• Proceedings of the Korean Powder Metallurgy Institute Conference
• /
• 2006.09a
• /
• pp.158-159
• /
• 2006

Ultrafine Au-Pb particles prepared by two method, (1) simultaneous evaporation of Au and Pb in inert gas and (2) subsequent vapor condensation of Pb in a differentially evacuated tube onto flying Au nanoparticles prepared by gasevaporation technique, were observed by electron microscopy. In the method (1), the particles that grew at the region where the two smoke masses converged, consisted of alloy phases. In the method (2), the particles consisted of two or three phases of Au, $Au_2Pb$, $AuPb_2$ and Pb phases in turn from the inner part, Pb-rich particles being composed of only two phases of $AuPb_2$ and Pb.

• Journal of the Korean Ceramic Society
• /
• v.33 no.11
• /
• pp.1267-1275
• /
• 1996

Green sheet was prepared by tape casting in the composition of (1-x)Pb(Mg1/3Nb2/3)O3-PbTiO3 system using Pb(Mg1/3Nb2/3)O3 and PbTiO3 synthesized with PbO, Nb2O5 MgO and TiO2 The densest green sheet was obtained in the weight ratio 70:30 of powder to binder. Green sheet wasmultilayered in metal mould and formed into lamination at 7$0^{\circ}C$, 300kg/cm2 The lamination was sintered at 110$0^{\circ}C$ 2hr, Dielectric constant and Curie temperature of disc type sintered body was highered with increasing the amount of PbTiO3 and was in the range of 19000-21000, -7~45$^{\circ}C$ respectively. Green and sintered relative density of lamination was 61% and 95% respectively.

• Resources Recycling
• /
• v.33 no.2
• /
• pp.54-61
• /
• 2024

When steel contaminated with Pb, produced by the decay of natural radionuclides, is remelted, Pb distributes among the metal, slag, and gas phases. In this study, 5 wt%Pb was added to Fe and melted with CaO-SiO₂-Al₂O₃-MgO slag to investigate Pb's distribution in the metal/slag/gas. As slag basicity ((wt%CaO)/(wt%SiO₂)) increased, Pb solubility in Fe slightly increased, while Pb in the slag tended to decrease. Consequently, the slag/metal distribution ratio of Pb decreased with increasing basicity. Thermodynamic calculations revealed that the slag/Fe phase distribution ratio of Pb remained very low irrespective of the activity coefficient of PbO in the slag, consistent with the experimental results. The calculated evaporation rate of Pb in Fe-Pb was approximately 22 times that of Fe; hence, most of the Pb evaporated into the gas phase.

• Journal of the Korean Ceramic Society
• /
• v.25 no.5
• /
• pp.488-494
• /
• 1988

Effects of MnO2 addition on themicrostructure, dielectric and piezoelectric properties of Rhombohedral, Tetragonal and Morphotropic phase boundary(MPB) in Pb(Ni1/3Nb2/3)O3-PbTiO3-PbZrO3 system were investigated and respectively the amount of MnO2 addition was 0, 0.2, 0.5, 1.0, 3.0wt%. In the tetragonal region, compared with the Rhombohedral and Morpotropic phase boundary, Mechanical quality factor(Qm), Curie temperature(Tc) and Dissipation factor were promoted by addition of MnO2. According to the results of the microstructure, dielectric and piezoelectric properties, the solid solution range of MnO2 addition in this system was 0.2-0.5wt%.

• Journal of Microbiology and Biotechnology
• /
• v.8 no.4
• /
• pp.412-415
• /
• 1998

The accumulation process of $Pb^{2＋}$ in an industrial strain of Saccharomyces cerevisiae proved to be temperature-dependent, and was quite similar to chemical adsorption at the initial stage of $Pb^{2＋}$accumulation. The initial $Pb^{2＋}$ accumulation rate increased from 11.4 to 46.2 mg $Pb^{2＋}$/g cell dry weight/day, in response to the increased temperature from $20^{\circ}C\;to\;50^{\circ}C$ while the maximal $Pb^{2＋}$ accumulation amount (175.8 mg $Pb^{2＋}$/g cell dry weight) was achieved at $30^{\circ}C$. The maximal $Pb^{2＋}$/ accumulation amount with temperature was independent of ion exchange with $K^＋\;and\;Mg^{2+}$.

• Applied Chemistry for Engineering
• /
• v.7 no.6
• /
• pp.1105-1114
• /
• 1996

The characteristic and performance of ${\beta}-PbO_2$ layer electrodeposited on ${\alpha}-PbO_2/IrO_2-TiO_2/Ti$ substrate by adding sodium lauryl sulfate and $TiO_2$ powder in lead nitrate solution were investigated by using XRD, SEM, cyclic voltammograms, and macro-elctrolysis. Results of XRD analysis ascertain that ${\beta}-PbO_2$ layers electrodeposited in the presence of sodium lauryl sulfate and $TiO_2$, powder on ${\alpha}-PbO_2/IrO_2-TiO_2/Ti$ substrate have the same tetragonal structure as pure ${\beta}-PbO_2$ layers. The SEM results show that sodium lauryl sulfate tend to diminish crystal size of the deposited layer. The ${\beta}-PbO_2$ electrode electrodeposited in the presence of sodium lauryl sulfate and $TiO_2$ powder gives significantly improved oxygen overvoltage and durability for anodic oxidation in KOH and $HClO_4$ supporting electrolyte. Electrode performance and durability for the evolution of ozone in perchloric acid solution have been investigated by using ${\beta}-PbO_2$ electrodes electrodeposited on Titanium $madras^{(R)}$. It was ascertained that the $PbO_2$ electrode electrodeposited on ${\alpha}-PbO_2/IrO_2-TiO_2/Ti$ $madras^{(R)}$ by adding sodium lauryl sulfate and $TiO_2$ powder in $HClO_4$ supporting electrolyte had the highest current efficiency and durability.

• Journal of Korean Society of Environmental Engineers
• /
• v.38 no.12
• /
• pp.647-655
• /
• 2016

Lead dioxide ($PbO_2$) is an electrode material that is effective for organic pollutant degradation based on hydroxyl radical ($^{\bullet}OH$) attack. Representative parameters for $PbO_2$ electrodeposition are summarized to current, temperature, reaction time, concentration of Pb(II) and electrolyte agent. In this study, $Ti/PbO_2$ electrodes were fabricated by electrodeposition method under controlled reaction time, current density, temperature, concentration of $HNO_3$ electrolyte. Effects of deposition parameters on $^{\bullet}OH$ evolution were investigated in terms of electrochemical bleaching of p-Nitrosodimethylaniline (RNO). As major results, the $^{\bullet}OH$ evolution was promoted at the $PbO_2$ that was deposited in longer reaction time (1-90 min), lower current density ($0.5-50mA/cm^2$), higher temperature ($5-65^{\circ}C$) and lower $HNO_3$ concentration (0.01-1.0 M). Especially, the $PbO_2$ which was deposited in 0.01 M of lowest $HNO_3$ concentration by applying $20mA/cm^2$ for above 10 min was most effective on $^{\bullet}OH$ evolution. The performance gap between $PbO_2$s that was best and worst in $^{\bullet}OH$ evolution was about 41%. Among the properties of $PbO_2$ related on $^{\bullet}OH$ evolution performance, conductivity of $Ti/PbO_2$ significantly influenced on $^{\bullet}OH$ evolution. The increase in conductivity promoted $^{\bullet}OH$ evolution. In addition, the increase in crystal size of $PbO_2$ interfered $^{\bullet}OH$ evolution at surface of some $PbO_2$ deposits.

• Electrical & Electronic Materials
• /
• v.4 no.3
• /
• pp.220-228
• /
• 1991

본 연구에서는 핫프레스법으로 제작된 0.05Pb(Sn$_{1}$2/Sb$_{1}$2/)O$_{3}$-0.60PbZrO$_{3}$-0.35PbTiO$_{3}$+x[wt%]MnO$_{2}$ 세라믹스에 대해 구조적, 전기적 특성 및 탄성 표면파 특성을 조사하였다. x가 0.4인 조성을 1150[.deg.C]에서 45분간 소성한 시편의 경우 탄성표명파의 전기 기계 결합 계수 k$_{s}$ $^{2}$가 2.8[%], 기계적 품질 계수 Q$_{m}$ 이 1976으로 탄성 표면파 소자용 기판으로서 응용 가능함을 보였다.

• Journal of the Microelectronics and Packaging Society
• /
• v.1 no.2
• /
• pp.125-134
• /
• 1994

저항범위가 다른 두종류의 Ru계 후막저항계(1Kohm/sq. 100kohm/sq.)를 선택하여 도전상의 상전이 기구를 반응조건을 변화시켜 연구하였다. 저저항체의 경우 도전상으로는 RuO2였으며 700-100$0^{\circ}C$에서 1시간 반응한 경우 반응온도에 따른 구성상의 변화는 없었다 반응온도 90$0^{\circ}C$에서 반응시간이 경과함에 따라 도전상은 RuO2가 Glass의 구성성분인 Pb와 반응하여 Rb2(Ru1.69 Pb0.31)O6.5로 변하고 시간이 36시간 경과한 후에는 도전상이 Pb4Al2Si2O10인 결정으로 둘러 쌓이는 반응인 peritectic reaction이 일어났다. 고전항체의 경 우 도전상으로는 Pb2(Ru1.69 Pb0.31)O6.5로 변하고 시간이 36시간 경과한 후에는 더전상이 Pb4Al2Si2O10인 결정으로 둘러쌓이는 반응인 peritectic reaction 이 일어났다. 고저항체의 경 우 도전상으로는 Pb2(Ru1.69 Pb0.31)O6.5인 pyrochrole 상이였다. 100$0^{\circ}C$에서 1시간 반응시킬 경 우 도전상이 RuO2로 변하였다. 반응온도를 90$0^{\circ}C$로 하고 반응시간을 변화시키면 도전상인 Pb2(Ru1.69 Pb0.31)O6.5가 (Ru1.69Pb0.31)O4x로 변하면서 공존하였다.

• Journal of Environmental Health Sciences
• /
• v.46 no.5
• /
• pp.532-538
• /
• 2020

Objectives: The study evaluated correlations among monthly PM_2.5, PM₁₀, Cd, Pb concentrations and the number of Asian dust days. Methods: Based on data from 'The annual report on air quality in Korea from 1999 to 2017', concentrations of PM₁₀, PM_2.5, Cd, Pb, and the number of Asian dust days were recalculated to mean, standard deviation, minimum, and maximum. Correlation coefficients were calculated among PM_2.5, PM₁₀, Cd, Pb, and Asian dust days. Results: Asian dust days were correlated only with PM₁₀ among the four factors of PM₁₀, PM_2.5, Cd, and Pb. The four factors of PM₁₀, PM_2.5, Cd, and Pb were very significantly correlated with each other (p<0.01). Their correlation coefficients for PM₁₀ were 0.800 for PM_2.5, 0.823 for Cd, and 0.892 for Pb. PM_2.5 was also correlated strongly with Cd (0.845) and Pb (0.830). Cd had a correlation with Pb of 0.971. The maximums of PM_2.5, PM₁₀, and Pb were shown to exceed the atmospheric environmental standard of Korea, which necessitates national continuous exposure control. Based on exposure data, Asian dust days were thought to be an exposure factor for Cd and Pb. Conclusion: Asian dust might be a factor in Cd and Pb exposure. National exposure controls are required for exposure to PM_2.5, PM₁₀, Cd, and Pb.