• Korean Journal of Food Science and Technology
• /
• v.36 no.3
• /
• pp.507-513
• /
• 2004

Microbiological safety investigation of 36 commercial salt-fermented shrimps revealed presence of coliform and Gram(+) cocci, whereas pathogenic bacteria such as Escherichia coli O26, Salmonella, Shigella, Staphylococcus aureus, Vibrio parahaemolyticus, and V. cholerae were not detected. When pathogenic bacteria were inoculated into 9, 18, and 27% salted shrimps, Salmonella so., E. coli O26, and S. aureus were not detected up to 13, 80, and 90 days of fermentation at $20^{\circ}C$, respectively, whereas up to 15 day in commercial salt-fermented shrimps.

• Korean Chemical Engineering Research
• /
• v.43 no.6
• /
• pp.751-755
• /
• 2005

Carbon dioxide, included in the flue gas from the combustion of fossil fuel, was known as a representative green house gas and various removal and utilization technologies of it has been studied for the prevention of global warming. This study was performed as an effort to find out a method to reuse carbon dioxide separated from flue gas by magnetite powder. Magnetite powder was synthesized using various oxidizers and alkalinity controlled aqueous solutions of $FeSO_4{\cdot}7H_2O$ and NaOH at 50, 80, 90, $100^{\circ}C$ and analyzed by XRD and SEM. The analysis results showed that magnetite powder synthesized at higher alkalinity and temperature had crystalline spinel and cubic structure. The reduction by hydrogen and the oxidation by carbon dioxide of synthesized powder were studied by TGA. The results showed that magnetite powder synthesized at low alkalinity and temperature was non-cubical amorphous but crystalline and cubical at high alkalinity and temperature. Comparing magnetite powders synthesized using oxidants(air and oxygen) and nitrogen, magnetite powder using more oxygen containing oxidant synthesized more crystalline magnetite powder. The experimental results of redox reaction of the synthesized magnetite powder showed that the reduction by hydrogen and the oxidation by carbon dioxide were seldom observed below $400^{\circ}C$ and observed well at $500^{\circ}C$. Magnetite powder synthesized at $100^{\circ}C$ and alkalinity(molal concentration ratio of $FeSO_4{\cdot}7H_2O$ to NaOH) of 2.0 using $O_2$ showed the highest reduction of 27.15 wt％ and oxidation of 26.73 wt％, especially at reaction temperature of $500^{\circ}C$.

• Resources Recycling
• /
• v.28 no.5
• /
• pp.51-59
• /
• 2019

This study focused on the synthesis of the nickel hydroxide using ammonium sulfate in leaching solution from waste nickel-cadmium batteries. The effect of pH, temperature and the input amount of ammonium sulfate in leaching solution was investigated. The ammonium nickel sulfate with high purity was obtained in acidic leaching solution and the solution temperature of $60^{\circ}C$. The suitable molar ratio of the input amount of ammonium sulfate to nickel in solution is 2:1. The impurity about 1.4 at.% of Cd was included in the nickel hydroxide precipitates when ammonium nickel sulfate was used. At the process using sodium sulfide which precipitates the cadmium in solution, nickel and iron compounds were precipitated together.

• Korean Journal of Medicinal Crop Science
• /
• v.11 no.2
• /
• pp.161-166
• /
• 2003

Korean ginseng(Panax gmseng C.A. Meyer) is very difficult to obtain stable production of qualified ginseng roots because of variable stresses in soil environments. In environment stresses, soil condition is the most important factor, among which nutrients, especially inorganic materials such as N, P, K, Ca, Mg, Fe, etc., influence greatly on the ginseng growth. However, present ginseng field soils in Korea contain so much amount of such inorganic materials that a variety of remarkable disorders were noted in many ginseng plantations, resulting in decrease of qualitative ginseng production. Therefore, it is required to search for genetic resources and genes tolerant to salt stress for the development of ginseng cultivars. Selection of stress-tolerant ginseng lines in fields is very difficult because it is almost impossible to control properly the environmental conditions of soil. On the contrary, it can be studied with ease to search for stress-tolerant ginseng lines through in vitro culture because of easy manipulation of stress conditions. Murashige & Skoog(MS) media with 2.5 folds of $KNO_3,\;NH_4NO_3,\;MgSO_4\;7H_2O,\;KH_2PO_4,\;and\;CaCl_2\;2H_2O$ was established for the selection of ginseng lines tolerant to salt stress under the embryo culture.

• Applied Chemistry for Engineering
• /
• v.29 no.3
• /
• pp.356-361
• /
• 2018

It is common to analyze volatile organic compound (VOC) or semi-VOC (SVOC) in a sample composed of a complex matrix consisting of multiple components such as bloods through a separation process. Adsorption is a physical phenomenon in which certain components accumulate on the surface of other phases. In order to overcome difficulties in the pretreatment process, an adsorption is frequently used. Solid phase microextraction (SPME) equipment with porous carbon carboxen (CAR) is an example of adsorption application. In this study, the adsorption of 4-octylphenol to carboxen was examined. To do so, the extraction efficiency for such solvents as dichloromethane ($CH_2Cl_2$, DCM), ethylacetate ($CH_3COOC_2H_5$, EA) and diethylether ($C_2H_5OC_2H_5$, $Et_2O$) was studied and also the derivatization reaction for 4-octylphenol with reagents of bistrimethylsilyltrifluoroacetamide (BSTFA), methylchloroformate (MCF) and pentafluorobenzylbromide (PFBBr) was compared. The combination of DCM and BSTFA showed good performance thus they were adopted for this study. Thermodynamic adsorption experiments showed that the adsorption process was endothermic and Freundlich isotherm equation was more suitable than Langmuir isotherm. It was also found that the adsorption followed a pseudo-$2^{nd}$ order kinetic model.

• Korean Journal of Food Science and Technology
• /
• v.40 no.2
• /
• pp.123-128
• /
• 2008

The MRLs (maximum residue limits) of DDT (DDD and DDE) in fresh ginseng, dried ginseng, and steamed red ginseng are set as low as 0.01 mg/kg, 0.05 mg/kg, and 0.05 mg/kg, respectively. Therefore, this study was undertaken to develop a simple and highly sensitive analysis method, as well as to reduce interfering ginseng matrix peaks, for the determination of DDT isomers (o,p'-DDE, p,p'-DDE, o,p'-DDD, p,p'-DDD, o,p'-DDT, and p,p'-DDT) in fresh ginseng, dried ginseng, and steamed red ginseng at the 0.01 mg/kg level. The method used acetonitrile extraction according to simultaneous analysis, followed by normal-phase Florisil solid-phase extraction column clean-up. The purification method entailed the following steps: (1) dissolve the concentrated sample extract in 7 mL hexane; (2) add 3 mL of $H_2SO_4$; (3) vigorously shake on avortex mixer; (4) cetrifuge at 2000 rpm for 5 min; (5) transfer 3.5 mL of the supernatant to the Florisil-SPE (500 mg/6 mL);and (6) elute the SPE column with 1.5 mL of hexane and 10 mL of ether/hexane (6:94). The determination of DDT isomers was carried out by a gas chromatography-electron capture detector (GC-${\mu}$ECD). The hexane and ether/hexane (6:94) eluate significantly removed chromatographic interferences, and the addition of 30% $H_2SO_4$ to the acetonitrile extract effectively reduced many interfering ginseng matrix peaks, to allow for the determination of the DDT isomers at the 0.01 mg/kg level. The recoveries of the 6 fortified (most at 0.01 mg/kg) DDT isomers from fresh ginseng, dried ginseng, and steamed red ginseng ranged from 87.9 to 99.6%. The MDLs (method detection limits) ranged from 0.003 to 0.009 mg/kg. Finally, the application of this method for the determination of DDT isomers is sensitive, rapid, simple, and inexpensive.

• Journal of Life Science
• /
• v.23 no.6
• /
• pp.757-769
• /
• 2013

A microorganism producing carboxymethylcellulase (CMCase) was isolated from seawater, identified as Bacillus velezensis by analyses of 16S rDNA and partial sequences of the gyrA, and designated as B. velezensis A-68. The optimal conditions for production of CMCase by B. velezensis A-68 were established using response surface methodology (RSM). The optimal concentrations of rice hulls and yeast extract, and initial pH of the medium for cell growth were 60.2 g/l, 7.38 g/l, and 7.18, respectively, whereas those for production of CMCase were 50.0 g/l, 5.00 g/l, and 7.30. The analysis of variance (ANOVA) implied that the most significant factor for cell growth as well as production of CMCase was yeast extract. The optimal concentrations of $K_2HPO_4$, NaCl, $MgSO_4{\cdot}7H_2O$, and $(NH_4)_2SO_4$ in the medium for cell growth were 7.50, 1.00, 0.10, and 0.80 g/l, respectively, which were the same as those for production of CMCase. The optimal temperatures for cell growth and production of CMCase were 30 and $35^{\circ}C$, respectively. The maximal production of CMCase under optimized conditions was 83.8 U/ml, which was 3.3 times higher than that before optimization. In this study, rice hulls, agro-byproduct, were developed as a substrate for production of CMCase and time for production of CMCase was reduced to 3 days using a newly isolated marine bacterium.

• Resources Recycling
• /
• v.19 no.6
• /
• pp.51-60
• /
• 2010

A study on the recovery of cobalt and lithium from Lithium Ion Battery(LIB) scraps has been carried out by a physical treatment - leaching - solvent extraction process. The cathode scraps of LIB in production were used as a material of this experiment. The best condition for recovering cobalt from the anode scraps was acquired in each process. The cathode scraps are dissolved in 2M sulfuric acid solution with hydrogen peroxide at $95^{\circ}C$, 700 rpm. The cobalt is concentrated from the leaching solution by means of a solvent extraction circuit with bis(2-ethylhexyl) phosphoric acid(D2EHPA) and PC88A in kerosene, and then cobalt and lithium are recovered as cobalt hydroxide and lithium carbonate by precipitation technology. The purity of cobalt oxide powder was over 99.98% and the average particle size after milling was about 10 lim. The over all recoveries are over 95% for cobalt and lithium. The pilot test of mechanical separation was carried out for the recovery of cobalt from the scraps. The $Co_3O_4$ powder was made by the heat treatment of $Co(OH)_2$ and the average particle size was about 10 ${\mu}m$ after grinding. The recovery was over 99% for cobalt and lithium each other and the purity of cobalt oxide was over 99.98%.

• KSBB Journal
• /
• v.14 no.1
• /
• pp.103-108
• /
• 1999

A bacterium having strong fibrinolytic activity, S7-16 strain, was isolated from soil. The isolated bacterium was identified and named as Bacillus sp. S7-16. The optimal composition of the medium for the production of fibrinolytic enzyme by Bacillus sp. S7-16 was 0.5%(w/v) polypeptone, 0.5%(w/v) yeast extract, 0.3%(w/v) NaCl, 0.1% (w/v) $KH_2PO_4,\;0.3%(w/v)\;K_2PHO_4,\;and\;0.01%(w/v)\;MgSO_4{\cdot}7H_2O$. The optimal temperature and initial pH of the medium for the production of the enzyme were $35^{\circ}C$ and 7.0, respectively. The maximum production of the fibrinolytic enzyme was obtained after 24 hours of the incubation. Under the above conditions, the culture supernatant had strong fibrinolytic activity. Within pH4~11, the crude fibrinolytic enzyme was stable. The enzyme was stable up to $50^{\circ}C$. The optimum pH and temperature for the enzyme activity were around 7.5 and $40^{\circ}C$, respectively.

• The Transactions of the Korea Information Processing Society
• /
• v.7 no.2
• /
• pp.426-436
• /
• 2000

Given a linear arrangement of n base stations which generate multiple types of traffic among themselves, we consider the problem of finding a set of disjoint clusters to cover n base statons so that a cluster is assigned a location server. Our goal is to minimize the total communication cost for the entire network where the cost of intra-cluster communication is usually lower than that of intercluster communication for each type of traffic. The optimization problem is transformed into an equivavalent problem using the concept of relative cost, which generates the difference of communication costs between intracluster and intercluster communications. Using the relative cost matrix, an efficient algorithm of O($mm^2$), where m is the number of clusters in a partition, is designed by dynamic programming. The algorithm also finds all thevalid partitions in the same polynomial time, given the size constraint on a cluster, and the total allowable communication cost for the entire network.