• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.8A
• /
• pp.1238-1246
• /
• 2000

In a multi-channel network based on wavelength division multiplexing (WDM), an efficient protocol is needed for transmitter and receiver to be tuned to same wavelength during message transmission time. This paper proposes a message scheduling protocol that can efficiently support variable-sized messages, where tunable transceiver has nonzero tuning time. In this protocol, once a node reserves one data channel, it can persistently use the reserved channel till message transmission is finished. Therefore, overhead due to tuning time of the tunable transceiver can be reduced. Moreover, the protocol does not require any global information. Therefore, it can operate independently of the change of the number of nodes, and any new node can join the network at anytime without requiring network initialization. With this protocol, one can avoid data channel and destination conflicts. The protocol is analyzed with a finite population model and the throughput-delay characteristics are investigated as performance measures.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.5A
• /
• pp.359-369
• /
• 2005

For large capacity optical CDMA networks, we propose a shared-type encoder/decoders based on an tunable wavelength converter(TWC) and an arrayed waveguide grating (AWG) router. The proposed encoder/decoder treats codewords of wavelength/time 2-D code simultaneously using the dynamic code allocation property of the TWC and the cyclic property of the AWG router, and multiple subscribers can share the encoder/decoder in networks. Feasibility of the structure of the proposed encoder/decoder for dynamic code allocation is tested through simulations using two wavelength/time 2-D codes, which are the generalized multi-wavelength prime code(GMWPC) and the generalized multi-wavelength Reed-Solomon code(GMWRSC). Test results show that the proposed encoder/decoder can increase the channel efficiency not only by increasing the number of simultaneous users without any multiple-access interference but by using a relatively short length CDMA codes.

• Korean Journal of Optics and Photonics
• /
• v.13 no.4
• /
• pp.289-294
• /
• 2002

We propose optical true time-delays (TTDs) for phased-array antennas (PAAs) composed of 2${\times}$2 MEMS switches and fiber delay lines, and implement a TTD which shows a maximum scan angle of $120^{o}$ with $30^{o}$ resolution. Since this structure uses only one fixed wavelength laser diode, it provides several advantages such as easy control, high speed operation, and low cost compared with those of the optical TTDs using tunable laser sources. We design a four element linear PAA using the proposed TTDs at 10 ㎓. Simulation results show that the maximum gain is 11.6 dB at the radiation angle $0^{o}$, 11.2 dB at $\pm$$30^{o}$, and 10.6 dB at $\pm$$60^{o}$.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.8
• /
• pp.688-693
• /
• 2009

In this paper, a half wave-length microstrip antenna was proposed to be able to continuously tune the resonant frequency in the stated area of UHF ISM band. By loading varactor diodes at both edges of the half wavelength antenna, where the electric field is the strongest, and varying the voltage in order to tune the electrical resonance length continuously, it is possible to automatically recover the resonant frequency and input impedance shifted by surrounding environment. When the microstrip antenna(center resonant frequency: 425 MHB) was tested, by adjusting the each voltages of varactor diodes from DC 0.6 to BC 3.0 volts, the resonant frequency under 20 dB return loss was varied 385 to 465 MHz. The peak gain was -0.2 dBd and return loss -10 dB bandwidth was 3.3 MHz(0.8 %).

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.32 no.7
• /
• pp.37-42
• /
• 2004

In order to monitor the impact locations in smart structures, multipoint ultrasonic sensors are to be employed. In this study, a multiplexing demodulator with wide dynamic range was proposed to detect the impact locations using FBG sensors, and a stabilization controlling system was also developed for the maintenance of maximum sensitivity of sensors. Two FBG sensors were attached on the bottom side of the aluminum beam specimen and low velocity impact tests were performed to detect the one-dimensional impact locations. As a result, multiplexed in-line FBG sensors could detect the moment of impact precisely, and found the impact locations with the average location error below 0.58mm.

• Korean Journal of Optics and Photonics
• /
• v.10 no.2
• /
• pp.162-168
• /
• 1999

A new design of four-pass dye laser amplifier affording a narrow-bandwidth pulsed output is demonstrated to suppress the amplified spontaneous emission(ASE) carried by the amplifier output and reduce the possibility of parasitic oscillation in the amplifier. By the direct pulsed amplification of a cw 100 mW dye laser under a Q-switched doubled Nd:YAG laser pumping with energy of 5.6 mJ/pulse, high-peak-power pulsed output with 1.5-mJ energy in 130-MHz bandwidth is obtained corresponding to a power gain greater than $2{\times}10^6$ and an energy efficiency of 27%. The ASE ratio in the four-pass amplifier output is dramatically reduced by using a diffraction grating in the amplifier. Compared with the results obtained from the normal operation of the amplifier with no frequency-selective device, the ASE ratio is reduced by a factor in excess of 10 to remain under 1.5% of the amplifier output whereas the total output energy is slightly increased by ~4%.

• Korean Journal of Optics and Photonics
• /
• v.17 no.3
• /
• pp.216-222
• /
• 2006

We propose the use of the Gaussian-curve fitting algorithm for the improvement of measurement accuracy in wavelengthscanned Fabry-Perot filter based demodulation systems. The peak locations of FBG sensors were calculated from the fitted curves rather than from distorted PD profiles, resulting in much better measurement accuracy than that of the highest-peak search algorithm. Also, the algorithm was proved to minimize measurement uncertainty of spectrally-distorted grating sensors. From our experimental results, a temperature resolution as small as ${\sim}0.3^{\circ}C$ was readily achieved by use of the Gaussian-curve fitting algorithm whereas the highest-peak search algorithm gave a temperature resolution larger than ${\sim}4^{\circ}C$.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.6A
• /
• pp.802-812
• /
• 2000

Multihop lightwave networks are the optical-fiber based local communication systems that employ WDM(Wavelength Division Multiplexing) technology to fully use the enormous fiber bandwidth without requiring any tunable tranceives. In this paper, we introduce a novel ShuffleNet topology, asymmetric bilayered ShuffleNet(ABS) topology as a multihop WDM network technique. For 1Gb/s transmission system, we compared ABS topology with previously reported ones in terms of common network parameters such as average number of hops, throughput, time delay, and network power function. Through the analysis, the performance of ABS topology was proven to be superior to the existing ones. To decrease the amount of hardware required for implementing ABS system, we also proposed a new WDM channel sharing scheme. For (2, 3) ShuffleNet topology system, the number of wavelengths needed in the system can be reduced dramatically from 96 to 4 by using new scheme.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.32 no.5
• /
• pp.50-57
• /
• 2004

For the application of structural health monitoring such as AE detection, a stabilized FBG sensor system with wide dynamic range was proposed. A tunable Fabry-Perot filter with narrow free spectral range(FSR) was used to simplify the multiplexing demodulator for FBG vibration sensors. Stabilization controlling system was also developed for the maintenance of maximum sensitivity of the sensors. In order to verify the performance of the proposed FBG vibration sensor system, we measured sensitivity, and the system showed the average sensitivity of 256 $n{\in}_{mas}/{\sqrt{Hz}}$. Finally, multi-points vibration tests using in-line FBG sensors were conducted to validate the multiplexing performance of the FBG system.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.14 no.5
• /
• pp.81-86
• /
• 2014

A smart phone subscriber needs wide bandwidth services for more fast data communication on the internet. The conventional MIMO system is now developing to resolve these problems with limited device space for antenna and frequency band environment reserved. One of way to make it practically is to add the number of antennas theoretically. But it is difficult to increase the antenna element as a limited space on the system. Therefore an active beam forming scheme is known as a way of constructing a Compact MIMO system for that. In this paper, the fast switching control block was suggested to adjust a reactance of the antenna element and verified experimentally the effects by switching signal on an orthogonal beam forming through a spatial domain.