• Journal of environmental and Sanitary engineering
• /
• v.3 no.2 s.5
• /
• pp.43-60
• /
• 1988

This study was carried out to determine traffic noise level and analyze noise reduction effects of various sound protection facilities in the area of Seoul, Inch'on, Songchoo and Seoul- Busan Expressway from March to Octover, 1987. The results were as follows; 1. As compared with the environmental standards and the traffic noise level in heavy noise areas, traffic noise levels observed were shown in higher than environmental standards. The noise levels in Seoul were determined at 12.8-18.2 dB(A) in daytime and 19.0-26.9 dB (A) in nighttime. And incase of inch'on, it were 6.7-9.6 dB(A) in daytime, 7.9-18.9 dB(A) in nighttime, respectively. 2. The environmental noise level observed in the backside of protection facilities, such as apartment, soundproof barrier and houses, which were constructed in paralled to the road was lower about 3-5 dB(A) than perpendicular to theroad. Noise recuction effect of upper stairs in apartment was higher than lower stairs. 3. The predicted noise level obtained from the equation $({\triangle}L\;=\; -10\;log\;(^{I'1}/Ii)\;was\;\pm\;1dB$ (A) and the correlation coefficient (r) was 0.923. 4. The noise reduction effect in backside of apartment was measured at on sites and predicted by total noise loss equation. The predicted noise level was 60.9 dB(A) and the measured level was 60.6 dB(A), respectively. 5. The narrow width landscape less than 10m width was almost no effect for the protection of traffic noise. According to the synthesis of the above results, the noise level of the road was exceeding mostly the environmental standard in the heavy traffic areas. The counterplan should be set as well. The insulation of noise protection facilities were effective by the location with near distance from the road edge. The reduction effect of double window in apartment was represented so much. The prediction model could be applied to estimate the noise levels in the roadside as well as the effectiveness for the noise protection facilities.

• Applied Chemistry for Engineering
• /
• v.28 no.5
• /
• pp.587-592
• /
• 2017

Uniform and optimum sized silver nanoplates were synthesized through the liquid phase reduction method by using silver nitrate solution as a starting chemical, dimethylformmide (DMF) as a reducing solvent, and polyvinylpyrrolidone (PVP) as reducing and surfactant agents. Synthesized and also film samples were characterized by using SEM, TEM, UV-Vis-NIR spectroscopy, particle size analyzer (PSA), and XRD. Triangle nanoplates with the size of 100~200 nm were found from the sample synthesized at $70^{\circ}C$ for 72 h using silver nitrate, DMF and 26 wt% PVP. The sample could reflect near-infrared light because it showed the maximum absorbing peak at about 1,000 nm. When the content or particle size of silver nanoplates increased in coating solutions, the transmittance decreased and the reflectance increased in film samples.

• Journal of the Korea Fashion and Costume Design Association
• /
• v.16 no.4
• /
• pp.189-203
• /
• 2014

In this study, Creative motifs using face composition of Jogakbo and Knot Symbol were developed, and applied to traditional Baeja of Joseon Dynasty to develop design contents of traditional clothes. As for study method, 7 motifs of new formative image that integrates traditional beauty and contemporary sense were developed by applying Knot Symbols and face compositions of Jogakbo with the use of Adobe Illustrator CS6 and Adobe Photoshop CS6 vector graphic software. The motifs were designed in contemporary image in face compositions like rectangle pattern, triangle pattern, dual rectangle pattern, vertical and horizontal pattern, pinwheel pattern, gojunmun pattern and free pattern by involving various changes like repetition, rotation, reduction, expansion and decomposition and using the colors used in the Jogakbo. It is desired that through this study, traditional Baeja may develop to bear traditional and contemporary image so that our traditional clothes design may become global. Also it is anticipated that this study will contribute to development of culture products of Hanbok like Jeogori, pants and skirt that require change of design in the global era while maintaining traditional beauty to appeal to the emotions of world citizens.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.6 no.2
• /
• pp.816-825
• /
• 1964

1. Outline: The flow of the siphon spillway is very intricate and affected by vacuous condition. It is an intresting problem to make vacuum rapidly in_siphon, i.e, to provoke the perfect siphonaoge with the lowest water-level of overflow. The hydraulic experiments of siphon spillway have practiced at the Masan Lake, Haenam, the province of Junnam and gained rational and economical results which cannot be odtained by calculation. 2. Experiment: The model scale was a half of that of the prototype. 3. Results and discussion: In the experiments of 14 runs, washing, overflow water level, outlet, water level of cushion, phenomenon of water flying and water pressure of every part, etc. were studied. a) The relation of overflow water-level at siphon inlet and deflector When the elevation of the deflector is 10. 65m and the form of deflector O.4m long is the hypotenuse of an $45^{\circ}$ isosceles triangle, the over flow water-level is the minimum, i. e. the siphonage was excellent. There is no effect by the rising of overflow water-Ievel between 11.95m to 1O.65m of deflector elevation (in the first plan, it is 11.05m). But the overflow water-level rises remarkably in the outside region of the above limits. b) The relation of overflow water-level, the length of cushion and standard height of the base. The reduction of the length of cushion brings the rising of overflow waterlevel, and the rising of the standard height of the base brings the rising of overflow water level. For the long cushion length and low standard height of the base, it cannot be expeted to have the falling of overflow water-level. The most satisfactory data were obtained at 5.20m of the base standard height and 6.1m of the length of cushion. The first vah,le planned was 5.70 m and 4.30m.

• Wind and Structures
• /
• v.23 no.6
• /
• pp.615-639
• /
• 2016

Although the underlying mechanism of rain-wind induced vibrations (RWIVs) of stay cables has not been fully understood, some countermeasures have been successfully applied to mitigating this kind of vibration. Among these, installing dampers near the bridge deck was widely adopted, and several field observations have shown its effectiveness. In this study, the effectiveness of dampers to RWIVs of stay cables is numerically investigated comprehensively by means of finite difference method (FDM). Based on the free vibration analysis of a taut string, it is found that the 3-points triangle scheme, which can be easily implemented in FDM, can offer an excellent approximation of the concentrated damping coefficient (expressed as a Dirac delta function) at the location where the damper is installed. Then, free vibration analysis of a 3-D continuous stay cable attached with two dampers is carried out to study the relationship of modal damping ratio and damping coefficient of the dampers. The effects of orientation of the dampers and cable sag on the modal damping ratio are investigated in detail. Finally, the RWIV response of a 3-D continuous stay cable attached with two dampers is examined. The results indicate that 0.5% of damping ratio is sufficient to reduce the RWIV vibration of the Cable A20 on the No.2 Nanjing Bridge over Yangtze River.

• Journal of the Mineralogical Society of Korea
• /
• v.4 no.2
• /
• pp.99-107
• /
• 1991

Three fully dehydrated fully Rb+-exchanged zeolite A single crystals have been prepared by the reduction of all Na+ ions in dehydrated Na12-A by rubidium vapor at various experimental conditions (220 $\leq$ T $\leq$ 33$0^{\circ}C$, 2 $\leq$ t $\leq$24 hours, and 0.1 $\leq$ PRb $\leq$ 1.1 Torr). Their structures were determined by single-crystal X-ray diffraction methods in the space group {{{{ RHO }}m3m (a=12.245(3) A) at 22(1)$^{\circ}C$. In these structures 12.6(2) to 13.5(2) Rb species are found per unit cell, more than the 12 Rb+ ions needed to balance the anionic charge of the zeolite framework, indication that the sorption of Rb0 has occurred. In each structure, three Rb+ ions per unit cell are located at the centers of 8-rings. Beyond that, the fractional occupancies observed are simply explained by two unit cell arrangments. In one, two Rb+ ions are in the sodalite unit near opposite 6-rings, six are in the large cavity near 6-ring, and one is in the large cavity near a 4-ring. In the other, three Rb species in the sodalite cavity (forming a triangle 3.7 A on an edge) each bond (3.4 A) through a 6-ring to an Rb species in the large cavity to give an (Rb6)4+ cluster of symmetry 3m (C3V). Five additional Rb+ ions fill the remaining large-cavity 6-ring sites.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.22 no.4
• /
• pp.691-699
• /
• 2018

Astronomical positioning has been carried out from the past by using Sextant. The St. Hilaire method was mainly used by Nautical Almanac and Sight Reduction Tables For Marine Navigation. In modern times, it has been able to use the LOP(Line of Position) method smoothly by combining with IT technology. However, in comparison with the past method, the LOP method always shows two positions, True Position and False Position, which must be distinguished by the navigator. Therefore, in this paper, we proposed a method of using the azimuth to remove the false position generated by the LOP method. In particular, the theoretical considerations using azimuth are presented in various ways, and the validity of the theoretical considerations is confirmed. Simulations are presented to confirm that the theoretical basis of the thesis is valid.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.17 no.1
• /
• pp.591-596
• /
• 2016

Numerical analyses were performed on the heat flow characteristics of a heat transfer plate with six different shapes (basic, rectangle, triangle, wave type) to reduce the level of white smoke at a stack. In this study, to examine the heat transfer performance (heat transfer capacity, pressure drop, turbulence kinetic energy, heat transfer coefficient) on the heat transfer plates, simulations were conducted using the commercial computational fluid dynamics software, ANSYS CFX Ver.14 under uniform flow conditions. The thermal flow phenomenon in a channel with six heat transfer plates could be predicted adequately under uniform flow conditions. The heat transfer capacity, pressure drop, turbulence kinetic energy, and heat transfer coefficient were affected by the flow rate, aspect ratio and plate shape. These results provide guidelines to design an effective heat exchanger with the wave type to reduce white smoke.

• Tribology and Lubricants
• /
• v.32 no.3
• /
• pp.101-105
• /
• 2016

Trap effect of groove is evaluated in a lubricating system using computational fluid dynamics (CFD) analysis. The simulation is based on the standard k-ε turbulence model and the discrete phase model (DPM) using a commercial CFD code FLUENT. The simulation results are also capable of showing the particle trajectories in flow field. Computational domain is meshed using the GAMBIT pre-processor. The various grooves are applied in order to improve lubrication characteristics such as reduction of friction loss, increase in load carrying capacity, and trapping of the wear particles. Trap effect of groove is investigated with variations in cross-sectional shape and Reynolds number in this research. Various cross-sectional shapes of groove (rectangular, triangle, U shaped, trapezoid, elliptical shapes) are considered to evaluate the trap effect in simplified two-dimensional sliding bearing. The particles are assumed to steel, and defined a single particle injection condition in various positions. The “reflect” boundary condition for discrete phase is applied to the wall boundary, and the “escape” boundary condition to “pressure inlet” and “pressure outlet” conditions. The streamlines are compared with particles trajectories in the groove. From the results of numerical analysis in the study, it is found that the cross-sectional shapes favorable to the creation of vortex and small eddy current are effective in terms of particle trapping effect. Moreover, it is found that the Reynolds number has a strong influence on the pattern of vortex or small eddy current in the groove, and that the pattern of the vortex or small eddy current affects the trap effect of the groove.

• Korean Journal of Remote Sensing
• /
• v.22 no.1
• /
• pp.49-61
• /
• 2006

The lifting scheme has been found to be a flexible method for constructing scalar wavelets with desirable properties. In this paper, it is extended to the UDAR data compression. A newly developed data compression approach to approximate the UDAR surface with a series of non-overlapping triangles has been presented. Generally a Triangulated Irregular Networks (TIN) are the most common form of digital surface model that consists of elevation values with x, y coordinates that make up triangles. But over the years the TIN data representation has become an important research topic for many researchers due its large data size. Compression of TIN is needed for efficient management of large data and good surface visualization. This approach covers following steps: First, by using a Delaunay triangulation, an efficient algorithm is developed to generate TIN, which forms the terrain from an arbitrary set of data. A new interpolation wavelet filter for TIN has been applied in two steps, namely splitting and elevation. In the splitting step, a triangle has been divided into several sub-triangles and the elevation step has been used to 'modify' the point values (point coordinates for geometry) after the splitting. Then, this data set is compressed at the desired locations by using second generation wavelets. The quality of geographical surface representation after using proposed technique is compared with the original UDAR data. The results show that this method can be used for significant reduction of data set.