the excessive lateral displacement of the electromagnet. The goal of this study is to analyze the influence of a segmented switch on the safety of major design-related variables for achieving improved running safety. We propose a three-dimensional multibody dynamics model composed of two cars with one body. Using the proposed model, we perform a simulation of the lateral air gap, which is one of the measurements of the running safety of the vehicle when it passes the switch. The analyzed design variables are the length between short span girder, the articulation angle, the length between two centers of a fixed girder at its ends, and the number of girders. On the basis of the effects of the considered design variables, we establish an optimized design of a switch with improved safety.

• Journal of Korea Soil Environment Society
• /
• v.2 no.2
• /
• pp.25-33
• /
• 1997

To investigate the effects of cow manure compost(CMC) on soil and water environment as non-point source, the elution patterns of anions were determined in muti-layered soil columns which were consisted of one top and one bottom in combination. The top soil columns were uniformly packed with Ap horizon soils amended with air-dried CMC at different ratios(0, 2, 4, 6%, wt/wt), the bottom ones were packed with of B horizon soils of 15, 30, and 45cm in length. After saturating the each soil column, the leachate were collected from the bottom of the column while the double-ionized water was applied from the surface of the column by constant head method. From the hydraulic conductivity and anion eluted were measured in the leachate. Each saturated hydraulic conductivities for top and the bottom soils were 3$\times$$10^{-4}$sec and 1.6$\times$$10^{-3}$cm/sec. Most of water soluble chloride and sulfate, having non-specific adsorption characteristics onto the soil particles, were eluted within 1 PV, showing that there was no apparent retardation of anion movement with increasing CMC contents in the top soils. The effect of soil depths on anion movement were similar to the results of CMC contents. Sulfate of having both of non-specific and specific adsorption characteristics was also recovered in the effluent within 1 PV, while the elution curves were slightly skewed to the right showing that the CMC affected the movement of sulfate. Phosphate of specific adsorption characteristics was hardly eluted within 5 PV.

• The Journal of Engineering Geology
• /
• v.28 no.3
• /
• pp.455-463
• /
• 2018

This study developed a method to quantitatively measure the size of cracks in concrete using X-ray CT images. We prepared samples with a diameter of 50 mm and a length of 100 mm by coring cracked concrete block that was obtained by chipping. We used a micro-focus X-ray CT, then applied the 3DMA method (3 Dimensional Medial axis Analysis) to the 3D CT images to find effective parameters for damage assessment. Finally, we quantitatively assessed the damage based on sample locations, using the damage assessment parameter. Results clearly show that the area near the chipping surface was damaged to a depth of 3 cm. Furthermore, X-ray methods can be used to evaluate the porosity index, burn number, and medial axis, which are used to estimate the damage to the area near the chipping surface.

• The Journal of Korean Academy of Prosthodontics
• /
• v.53 no.3
• /
• pp.215-221
• /
• 2015

Treating patients with severely worn dentition often requires comprehensive prosthetic treatments. Oral rehabilitation and long-term stability could be achieved by analyzing the cause of the wear and changing vertical dimension. The temporary restoration procedure is executed and patient's adaptation is evaluated by long-term observation when treatment is accompanied with increasing vertical dimension. In this case, 54 year-old male presented with worn dentition and esthetic dissatisfaction. In oral manifestations, severely worn dentition with attrition and erosion is diagnosed. To evaluate change of vertical dimension, interocclusal rest space, facial appearance, pronunciation, clinical crown length, distance from incisor edge to labial vestibule are evaluated. Consequently, 2.5 mm increase of vertical dimension that based on articulator incisal pin is determined. After 8 weeks stabilization period with temporary prostheses, definitive prostheses are fabricated. After 6 months follow up period, satisfactory outcomes were achieved both in functional and esthetic aspects through this procedure.

• Horticultural Science & Technology
• /
• v.18 no.6
• /
• pp.819-822
• /
• 2000

This study was conducted to determine the optimum rooting media composition for the production of high-quality rose cuttings. The percentage of rooting was highest in peatmoss (P) and coarse vermiculite (CV) mixture (1:2, v/v). In 'Little Mable' and 'Suplesse', the rate was above 95%, and 'Red Velvet', 'Noblesse', 'Rote Rose', and 'Sweetness' showed 100% rooting rate. 'Rote Rose' showed lowest rooting rate, but in the composition, the rate was 100%. In the composition, root growth was accelerated. Root number, root weight, and root diameter increased in P:CV (1:2) mixture. However, root length increased in peatmoss and perlite mixture (1:2). This results might be caused by the water holding capacity and porosity of the rooting media composition.

• Journal of Sensor Science and Technology
• /
• v.11 no.3
• /
• pp.171-182
• /
• 2002

The differential electromagnetic transducer for IME(implantable middle ear) system, which have two small permanent magnets glued with the same pole facing each other in the coil, has high vibration efficiency and does not influenced by external magnetic field. In this paper, using finite element method, highly efficient structure of the transducer was proposed and vibration force of the transducer was calculated by electromagnetic theory. And the necessary vibration force of transducer to transmit the sound signal to inner ear when the transducer is attached at stapes was calculated and the design parameters of the transducer were investigated. Using the parameters, the differential electromagnetic transducer was manufactured in small size to implant in confined human middle ear. And it was examined by unloaded and loaded vibration experiment using temporal bone sampled from cadaver.