• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2001년도 추계학술대회 논문집 Vol.14 No.1
• /
• pp.565-568
• /
• 2001

We have fabricated $Bi_{3.25}La_{0.75}Ti_{3}O_{12}(BLT)$ thin(200nm) films on the $Pt/Ti/SiO_{2}/Si$ substrates using a MOD(Metalorganic decomposition) method with annealing temperature from $550^{\circ}C$ to $750^{\circ}C$. The structural properties of the films examined by x-ray diffraction. The layered-perovskite phase obtained above $600^{\circ}C$. Scanning electron micrographs showed uniform surface composed of rodlike grains. The grain size increased with increasing annealing temperature. The BLT thin films showed little polarization fatigue test up to $3.5{\times}10^{9}$ bipolar cycling at a 5V and 100kHz.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2002년도 하계학술대회 논문집
• /
• pp.301-304
• /
• 2002

We investigated the structural and electrical properties of Ce-doped Ba($Zr_{0.2}Ti_{0.8}$)$O_3$(BCZT) thin films with a mole fraction of x=0.2 and a thickness about 100 nm. BCZT films were prepared on Pt/Ti/$SiO_2$/Si substrate by a RF magnetron sputtering system. We have measured the thickness profile with Ar/$O_2$ ratio and the surface roughness. It was observed that the oxygen gas, which introduced during the film deposition, have an influence on the roughness of the film and the film roughness was reduced by annealing from 2.33 nm to 2.02 m (RMS at $500^{\circ}C$, Ar:6 scrim, $O_2$:6 sccm). We have found that annealing procedure after top electrode deposit can reduce the dissipation factor.

• 센서학회지
• /
• 제14권1호
• /
• pp.56-61
• /
• 2005

This paper present characteristics of chromium oxide thin-film as piezoresistive sensors, which were deposited on Si substrates by DC reactive magnetron sputtering in an argon-Oxide atmosphere for high temperature applications. The chemical composition, physical and electrical properties and thermal stability ranges of the $CrO_{x}$ sensing elements have studied. $CrO_{x}$ thin films with a linear gauge factor(GF${\fallingdotseq}$15), high electrical resistivity (${\rho}$ = $340{\mu}{\Omega}cm$) and TCR<-55 ppm/$^{\circ}C$ have been obtained. These $CrO_{x}$ thin films may allow high temperature pressure sensor miniaturization to be achieved.

• 대한전자공학회논문지SD
• /
• 제44권11호
• /
• pp.15-19
• /
• 2007

OTFTs (Organic Thin Film Transistors)의 구동에 있어, 게이트 절연막 표면과 채널의 계면상태가 소자의 전기적 특성에 큰 영향을 미치게 된다. OTS(Octadecyltrichlorosilane)등과 같은 습식 SAM(Self Assembly Monolayer)를 이용하거나, $O_2$ Plasma와 같은 건식 표면 처리등 여러 표면 처리법에 대한 연구가 진행되고 있다. 본 논문에서는 pentacene을 진공 증착하기 전에 게이트 절연막을 $O_2$ plasma와 Ar ion beam을 이용하여 건식법으로 전처리 한 후 표면 특성을 atomic force microscope (AFM) and X-ray photoelectron spectroscopy (XPS)를 사용하여 비교 분석하였고, 각 조건으로 OTFT를 제작하여 전기적 특성을 확인하였다. Ar ion beam으로 표면처리 했을 때, $O_2$ plasma처리했을 때 보다 향상된 on/off ratio 전기적 특성을 얻을 수 있었다. 표면 세정을 위하여 $O_2$ plasma 처리시 $SiO_2$ 표면의 OH-기와 반응하여 oxide trap density가 높아지게 되고 이로 인하여 off current가 증가하는 문제가 발생한다. 불활성 가스인 Ar ion beam 처리를 할 경우 게이트 절연막의 세정 효과는 유지하면서, $O_2$ Plasma 처리했을 때 증가하게 되는 계면 trap을 억제할 수 있게 되어, mobility 특성은 동등 수준으로 유지하면서 off current를 현저하게 줄일 수 있게 되어, 결과적으로 높은 on/off ratio를 구현할 수 있다는 것을 확인하였다.

• 산업기술연구
• /
• 제19권
• /
• pp.101-105
• /
• 1999

Ultra thin $Ta_2O_5$ gate dielectrics were prepared by RTMOCVD (rapid thermal metal organic chemical vapor deposition) using Ta source $TaC_{12}H_{30}O_5N$ and $O_2$ gaseous mixtures. As a result, $Ta_2O_5$ thin films showed significantly low leakage current compared to $SiO_2$ of identical thickness, which was due to the stabilization of the interfacial layer by NO ($SiO_xN_y$) passivation layer. The conduction of leakage current in $Ta_2O_5$ thin films was described by the hopping mechanism of Poole-Frenkel (PF) type.

• 한국진공학회지
• /
• 제8권3B호
• /
• pp.322-326
• /
• 1999

We have investigated the growing process of a silicon film on the $CeO_2/Si$ surface. The silicon was deposited by using electron beam deposition method. The $CeO_2$(111) film was grown on a (111)-oriented silicon substrate at $700^{\circ}C$ at oxygen [partial pressure of $5\times10^{-5}$ Torr. To investigate the condition of epitaxial growth of si films on the $CeO_2/Si$ substrate, we deposited Si at various temperature니 The overlayer silicon was characterized by using x-ray diffraction(XRD). double crystal x-ray diffraction (DCXRD), and transmission electron microscopy (TEM). At temperature higher than $690^{\circ}C$, $CeO_2$ layer was observed at the $CeO_2/Si$ interface, which was formed by chemical reaction with silicon and oxygen dissociated from $CeO_2$. When silicon was deposited on the $CeO_2/Si$ at $620^{\circ}C$, silicon grew epitaxially along the (111)-direction.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1995년도 춘계학술대회 논문집
• /
• pp.187-191
• /
• 1995

Thin film of the (Pb$\_$1-x/La.sub x/)(Zr$\_$0.25/Ti/Sub 0.48/) O$_3$(x=0~13[at%]) were prepared by Sol - Gel method. Multi-layer PLZT thin films were fabricated by spin-coating on Pt/Ti/SiO$_2$/Si substrate. The crystallinity and microstructure of the films were investigated with the sintering condition. At the sintering temperature of of 600[$^{\circ}C$], the perovskite phase was dominat. PLZT(11/52/48)thin films sintered at 600[$^{\circ}C$], 1[hr] had good dielectric constant (1236), dielectric loss (2.2[%]), remanent polarization (1.38[${\mu}$C/$\textrm{cm}^2$] and coercive field(16.86[ kV/cm]) respectively.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2002년도 하계학술대회 논문집 Vol.3 No.2
• /
• pp.1144-1147
• /
• 2002

Ferroelectric $Sr_xBa_{1-x}Nb_2O_6(0.25{\leq}x{\leq}0.75)$ thin films were prepared by the Ion Beam Sputtering method. Deposit onto Pt/Ti/$SiO_2$/Si(100) substrates. The deposited thin films were heat-treated for crystallization. Microstructure and crystallization behavior were examined using FE-SEM, XRD. Ferroelectric hysteresis were measured. The measured remanent polarization and coercive field values were $38{\mu}C/cm^2$ and 120kV/cm, respectively.

• Bulletin of the Korean Chemical Society
• /
• 제30권1호
• /
• pp.201-204
• /
• 2009

$BaTiO_3/SrTiO_3$ and $PbTiO_3/PbZrO_3$ superlattice thin films were fabricated on $Pt/Ti/SiO_2/Si$ substrate by the pulsed laser deposition process. The morphologies and physical properties of deposited films were characterized by using X-ray diffractometer, HR-SEM, and Impedance Analyzer. XRD data and SEM images of the films indicate that each layer was well deposited alternatively in the superlattice structure. The dielectric constant of $BaTiO_3/SrTiO_3$ superlattice thin film was higher than that of individual $BaTiO_3$ or $SrTiO_3$ film. Same result was obtained in the $PbTiO_3/PbZrO_3$system. The dielectric constant of a superlattice film was getting higher as the number of layer is increased.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2002년도 International Meeting on Information Display
• /
• pp.625-627
• /
• 2002

MgO thin films were deposited on glass and (100) Si substrates by an Arc Ion Plating (AIP) equipment using a magnesium metal target at various oxygen gas flow. In this work, we investigated the relationship between the structural properties and the discharge characteristics of MgO coating layers. X-ray diffraction and AFM have been used to study behaviors of the structure and surface morphology. The optical transmittance and the ion induced secondary electron emission coefficient of the MgO films have been also measured. The resistivity of the deposited MgO films was gradually increased from 0.17 G ohm/${\square}$ to 0.35 G ohm/${\square}$ with the oxygen gas flow. The growth rate of the MgO coating layer was decreased with increasing the oxygen gas flow, while the optical transmittance was improved.