• Clean Technology
• /
• v.23 no.1
• /
• pp.104-112
• /
• 2017

Hydrogen production via steam reforming of liquefaction liquid from marine algae over hydrothermal liquefaction was carried out at 873 ~ 1073 K with a commercial catalyst and Ni based $K_2Ti_xO_y$ added catalysts. Liquefaction liquid obtained by hydrothermal liquefaction (503 K, 2 h) was used as a reactant and comparison studies for catalytic activity over different catalysts (FCR-4-02, $Ni/K_2Ti_xO_y-Al_2O_3$, $Ni/K_2Ti_xO_y-SiO_2$, $Ni/K_2Ti_xO_y-ZrO_2/CeO_2$ and Ni/$K_2Ti_xO_y$-MgO), reaction temperature were performed. Experimental results showed Ni/$K_2Ti_xO_y$ based catalysts ($Ni/K_2Ti_xO_y-Al_2O_3$, $Ni/K_2Ti_xO_y-SiO_2$, Ni/$K_2Ti_xO_y-ZrO_2$/ $CeO_2$ and Ni/$K_2Ti_xO_y$-MgO) have a higher activity than commercial catalyst (FCR-4-02) and In particular, a product composition was different depending on support materials. An acidic support ($Al_2O_3$) and a basic support (MgO) led to a higher selectivity for CO while a neutral support ($SiO_2$) and a reducing support ($ZrO_2/CeO_2$) resulted in a higher $CO_2$ selectivity due to water gas shift reaction.

• Clean Technology
• /
• v.25 no.4
• /
• pp.296-301
• /
• 2019

This study was conducted to investigate the characteristics of CO oxidation by NO poisoning in Pt/TiO₂ catalyst prepared by wet impregnation method and calcined at 400 ℃. In order to confirm the NO poisoning effect of the Pt/TiO₂ catalyst, the change of reaction activity was observed when NO was injected during the CO+O₂ reaction where it was ascertained that the CO conversion rate rapidly decreased below 200 ℃. Also, CO conversion was not observed below 125 ℃. Recovery of initial CO conversion was not verified even if NO injection was blocked at 125 ℃. Accordingly, various analyses were performed according to NO injection. First, as a result of the TPD analysis, it was confirmed that NO pre-adsorption in catalyst inhibited CO adsorption and conversion desorption from adsorbed CO to CO₂. When NO was pre-adsorbed, it was confirmed through H₂-TPR analysis that the oxygen mobility of the catalyst was reduced. In addition, it was validated through FT-IR analysis that the redox cycle (Pt²⁺→Pt⁰→Pt²⁺) of the catalyst was inhibited. Therefore, the presence of NO in the Pt/TiO₂ catalyst was considered to be a poisoning factor in the CO oxidation reaction, and it was determined that the oxygen mobility of the catalyst is required to prevent NO poisoning.

• Journal of the Korean Magnetics Society
• /
• v.10 no.5
• /
• pp.220-224
• /
• 2000

Ultra-fine $Co_{1+x}$F $e_{2-}$2x/ $Ti_{x}$ $O_4$ferrite powders have been prepared by the sol-gel method. The crystallographic and magnetic properties of the sample have been investigated by means of x-ray diffraction, Mossbauer spetroscopy and vibrating sample magnetometry. The formation of nano crystallized particles is confirmed. The x-ray diffractions of all samples with various compositions clearly indicate the presence of spinel structure. The Mossbauer spectra could be fitted as the superposition of two sextets due to F $e^{3+}$ A-site and B-site. The IS and QS values nearly constant with substituted Co-Ti contents, whereas $H_{hf}$ of B-site decreases with increasing Co-Ti substitution in $Co_{1+x}$F $e_{2-}$2x/ $Ti_{x}$ $O_4$. The magnetic behaviour of powders shows that the saturation magnetization and the coercivity decrease with increasing x in $Co_{1+x}$F $e_{2-}$2x/ $Ti_{x}$ $O_4$.$.X>.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.57 no.9
• /
• pp.1599-1605
• /
• 2008

The research was conducted in order to improve the hydrogen generation efficiency of the electrical plasma technology from tap water by using $TiO_2$ photocatalyst, mixed Cu - $TiO_2$ powder, and mixed Ni - $TiO_2$ powder as the catalysts. Experiments were performed with the pulsed power and nitrogen carrier gas. The result has shown that the hydrogen concentration with the presence of $TiO_2$ powder was created higher than that of without using photocatalyst. The hydrogen concentration with using $TiO_2$ was 3012ppm corresponding to the applied voltage of 16kV, while it without using the $TiO_2$ was 1464ppm at the same condition . The effect of $TiO_2$ powder was strongly detected at the applied voltages of 15kV and 16kV. This phenomena might be resulted from the co-effect of the pulsed power discharge and the activated state of $TiO_2$ photocatalyst. The co-effect of the mixed catalysts such as Cu-$TiO_2$ and Ni-$TiO_2$ (the mixed photocatalyst $TiO_2$ and transition metals) were also investigated. The experimental results showed that, Cu and Ni powder dopants were greatly enhancing the activity of the $TiO_2$ photocatalyst. Under these experimental conditions the extremely high hydrogen concentrations at the optimal point were produced as 4089ppm and 6630ppm, respectively.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2006.06a
• /
• pp.448-449
• /
• 2006

For the possible applicative pearl pigment, multi-layered $TiO_2/Al/TiO_2$, $TiO_2/Cr/TiO_2$ thin film was deposited on glass substrate by using sputtering method. $TiO_2$ and Al or Cr was selected as a possible high and low refraction materials at the film interface respectively. Optical properties including color effect were systematically studied in terms of different film thickness and film layers by using spectrometer. In order to expect the experimental results, the simulation program, the Essential Macleod Program(EMP) was adopted and compared with the experimental data. The film consisting of $TiO_2/Al/TiO_2$, $TiO_2/Cr/TiO_2$ layers show the wavelength range of 430 - 760nm, typically color ranges between bluish purple and red. It was confirmed that this experimental result was quite well matched with the experimental one.

• Journal of the Korean Magnetics Society
• /
• v.10 no.4
• /
• pp.154-158
• /
• 2000

Crystallographic and magnetic properties of the Co and Ti-doped BaF $e_{12-2x}$ $Co_{x}$ $Ti_{x}$ $O_{19}$(0.0$\leq$x$\leq$1.0) system have been investigated by means of x-ray diffractometry, Mossbauer spectroscopy, and vibrating sample magnetometer. The structure of the system was found to be the magnetoplumbite structure, and the lattice parameter a is nearly constant and c increase as the doped Co-Ti contents increasing. We found that the saturation magnetization nearly unchanged but the coercivity rapidly decreased between x = 0.0 and x = 0.2 with increasing x in BaF $e_{12-2x}$ $Co_{x}$ $Ti_{x}$ $O_{19}$. From the Mossbauer spectra analysis Co-Ti ions prefer 12k, 4 $f_{vi}$ and 2b sites.tes.

• Journal of the Korean Society of Safety
• /
• v.21 no.2 s.74
• /
• pp.35-45
• /
• 2006

Cobalt catalysts for gas mask loaded on various supports such as $Al_{2}O_{3},\;TiO_{2}$, AC(activated carbon) and $SiO_{2}$ were used to examine influences of calcination temperatures and reaction temperatures for CO oxidation. $Co(NO_{3})_2{\cdot}6H_{2}O$ was used as cobalt precursor and the catalysts were prepared by incipient wetness impregnation. The catalysts were characterized using XRD, TGA/DTA, TEM, $N_{2}$ sorption, and XPS. For the catalytic activity, support was in the order of ${\gamma}-Al_{2}O_{3}>TiO_{2}>SiO_{2}>AC\;and\;Al_{2}O_{3}$. The catalytic activity at lower temperature than $80^{\circ}C$ showed that with the increase of reaction temperature, cobalt catalysts on ${\gamma}-Al_{2}O_{3},\;TiO_{2},\;AC\$ has the negative activation energy but that of $SiO_{2}$ was positive.

• Korean Journal of Materials Research
• /
• v.5 no.3
• /
• pp.324-332
• /
• 1995

전자빔 증착법을 사용하여 Ti과 Co를 Si(100) 단결정, 다결정 Si 및 Si$O_{2}$기판에 증착한 후 90$0^{\circ}C$에서 20초 급속 열처리하여, Co/Ti 이중박막으로부터의 실리사이드화 반응을 조사하였다. 단결정 시편의 경우 Ti의 두께를 5~6mm로 최소화함으로서 두께가 균일하고 기판과의 계면이 평탄하며 비저항이 낮고 열적 안정성이 높은 Co$Si_{2}$ 에피박막을 형성할 수 있었다. 그러나 다결정 시편에는 두께와 계면이 불균일하고 열적으로도 불안정한 다결정의 Co$Si_{2}$와 그 위에 두개의 Co-Ti-Si혼합층이 형성되었다. 한편 Si$O_{2}$ 우에 증착된 Co/Ti은 열처리를 하여도 확산하지 않고 그대로 남아 있어서, Co/Ti 이중박막의 Si$O_{2}$와의 반응성이 미약함을 보여 주었다.

• Bulletin of the Korean Chemical Society
• /
• v.29 no.6
• /
• pp.1217-1223
• /
• 2008

A series of Zr,S co-doped $TiO_2$ were synthesized by a modified sol-gel method and characterized by various spectroscopic and analytical techniques. The presence of sulfur caused a red-shift in the absorption band of $TiO_2$. Co-doping of sulfur and zirconium (Zr-$TiO_2$-S) improves the surface properties such as surface area, pore volume, and pore diameter and also enhances the thermal stability of the anatase phase. The Zr-$TiO_2$-S systems are very effective visible-light active catalysts for the degradation of toluene. All reactions follow pseudo firstorder kinetics with the decomposition rate reaching as high as 77% within 4 h. The catalytic activity decreases in the following order: Zr-$TiO_2$-S >$TiO_2$-S >Zr-$TiO_2$>$TiO_2$$\approx$ P-25, demonstrating the synergic effect of codoping with zirconium and sulfur. When the comparison is made within the series of Zr-$TiO_2$-S, the catalytic performance is found to be a function of Zr-contents as follows: 3 wt % Zr-TiO2-S >0.5 wt % Zr-$TiO_2$-S> 5 wt % Zr-$TiO_2$-S >1 wt % Zr-$TiO_2$-S. Higher calcination temperature decreases the reactivity of Zr-$TiO_2$-S.

• Proceedings of the KIEE Conference
• /
• 1997.07d
• /
• pp.1439-1442
• /
• 1997

We investigated the electrical and CO sensing properties of ZnO-$TiO_2$ composite ceramics. The electrical conductivities and relative dielectric constants of $TiO_2$ added ZnO increased with increasing $TiO_2$ content in air. The calculated dielectric constants of 3mol%, 5mol%, and 7mol% $TiO_2$ added ZnO were 7, 13, and 120, respectively. The measured CO sensivities were $1{\sim}6.42$ in the temperature range from $100^{\circ}C$ to $400^{\circ}C$.