• Journal of Mushroom
• /
• v.19 no.4
• /
• pp.329-335
• /
• 2021

This experiment was conducted to investigate the changes in freshness parameters and determine the optimal UV-B irradiation conditions for each storage period for Heuktari, an oyster mushroom cultivar, grown under LED lightNo significant changes were observed in the CO₂ and O₂ content until day 12 of storage; however, after day 15, the CO₂/O₂ ratios were higher in the UV-treated groups than in the untreated groups. No color difference was observed between the UV-treated and untreated groups. In all UV-treated groups, hardness decreased over time; however, the group irradiated for 15 minutes showed higher hardness values than those of the untreated group. The UV-irradiated group showed higher ergosterol content than did the untreated group, and scanning electron microscopy revealed that mushroom cell wall destruction increased with increased UV treatment time. Overall, these findings confirmed that UV-B irradiation increased the ergosterol content of Heuktari but decreased its freshness and negatively impacted other storage characteristics.

• Bulletin of the Korean Chemical Society
• /
• v.33 no.2
• /
• pp.597-600
• /
• 2012

Polyynes were formed by laser ablation of a graphite target in deionized water ($H_2O$ and $D_2O$) and various organic solvents such as acetonitrile, n-hexane, and c-hexane and were identified by analyzing ultraviolet (UV) absorption and Raman spectra. We assigned the major UV absorption peaks that coincided with the electronic transitions corresponding to linear polyyne chains. The UV absorption peak intensities of a polyyne solution decreased as the holding temperature of the solution increased. Also, the absorption spectra of polyynes obtained by laser ablation of a graphite target at different volume fractions of $H_2O$ and $D_2O$ were examined.

• Journal of Environmental Science International
• /
• v.13 no.1
• /
• pp.37-40
• /
• 2004

In this study, the decomposition of gas-phase TCE, Benzene and Toluene, in air streams by direct UV Photolysis and UV/TiO$_2$ process was studied. For direct UV Photolysis, by regressing with computer calculation to the experimental results the value of reaction rate constant k of TCE, Toluene and Benzene in this work were determined to be 0.00392s$\^$-l/, 0.00230s$\^$-1/ and 0.00126s$\^$-1/, respectively. And the adsorption constant K of TCE, Toluene and Benzene in this work were determined to be 0.0519 mol$\^$-l/ ,0.0313mo1$\^$-1/ and 0.0084mo1$\^$-1/, respectively. For UV/TiO$_2$ system by regressing with computer calculation to the experimental results the value of reaction rate constant k of TCE, Toluene, and Benzene in this work were determined to be 5.74g/$\ell$$.$min, 3.85g/$\ell$$.$min, and 1.18g/$\ell$$.$min, respectively. And the catalyst adsorption constant K of TCE, Toluene, and Benzene in this work were determined to be 0.0005㎥/mg, 0.0043㎥/mg and 0.0048㎥/mg, respectively.

• Applied Chemistry for Engineering
• /
• v.23 no.2
• /
• pp.148-152
• /
• 2012

Anatase and anatase/rutile $TiO_2$ samples were prepared at $HNO_3$/TTIP molar ratio of 0.1, 0.5, 1.0, and 1.5 to study the effects of the physical properties of $TiO_2$ on photocatalytic decomposition of methylene blue. The physical properties of the samples were measured with XRD, SEM, TEM, BET, FT-IR, and UV-vis spectroscopy. Anatase phase was observed at $HNO_3$/TTIP of 0.1 and anatase/rutile phases were observed at $HNO_3$/TTIP of 0.5~1.5. Rutile crystal phase, mesopore size between $TiO_2$ nanoparticles, and surface OH group on $TiO_2$ sample were gradually increased with increasing the molar ratio of $HNO_3$/TTIP and the residual methylene blue concentration before UV irradiation decreased from 78.0 to 53.3%. After UV irradiation, the residual methylene blue concentrations of the samples prepared at $HNO_3$/TTIP of 0.1, 0.5, 1.0, and 1.5 were 20, 14, 11, and 23%, respectively, and the sample prepared at $HNO_3$/TTIP of 1.0 showed the best photocatalytic ability.

• Journal of the Korea Safety Management & Science
• /
• v.15 no.3
• /
• pp.127-132
• /
• 2013

This study shows an air-purification test by the UV lamp on which TiO2 catalyst is deposited with glass fiber in the reactor chamber. This test was based on the fundamental data of air-purifier as assessing a removing ability on various contaminants such as CH3COOH, NH3, NO and SO2 as variation of the TiO2 coating, the wave of UV lamp, and the additive CaO. As a result, the highest decomposing removal ratio was shown when 5-times coated glass fiber was used. It can be due to the recombination reaction of electrons and electron-hole in the loaded CaO. Thus, the decomposing removal ratio increased as the recombination ratio decreased. In addition, it was confirmed that the decomposing removal ratio lowered when CaO was considerably deposited because it hided the lamp of OH-1 radical.

• Proceedings of the Korean Environmental Sciences Society Conference
• /
• 2003.11b
• /
• pp.305-307
• /
• 2003

Uv/ZnO를 이용한 타르색소의 광촉매 분해에 대한 실험적 검토로부터 전 실험범위에서 tartrazine의 분해효과가 brilliant blue FCF보다 높았고. 두 색소 모두 ZnO의 투입량이 증가할수록 분해도가 증가하였으며, $KBrO_3$보다 (${(NH_4)}_2S_2O_{8}$의 분해촉진 효과가 더 컸으나 pH의 영향은 그다지 크지 않은 것으로 나타났다.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.14 no.1
• /
• pp.117-123
• /
• 2014

The fabrication and characterization of a Si/ZnO thin film heterojunction ultraviolet photodiode has been presented in this paper. ZnO thin film of ~100 nm thick was deposited on <100> Silicon (Si) wafer by atomic layer deposition (ALD) technique. The Photoluminescence spectroscopy confirms that as-deposited ZnO thin film has excellent visible-blind UV response with almost no defects in the visible region. The room temperature current-voltage characteristics of the n-ZnO thin film/p-Si photodiodes are measured under an UV illumination of $650{\mu}W$ at 365 nm in the applied voltage range of ${\pm}2V$. The current-voltage characteristics demonstrate an excellent UV photoresponse of the device in its reverse bias operation with a contrast ratio of ~ 1115 and responsivity of ~0.075 A/W at 2 V reverse bias voltage.

• Journal of Korean Society of Water and Wastewater
• /
• v.11 no.2
• /
• pp.105-111
• /
• 1997

Chlorine dioxide is being used to control THMs formation or taste & odor in water treatment plant. Recently, some operators or academic circles doubted the effectiveness of stabilized chlorine dioxide which is presumed as a liquid form of chlorine dioxide. In this study, we investigated components which consist of stabilized chlorine dioxide in terms of chlorine dioxide and chlorite. Two analytical methods used in this study are UV method and Iodometric method. Iodometric method is recommended by Korean EPA to check the purity of stabilized chlorine dioxide. The samples of stabilized chlorine dioxide from four water treatments were investigated and compared with that produced from chlorine dioxide generator on-site. This study demonstrated that the component of stabilized chlorine dioxide was overwhelmingly chlorite (${ClO_2}^-$) not chlorine dioxide ($ClO_2$) by UV method. It was also proved that Iodometric method (2nd method) recommended by Korean EPA could not differentiate between $ClO_2$ and ${ClO_2}^-$. Iodometric method (2nd method) recommended by Korean EPA should be revised accordingly to measure chlorine dioxide properly.

• Analytical Science and Technology
• /
• v.13 no.5
• /
• pp.652-658
• /
• 2000

Chemical degradation of aqueous humic acid by ozonation was studied with respect to the direct reactions of ozone and the indirect reactions due to its preliminary decomposition to secondary oxidant, OH radical. This was characterized by analyzing TOC, $UV_{254}$ and ozone consumption measured in different experimental conditions in which ozone reacted in the presence of various concentrations of $H_2O_2$ and $HCO_3{^-}$ concentrations ranging from 20 to 100 mg/L. and different pH (5-9). The results suggest that the TOC removal is mainly dependent on indirect reactions of OH radical whereas $UV_{254}$ reduction is mainly dependent on direct reactions of ozone with humic acid molecules. It has been also found that ozone consumption was most likely to be affected by pH and alkalinity in the solution.

• Applied Chemistry for Engineering
• /
• v.28 no.6
• /
• pp.705-713
• /
• 2017

A novel material, $Bi_2WO_6-GO-TiO_2$ composite, was successfully synthesized using a facile hydrothermal method. During the hydrothermal reaction, the loading of $Bi_2WO_6$ and $TiO_2$ nanoparticles onto graphene sheets was achieved. The obtained $Bi_2WO_{6-GO-TiO2}$ composite photo-catalysts were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), energy dispersive X-ray (EDX) analysis, transmission electron microscopy (TEM), Raman spectroscopy, ultraviolet-visible diffuse reflectance spectroscopy (UV-vis-DRS), and X-ray photoelectron spectroscopy (XPS). The $Bi_2WO_6$ nanoparticle showed an irregular dark-square block nanoplate shape, while $TiO_2$ nanoparticles covered the surface of the graphene sheets with a quantum dot size. The degradation of rhodamine B (RhB), methylene blue trihydrate (MB), and reactive black B (RBB) dyes in an aqueous solution with different initial amount of catalysts was observed by UV spectrophotometry after measuring the decrease in the concentration. As a result, the $Bi_2WO_6-GO-TiO_2$ composite showed good decolorization activity with MB solution under visible light. The $Bi_2WO_6-GO-TiO_2$ composite is expected to become a new potential material for decolorization activity. Photocatalytic reactions with different photocatalysts were explained by the Langmuir-Hinshelwood model and a band theory.