• Journal of Environmental Impact Assessment
• /
• v.32 no.5
• /
• pp.279-290
• /
• 2023

Recently, as wind farms using wind power as new and renewable energy have been installed nationwide, noise problems have emerged. The environmental impact assessment and post-environmental impact assessment also require the measurement of background noise and low-frequency noise for wind farms, especially by applying the living noise measurement method according to the low-frequency noise management guidelines issued by the Ministry of Environment in 2018. Due to the nature of wind power generators that generate loud noise in high winds, noise measurement should be made at high winds, but when wind speed increases, wind noise increases and living noise and low-frequency noise are not properly evaluated. Therefore, the type of noise generated by wind power generators was confirmed, and matters to be considered when measuring wind noise such as wind noise were confirmed.

• Venture DIGEST
• /
• s.35
• /
• pp.18-19
• /
• 2003

시간이 한번 스치고 지나간 것들 속에서 한국인의 심성이라는 섬세한 정신의 직물을 짜온 사진작가가 한 명 있다. 김대벽씨가 바로 그다. 그는 사력(寫歷)만 얼추 따져봐도 불혹의 세월을 훌쩍 넘게 국토를 떠돌며 고풍스런 역사의 흔적들을 기록하고 증언해왔다.

• The KSFM Journal of Fluid Machinery
• /
• v.15 no.2
• /
• pp.36-40
• /
• 2012

Pitch control of wind turbine is activated above rated wind speed for the purpose of rated power regulation. When we design pitch controller, its gain-scheduling is essential due to nonlinear characteristics of aerodynamic torque. In this study, 2-mass model including a vibration mode of drive-train for a 2 MW wind turbine is considered and pitch control with gain-scheduling using a linearization analysis of the nonlinear aerodynamic torque is applied. Some simulation results for the pitch gain-scheduling under step wind speed are presented and investigated. It is shown that gain-scheduling in pitch control is important especially in the region of high wind speeds when there exists a vibration mode of drive-train.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.10 no.4
• /
• pp.706-711
• /
• 2006

In order to retrieve ocean wind from SAR() image, and to estimate and validate between SAR-derived wind and in-situ wind, with RADAR SAR ocean images and real time marine meteorological data. It was used images with more than 10km to analyze the band of wind in SAR image by FFT(First Fourier Transformation) method and was used CMOD5 as wind retrieval model to retrieve ocean wind. In this study, generally it showed good results as RMS presented 0.8m/s for speed and 8 degree for direction, and especially when wind was hish speed, it presented very good results.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.18 no.12
• /
• pp.88-92
• /
• 2017

Owing to the depletion of fossil energy, wind power is attracting attention as a promising environmentally friendly alternative energy source, because it is abundant, renewable, and non-polluting. Wind turbines are divided into horizontal axis wind turbines (HAWTs) and vertical axis wind turbines (VAWTs) according to the direction of the rotating shaft. VAWTs have a low power generation efficiency, but are not affected by the wind direction and, thus, no yaw system is required and their structure is simple. Small VAWTs are attracting much attention because they can generate power even at low wind speeds. In this study, the output voltages and output currents of small VAWTs with gyromill type, hinge type and double door type blades capable of generating power even at low wind speeds were analyzed at variable wind speeds in the range of 1~11 m/s. At the maximum wind speed of 11m/s, the application of the double door type blades achieved 67% and 9% higher wind turbine output voltages than that of the gyromill type and hinge type blades, respectively. As regards the wind turbine output currents, the application of the double door type blades gave rise to 93% and 5% higher results than that of the gyromill type and hinge type blades, respectively. Through this study, the excellent output characteristics and commercialization potential of the double door type blades, which can generate power both at low and high wind speeds, were confirmed.

• Journal of Bio-Environment Control
• /
• v.28 no.2
• /
• pp.150-157
• /
• 2019

This study was carried out to investigate at the micrometeorology change of the orchard according to the net installation. Two weather stations were installed at the inside of the anti-insect nets(2 mm, 4 mm), one was installed at the outside(control). They were observed the temperature, humidity, wind speed and solar radiation from April to September 2018. Daily mean temperature at the experimental group was higher than control group by $0.2^{\circ}C$. Daily mean humidity at the experimental group was higher than control group by 3.5 to 4.7%. Daily mean the solar radiation at the experimental group(2 mm) was lower than control group by 50%. The wind speed was decreased from 12% to 50% of the external wind speed at 4 mm, and from 25% to 59% at 2 mm.

• Journal of Korea Water Resources Association
• /
• v.53 no.12
• /
• pp.1071-1079
• /
• 2020

For integrated water management, it is essential to secure basic data such as the amount of agricultural water intake. The river water intake through the intake weir is carried out through the agricultural irrigation canal, and a method for measuring the quantity of water intake is required to suit the characteristics of the measuring points. In this study, the accuracy of the calculated flow data was determined by applying a microwave water surface current meter. The microwave water surface current meter is a method of calculating surface velocity using doppler effect, which is mainly used in high-velocities situations such as flood. Surface velocity is difficult to represent the average velocity of the entire section at low dicharges or high wind speeds, it is considered to be low in continuous utilization throughout the year, and it is necessary to verify whether the measurement using an microwave water surface curren meter is appropriate in agricultural irrigation canal. The data measured with an microwave water surface curren meter were compared with the actual flow data to calculate the intake data in agricultural irrigation canal. In agricultural irrigation canal, the low-level discharge calculated using an microwave water surface current meter at a minimum velocity of about 0.3 m/s and a minimum discharge of about 1.0 m3/s or higher was found to have a high tendency and accuracy compared to the standard discharge, especially when the high discharge was high. Although effective results can be obtained in terms of quantity at low discharge, it is deemed that subsequent studies are needed to calculate the average discharge of the cross section at low discharge, given that the trend of data is unstable. Through this study, it is suggested that it is appropriate to calculate the amount of water intake through the microwave water surface current meter in artificial waterways with a certain discharge or higher, so it is expected to be widely distributed as a method for measuring river water intake.