• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.6A
• /
• pp.465-473
• /
• 2005

In this paper, the reduction scheme of Interchannel Interference(ICI) caused by the phase noise in Orthogonal Frequency Division Multiplexing(OFDM) systems for archiving high data rates is proposed. The performance of conventional common phase error(CPE) compensation method is degraded by the phase noise with wide 3dB bandwidth in OFDM systems width a higher-order constellation. After estimating dominant ICI coefficients using pilot subcarriers and data subcarriers adjacent to pilot subcarriers, the proposed scheme compensates OFDM signals distorted by the phase noise using estimated coefficients in the time or frequency domain. Also, in order to determine the length of dominant ICI coefficients effectively, the estimation method of the 3dB bandwidth of the phase noise is proposed. The proposed phase noise reduction method is shown to improve the Bit Error Ratio(BER) performance compared with the conventional CPE compensation.

• Fire Science and Engineering
• /
• v.24 no.6
• /
• pp.170-175
• /
• 2010

The effect of carbon dioxide addition on soot formation was investigated in jet diffusion flames in coflow. Flame temperature were measured with R-type thermocouple and the boundary temperature between blue and yellow flame was confirmed. Light-extinction method was introduced for the relative soot density (1-I/$I_0$) in the in-flame region. He-Ne laser with wave length at 632.8 nm was used for the light source, and the signal attenuated by absorption and scattering was detected directly. Oxidizer velocity effect on soot formation was studied to know that the thermal influence for soot formation. The results showed that the temperature of both blue and yellow flame were decreased according to the dilution of carbon dioxide but boundary temperature was nearly constant. The relative soot density was lower when carbon dioxide was added in oxidizer stream and oxidizer velocity increased. These were caused by the reduction of flame temperature and shorter residence time for soot growth. Also carbon dioxide addition enhanced the instability of jet flames like flickering, so the flame length was a little longer than pure ethylene/air flame.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.30 no.4
• /
• pp.295-301
• /
• 2010

Flow accelerated corrosion(FAC) of carbon steel pipes in nuclear power plants has been known as one of the major degradation mechanisms. It could have bad influence on the plant reliability and safety. Also detection of FAC is a significant cost to the nuclear power plant because of the need to remove and replace insulation. Recently, the interest of the guided wave testing(GWT) has grown because it allows long range inspection without removing insulation of the pipe except at the probe position. If GWT can be applied to detection of FAC damages, it will can significantly reduce the cost for the inspection of the pipes. The objective of this study was to determine the capability of GWT to identify location of FAC damages. In this paper, three kinds of techniques were used to measure the amplitude ratio between the first and the second welds at the elbow area of mock-ups that contain real FAC damages. As a result, optimal inspection technique and minimum detectability to detect FAC damages drew a conclusion.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.15 no.3
• /
• pp.576-582
• /
• 2011

In this paper, we proposed the improved Advanced Detail Enhancement algorithm that improve the blurring by the lossy compression with CODEC and reduce the ringing artifacts in restoration. The conventional algorithm needs much amount of the process by the use of RGB color space. To improve this, we only used the luminance value in YCbCr color space. We verified that the performance of the improved algorithm with Y color value, the luminance value, is equal to the conventional algorithm with RGB color value and that the operation time of the improved is shorter about 24% than the conventional through the measurement of the operation time with Kodak standard images.

• Journal of KIISE:Information Networking
• /
• v.37 no.5
• /
• pp.403-408
• /
• 2010

The sensor nodes can be installed in the environment in which the temperature change is considerable, such as desert, urban, and data center. Particularly, because the output power becomes less than the targeted power if a temperature is increasing, link quality is degraded and packet losses are occurred. In order to compensate the temperature changes, existing schemes detect the change of the link quality between nodes and control transmission power through a series of feedback process. However, these approaches can cause heavy overhead by additional control packets. In this paper, we propose the T2PC(Temperature-aware Transmission Power Control) to keep up the link quality despite temperature variation. At each node, T2PC compensates the attenuated link quality by controlling the transmission power based on the local temperature measurement. In addition, the packet reception ratio can be improved with less control packets than ones required in existing transmission power control methods based on the feedback control.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2016.10a
• /
• pp.66-69
• /
• 2016

In this paper, we suggests a Ka-band LNB considering next-generation UHD satellite TVRO. Since Ka-band has grater attenuation than Ku-band in atmosphere, we designed the low-noise down-converter to improve receiving sensitivity and to extend a dynamic range of receiver. It aims to compensate a quality of ultra high definition transmission signal for rainfall. The low-noise block diagram consists of a three-staged amplifier (LNA), band-pass filter for deleting image (BPF), mixer and IF when considering nonlinear characteristics in the receiver RF front end module. Also, we showed a LNB through optimization processes affecting dynamic range directly in receiver FEM. Asa resuly of experiment, the gain of low-noise down-converter show between 58.5dB and 60.7dB, the noise figure has a high characteristic as 1.38dB. Finally, the phase noise of local oscillator is -63.10dBc at 100MHz offset frequency.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.9C
• /
• pp.955-963
• /
• 2005

In this paper, we consider the noncoherent code acquisition problem using sequential schemes. We show that the outputs of the noncoherent receiver approximately have a central chi-square distribution under the null hypothesis through simulations. Based on this observation, simplified acquisition schemes are obtained using the approximations of the Bessel function. The performance of the simplified and original schemes are compared in additive white Gaussian noise and slowly varying fading channels. Numerical results show that the simplified schemes have essentially the same performance as the original schemes.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.5C
• /
• pp.601-610
• /
• 2004

In this paper, the performance of an adaptive array antenna using Constant Modulus Algorithm (CMA) based on the signal structure for the IMT-2000 3GPP specification reverse link of an asynchronous direct sequence code division multiple access (DS-CDMA) system are evaluated. In addition, the performance is compared with the array antenna using Least Mean Square (LMS) based on the training signal. The simulation parameters such as the number of multipath, mu10pa1h intensity profiles between path, spreading gain and multiuser etc., are considered in the Monte Carlo simulation. Simulation results demonstrate an adaptive array antenna using CMA may give more capacity gain than the amy antenna using LMS in the case of multipath fading channel.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.11C
• /
• pp.851-859
• /
• 2008

This paper investigates the effect a guard period (GP) in the form of a cyclic prefix for asynchronous multicarrier-code division multiple access (MC-CDMA) systems. At first, we analyze the performance of asynchronous MC-CDMA systems with a GP, which results in closed-form bit error rate (BER) performance. Furthermore, it confirms that the frequency diversity of MC-CDMA systems is identical to the path diversity. The analytical approach proposed here is extended to the case without a GP. The derived analytical results show that a GP is required for MC-CDMA systems in order to mitigate not only the effect of intersymbol interference (ISI) and intercarrier interference (ICI) but also the desired signal power degradation. In addition, the accuracy of the proposed analysis is verified by simulations.

• Journal of the Society of Naval Architects of Korea
• /
• v.29 no.2
• /
• pp.60-65
• /
• 1992

The roll response of a ship to random beam seas is investigated in terms of the threshold crossing process. The non-white excitation process is modeled as an equivalent white-noise one based on the assumption that the upcrossing properties of the response can be approximately replaced by the excitation with a white noise process with a suitable intensity. Then the non-linear damping is reinstated. The reinstated equation of motion with the equivalent white-noise intensity is solved using the equivalent non-linear method to get the desired probability density function. The proposed scheme is tested extensively with varing coefficients.