• Transactions of the Korean Society of Automotive Engineers
• /
• v.8 no.2
• /
• pp.19-26
• /
• 2000

This paper presents the effects of initial pressure of mixture on CO, $CO_2$ and NOx emissions in constant volume combustion chamber. The CO, $CO_2,O_2,N_2$ concentrations in the chamber are determined by thermal conductivity detection (Gas-chromatograph) wile the NOx concentration is measured by chemiluminescent detection (NOx Analyser). Methane-air mixture is used as premixed fuel and the measurements are taken with equivalence ratios($\phi$) varing from 0.6 to 1.3, and initial pressures of methane-air mixture varing from 0.1MPa to 0.8MPa in constant volume combustion chamber. The NOx concentration steadily increases with increasing equivalence ratio, peaks in lean flame ($\phi$=0.85~0.9), and then rapidly decreases. However, as the initial pressure of mixture is increased, the equivalence ratio corresponding to the point of peak [NOx] shifts towards leaner conditions. This is caused by a similar shift in the peak [CH], which is caused by the variation with pressure and equivalence ratio of the rate of CH production from $CH_2$ and OH. The maximum combustion pressure peaks at $\phi$ =1.05 and the $CO_2$ concentration peaks at $\phi$=0.95~1.0 while the CO concentration rises sharply at the condition of fuel-rich mixtures. This is caused by complete combustion at $\phi$=0.95.

• Journal of the Korean Ceramic Society
• /
• v.37 no.8
• /
• pp.817-823
• /
• 2000

A solid-state electrochemicall cell for sensing CO2 gas was fabricated using a solid electrolyte of Li2CO3-Li3PO4-Al2O3 mixture and a reference electrode of LiMn2O4. The e.m.f. (electromotive force) of sensor showed a good accordance with theoretical Nernst slope (n=2) for CO2 gas concentration range of 100-10000 ppm above 35$0^{\circ}C$. The e.m.f. of sensor was constant regardless of oxygen partial pressure at the high temperature above 0.1 atm. It was, however, a little depended on oxygen partial pressure as the pressure decreased below 0.1 atm. The oxygen-dependency of our sensor gradually disappeared as the operating temperature increased. The sensing behavior of our CO2 sensor was affected by the presence of water vapor, but its effect was small comparing with other sensors.

• Korean Chemical Engineering Research
• /
• v.48 no.3
• /
• pp.316-321
• /
• 2010

The $SO_2$ catalytic reduction was carried out under the condition of high pressure in this study. Sn-Zr based oxide and CO were used as the catalyst and reducing agent for the reduction of $SO_2$ to element sulfur, respectively. In order to compare the reactivity with the pressure on the catalytic process, the reactivity tests were performed under the conditions of atmospheric pressure and 20 atm. $SO_2$ conversion, the element sulfur yield and COS selectivity were also compared with changing the reaction temperature, $CO/SO_2$ mole ratio and the space velocity(GHSV). $SO_2$ conversion increased with increasing temperature and $CO/SO_2$ mole ratio under the condition of atmospheric pressure and element sulfur yield decreased due to the production of COS by the series reaction of CO and the produced sulfur. However, high $SO_2$ conversion and high element sulfur were obtained under the condition of 20 atm. It was concluded that COS decreased due to the condensation of the produced element sulfur under the condition of high pressure. Therefore, the high sulfur yield for $SO_2$ catalytic reduction could be profitably obtained under the condition of high pressure.

• Transactions of the Korean hydrogen and new energy society
• /
• v.18 no.2
• /
• pp.189-196
• /
• 2007

The evaporation heat transfer coefficient and pressure drop of $CO_2$(R-744) in a horizontal tube was investigated experimentally. The main components of the experimental apparatus are a receiver, a variable-speed pump, a mass flow meter, a pre-heater and an evaporator(test section). The test section consists of a horizontal stainless steel tube of 4.57 mm inner diameter. The experiments were conducted at mass flux of $200{\sim}1000\;kg/m^2s$ saturation temperature of $0{\sim}20^{\circ}C$, and heat flux of $10{\sim}40\;kW/m^2$. The test results showed that the heat transfer coefficient of $CO_2$ has a greater effect on nucleate boiling more than convective boiling. Mass flux of $CO_2$ does not affect nucleate boiling too much. In comparison with test data and existing correlations, All of the existing correlations for the heat transfer coefficient underestimated the experimental data. However lung et al.'s correlation showed a good agreement with the experimental data. The evaporation pressure drop of $CO_2$ increases with increasing mass flux and decreasing saturation temperature. When comparison between the experimental pressure drop and existing correlations. Existing correlations failed to predict the evaporation pressure drop of $CO_2$.

• Korean Journal of Food Science and Technology
• /
• v.29 no.6
• /
• pp.1119-1124
• /
• 1997

This study was carried out for improvement and correction of the traditional pressure variation method (PVM) in the respiration rate measurements of fresh fruits and vegetables using a microcomputer system and a differential pressure sensor. Water vapor pressure in the container was calculated by equations for psychrometric calculations. At the beginning of experimental period water vapor pressure in the container was increased and maintained constantly in the most experimental period, but was decreased dramatically after $CO_2$ scrubbing. The percentages of water vapor pressure on total differential pressure were $33{\sim}46%$ at $1^{\circ}C$, $23{\sim}45%$ at $11^{circ}C$ and $35{\sim}53%$ at $21^{\circ}C$. The differences between the respiration rates determined by gas chromatography and corrected pressure variation method (CPVM) were $0.2{\sim}0.3\;mgCO_2kg^{-1}h^{-1}$ at $1^{\circ}C$, $0.2{\sim}2.9\;mgCO_2kg^{-1}h^{-1}$ at $11^{\circ}C$ and 1.0{\sim}9.0\;mgCO_2kg^{-1}h^{-1}$ at $21^{circ}C$, while those between gas chromatography and normal pressure variation method (PVM) were $0.8{\sim}1.2\;mgCO_2kg^{-1}h^{-1}$ at $1^{\circ}C$, $3.9{\sim}11.0\;mgCO_2kg^{-1}h^{-1}$ at $11^{\circ}C$ and $8.0{\sim}32.0\;mgCO_2kg^{-1}h^{-1}$ at $21^{circ}C$, respectively. The differences of the respiration rates with CPVM were smaller than those with PVM. CPVM, therefore, were more exact and convenient method than PVM in the measurement of respiration rate of fresh produce.

• 기술발표회
• /
• s.2006
• /
• pp.311-319
• /
• 2006

Artesian Pressure exists in Hwa Jeon Project Site of Nakdong Delta Area. Maxium value of the pressure ranges between 06 tonf/m2 and 1 3 tonf/m2 in the design site. This paper presents a design case study considering the Artesian Pressure to calculate the consolidation settlement of the deep marine clay.

• Journal of Chest Surgery
• /
• v.29 no.7
• /
• pp.723-727
• /
• 1996

An adequate exposure is important in thoracoscopic procedures. The insufflation of $CO_2$has been demonstrated to aid in compressing lung parenchyma, and act as a retractor when combined with changes in patient's position. However, a recent study demonstrated that $CO_2$insufflation during thoracoscopy in the pig has adverse hemodynamic consequences. We prospectively studied 12 patients undergoing thoracoscopy to evaluate the effect of $CO_2$insufflation in the clinical setting. The mean arterial pressure, heart rate, central venous pressure, arterial oxygen saturation, and end-tidal $CO_2$pressure were monitored. Measurements were determined at baseline, at the initiation of one-lung ventilation, and at intrapleural pressure of 5, 10, 15 mmHg and following results were obtained. 1) The insufflation of 5 to 15 mmHg of $CO_2$had no significant effect on the mean arterial pressure, heart rate, arterial oxygen saturation. 2) The end-tidal $CO_2$pressure rose from 31.00$\pm$1.67 mmHg to 38.49$\pm$1.82 mmHg at an intrapleural pressure of 15 mmHg(p<0.05). 3) The central venous pressure rose from 7.75$\pm$0.76 mmHg to 12.83$\pm$1.64 mmHg and 16.16$\pm$l.97mmHg at an intrapleural pressure of 10 and 15 mmHg(p<0.05). 4) The low pressure (<10 mmHg) insufflation is a safe adjunct to the conduct of thoracoscopic surgical procedures.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.28 no.2
• /
• pp.429-437
• /
• 1999

A mathematical model was established for estimating changes in pressure and volume of permeable kimchi packages. The model comprises the CO2 gas production from kimchi and permeation of O2, CO2 and N2 through the permeable film or sheet. Using the developed model, the effects of various packaging variables on the pressure and volume changes were analyzed for rigid and flexible packag es of kimchi(3% salt content) at 15oC, and then effect of storage temperature was also looked into. In case of rigid pack of 400g, using the plastic sheet of high CO2 permeability and initial vacuumizing can help to relieve the problem of pressure build up. The lower fill weight can further reduce the pressure, but will result in higher packaging cost. For the flexible package of 3 kg, highly permeable films such as low density polyethylene(LDPE) and polypropylene can reduce the volume expansion. Higher ratio of CO2 permeability to O2 and N2 permeabilities are effective in reducing the volume expansion. Increased surface area cannot contribute to reduction of volume expansion for highly permeable flexible packages of kimchi. For the impermeable packages, pressure and volume at over ripening stage (acidity 1.0%) increase with decreased temperature, while those at optimum ripening stage(acidity 0.6%) change little with temperature. Pressure of permeable rigid LDPE package increases with tem perature at any ripening stage, and temperature affects the volume of flexible LDPE package very slightly. Experimental verification of the present results and package design with economical consid eration are needed as a next step for practical application.

• Journal of Soil and Groundwater Environment
• /
• v.21 no.6
• /
• pp.46-55
• /
• 2016

This experimental study was aimed to estimate interfacial tension of brine-$CO_2$ by using a pendant bubble method and image analysis. Measurements were performed for wide ranges of temperatures, pressures, and salinities covering reservoir conditions in Pohang basin, a possible candidate for $CO_2$ storage operation in Korea. The profiles of $CO_2$ bubbles in brine obtained from image analysis with the densities of brine and $CO_2$ from previous studies were applied to Laplace-Young equation for calculating interfacial twnsion in brine-$CO_2$ system. The experimental results reveals that the interfacial tension is significantly affected by reservoir conditions such as pressure, temperature and water salinity. For conditions of constant temperature and water salinity, the interfacial tension decreases as pressure increases for low pressures (P < $P_c$), and approaches to a constant value for high pressures. For conditions of constant pressure and water salinity, the interfacial tension increases as temperature increases for T < $T_c$, with an asymptotic trend towards a constant value for high temperatures. For conditions of constant pressure and temperature, the interfacial tension increases with increasing water salinity. The trends in changes of interfacial tension can be explained by the effects of the reservoir conditions on the density difference of brine and $CO_2$, and the solubility of $CO_2$ in brine. The information on interfacial tensions obtained from this research can be applied in predicting the migration and distribution of injecting and residual fluids in brine-$CO_2$-rock systems in deep geological environments during geological $CO_2$ sequestrations.

• Journal of the Korean institute of surface engineering
• /
• v.53 no.1
• /
• pp.22-28
• /
• 2020

In this study, manganese dioxide (MnO₂) nanoparticles were synthesized from KMnO₄ and MnCl₂·4H₂O without any dispersing agents and oxidant via ultra-high pressure homogenization process. We investigated various physicochemical properties and CO oxidation reactions of the MnO₂ nanoparticles as a function of the number of passes at 1,500 bar in a high pressure homogenizer nozzle. The observed X-ray diffraction patterns and scanning electron microscopy images revealed that the synthesized MnO₂ nanoparticles had a hexagonal structure and a uniform spherical shape. It was found from the Brunauer-Emmett-Teller measurements that the pore size of the MnO₂ nanoparticles ranged from 23.6 to 7.2 nm and their specific surface area ranged from 24 to 208 m²g^-1. In particular, it was confirmed from the measurements of CO conversion into CO₂ that CO oxidation reaction over the MnO₂ nanoparticles exhibited excellent catalytic activity at low temperatures below 100℃.