• Applied Biological Chemistry
• /
• v.41 no.6
• /
• pp.431-436
• /
• 1998

The optimum ohmic heating condition of apple juice was investigated with model solution. The temperature rise of model solution was found to be $7.8,\;21.0,\;47.4^{\circ}C/min$ when the distances between electrodes were 29, 22, and 17mm, respectively. The heating rate increased proportionally with the numbers of electrode pairs, 1 to 3 and highly dependent on applied voltage. The heating rate was not affected by the frequencies ranged from 60 Hz to 60 KHz and the wave form of applied alternating electric current. The apple juices prepared by ohmic heating sterilization revealed similar physicochemical properties to that by commercial sterilization.

• Korean Journal of Food Science and Technology
• /
• v.37 no.3
• /
• pp.438-442
• /
• 2005

Granule swelling is essential phenomenon of starch gelatinization in excess water, and characteristic of heated starch dispersion depends largely on size and distribution of swelled starch granule. Although swelling characteristic of starch granules depends on type of starch, heating rate, and moisture content, influence of heating rate on swelling phenomenon of starch granule has not been fully discussed, because constant heating rate of starch dispersion cannot be obtained by conventional heating method. Ohmic heating, electric-resistant heat generation method, applies alternative current to food materials, through which heating rate can be easily controlled precisely and conveniently at wide range of constant heating rates. Starch dispersion heated at low heating rates below $7.5^{\circ}C/min$ showed Newtonian fluid behavior, whereas showed pseudoplastic behavior at heating rates above $16.4^{\circ}C/min$. Apparent viscosity of starch dispersion increased linearly with increasing heating rate, and yield stress was dramatically increased at heating rates above $16.4^{\circ}C/min$. Average diameter of corn starch granules during ohmic heating was dramatically increased from $30.97\;to\;37.88\;{\mu}m$ by increasing heating rate from $0.6\;to\;16.4^{\circ}C/min$ (raw corn starch: $13.7\;{\mu}m$). Hardness of starch gel prepared with 15% corn starch dispersion after heating to $90^{\circ}C$ at different heating rates decreased gradually with increasing heating rate, then showed nearly constant value from $9.4\;to\;23.2^{\circ}C/min$. Hardness increased with increase of heating rate higher than $23.2^{\circ}C/min$.

• Journal of Energy Engineering
• /
• v.9 no.4
• /
• pp.279-287
• /
• 2000

코크스 오븐에서 석탄 건류과정 중에 발생하는 석탄 중심의 가스압 특성에 대한 장입탄 수분, 가열속도 및 일반탄 배합비의 영향을 조사하기 위해 이동벽이 있는 pilot 규모의 코크스 오븐(0.45mW$\times$0.1mH$\times$1.2mL)에서 석탄 건류 실험을 수행하였다. 석탄 중심에서의 가열속도가 상업용 코크스 오븐과 비슷한 건류조건에서 장입탄 수분을 감소시켰을 때, 수분 증발 이후 가열속도는 비슷하였으며, 건류 초기 수증기압은 크게 증가하였고, 석탄 중심에서의 가스압은 습탄에 비해 대략 2.5배 증가하였다. 석탄 중심에서의 가열속도가 상업용 코크스 오븐보다 훨씬 빠른 건류조건에서 장입탄 수분을 감소시켰을 때, 수분 증발 이후 가열속도는 크게 감소하였고, 건류 초기 수증기압은 크게 증가하였으며, 석탄중심에서의 가스압은 습탄에 비해 대략 2배 증가하였다. 석탄 가열속도가 상업용 오븐보다 빠른 건류조건에서 장입탄에 일반탄을 첨가하여 일반탄 배합비를 증가시켰을 때 배합탄 중심에서의 가스압은 현저히 감소하였다.

• Applied Chemistry for Engineering
• /
• v.18 no.4
• /
• pp.344-349
• /
• 2007

NaY zeolites synthesized by microwave heating were compared with those obtained by conventional heating. When the same temperature increasing rates were adopted in both heating methods, the microwave heating shortened the induction period and enhanced the rate of crystallization of NaY zeolites compared with the conventional heating. Irrespective of microwave radiation, the fast temperature increasing rate also shortened the induction time and enhanced the crystallization of NaY zeolites. The crystal sizes of NaY zeolites were large under the fast temperature raise of the reaction mixture and became larger by microwave radiation. At the same time, the fast temperature increasing rate has reduced the energy consumption due to the fast completion of reaction during the synthesis of NaY zeolite. The energy consumption in the conventional ethylene glycol bath was lower than that in the microwave oven with the same temperature increasing rate in this study, which means that the energy efficiency is not always high in microwave heating. If the temperature increasing rate is carefully controlled, however, NaY zeolite can be produced with high energy efficiency in the microwave oven.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.22 no.2
• /
• pp.181-185
• /
• 1993

The effects of concentrations (6~9%), heating temperatures (80, 85, 90 and 95$^{\circ}C$) and heating methods (continuous, method A and instantaneous, method B) on the flow properties of cowpea flour (air-dried sediment) at 6$0^{\circ}C$ were studied. The gelatinized cowpea flour dispersions by method B had higher values of yield stress and consistency index but lower value of flow behavior index compared to those values of method A. The log values of consistency index were positively correlated with the concentration and heating temperature for both methods. The rate of increase in the consistency index value by method B at the same concentration was greater in all heating temperatures than that by method A.

• Korean Journal of Food Science and Technology
• /
• v.23 no.3
• /
• pp.355-359
• /
• 1991

Effects of temperature and pH on thermal degradation of monosodium glutamate(MSG) were investigated during heating of 2% MSG solution at $100{\sim}200^{\circ}C\;and\;pH\;4{\sim}9$. The results showed that the degradation of MSG was very significantly affected by heating temperature and pH. Three hours of heating at $pH\;4\;and\;120^{\circ}C$ resulted appr. 73% MSG degradation while 3 hours at $100^{\circ}C$ decreased only 12%. The comparison study of initial rate of MSG degradation and degradation rate constants showed the highest degradation rate and rate constant and low values in the range of $pH\;6{\sim}8{\sim}$. The values of activation energy calculated from linear relationship of rate constants and 1/T were 18.3 and 9.2 kcal/mole for pH 4 and 5, respectively.

• Korean Journal of Food Science and Technology
• /
• v.26 no.6
• /
• pp.791-798
• /
• 1994

Ohmic heating is a food processing operation in which heat is internally generated within foods by the passage of alternating electric current. The process enables highly viscous paste foods such as Kochujang, and fermented soybean paste to be heated very fast. In order to develope the novel pasteurization process of paste foods, static Ohmic heating system was built, and heating characteristic during Ohmic heating under various conditions were studied. Electric conductivities of Kochujang and fermented soybean paste at room temperature were 1.865 S/m and 2.510 S/m, respectively and increased linearly with increasing temperature. Specific heating rate was highly dependent on the frequency. The highest heating rate was achieved at 5 KHz for Kochujang and 20 KHz for fermented soybean paste. Uniform heating throughout the sample was achieved during Ohmic heating with low frequency electrical currents, however above 5 KHz frequency, surface temperature was several degrees higher than the bulk.

• Journal of the Korea Concrete Institute
• /
• v.24 no.5
• /
• pp.605-612
• /
• 2012

Spalling of concrete occurs due to vapor pressure ignited explosion, temperature difference across a section, and combination of these factors. Factors affecting spalling can be classified into internal and external factors such as material property and environmental condition, respectively, have to be considered to precisely understand spalling behavior. An external environmental factor such as differences in heating rate cause internal humidity cohesion and different vapor pressure behavior. Therefore, spalling property, vapor pressure and thermal strain property were measured from concrete with compressive strengths of 30 MPa, 50 MPa, 70 MPa, 90 MPa, and 110 MPa, applied with ISO-834 standard heating curve of $1^{\circ}C/min$ heating rate. The experimental results showed that spalling occurred when rapid heating condition was applied. Also, when concrete strength was higher, the more cross section loss from spalling occurred. Also, spalling property is influenced by first pressure cancellation effect of thermal expansion caused by vapor pressure and heating rates.

• Proceedings of the KIPE Conference
• /
• 2018.07a
• /
• pp.3-5
• /
• 2018

유도 가열 (Induction Heating; IH) 기기는 빠른 가열 속도, 안전성, 청결성 등의 장점으로 산업계와 가정에서 널리 사용되고 있다. 하지만 기존 IH 기기는 낮은 저항을 갖는 비자성체 용기를 가열할 때 1차측 스위치에 높은 전류가 유도됨으로써 스위칭 손실과 전도 손실이 증가하고 스위치 정격 전류량을 초과하는 문제가 발생하였다. 본 논문에서는 용기 재질에 따른 임피던스 특성을 분석하여 비자성체 용기를 가열하기 위한 적절한 유도 가열용 직렬 공진형 컨버터의 새로운 스위칭 변조방식을 제안한다. 2 kW의 정격 전력을 가지는 유도 가열용 컨버터의 시작품을 사용하여 설계 방법론과 스위칭 변조 방식의 타당성과 성능을 검증하고자 한다.

• Applied Chemistry for Engineering
• /
• v.17 no.3
• /
• pp.296-302
• /
• 2006

The kinetics of the thermal-oxidative decomposition of waste polyurethane (PU) according to oxygen concentration has been studied using a non-isothermal thermogravimetric technique at several heating rates from 10 to $50^{\circ}C/min$. A kinetic model accounting for the effects of the oxygen concentration by the differential and integral method based on Arrhenius equation was proposed to describe the thermal-oxidative decomposition of waste PU. To obtain the information on the kinetic parameters such as activation energy, reaction order, and pre-exponential factor, the thermogravimetric analysis curves and its derivatives have been analyzed using the kinetic analysis method proposed in this work. From this work, it was found that reaction orders for oxygen concentration had a negative sign, and activation energy decreased as the oxygen concentration increased. It was also found that the kinetic parameters obtained from the integral method using the single heating rate experiments varied with heating rates. Therefore, it is thought that the differential method using the multiple heating rate experiments more effectively represents the thermal-oxidative decomposition of waste polyurethane.