• Smart Structures and Systems
• /
• v.24 no.2
• /
• pp.173-182
• /
• 2019

Due to the degradation of beamforming properties at angles close to $0^{\circ}$ to $180^{\circ}$, linear array does not have a complete $180^{\circ}$ inspection range but a smaller one. This paper develops a improved sensor array with two additional sensors above and below the linear sensor array, and presents time difference and two dimensional multiple signal classification (2D-MUSIC) based impact localization for omni-directional localization on composite structures. Firstly, the arrival times of impact signal observed by two additional sensors are determined using the wavelet transform and compared, and the direction range of impact source can be decided in general, $0^{\circ}$ to $180^{\circ}$ or $180^{\circ}$ to $360^{\circ}$. And then, 2D-MUSIC based spatial spectrum formula using uniform linear array is applied for locate accurate position of impact source. When the arrival time of impact signal observed by two additional sensors is equal, the direction of impact source can be located at $0^{\circ}$ or $180^{\circ}$ by comparing the first and last sensor of linear array. And then the distance is estimated by time difference algorithm. To verify the proposed approach, it is applied to a quasi-isotropic epoxy laminate plate and a stiffened composite panel. The results are in good agreement with the actual impact occurring position.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.30 no.9
• /
• pp.546-550
• /
• 2017

Ferroelectric properties are governed by domain structures and domain wall motions, so it is of significance to understand domain evolution processes under mechanical stress. In the present study, in situ piezoresponse force microscopy (PFM) observation under compressive stress was carried out for a near-morphotropic PZT. Both $180^{\circ}$ and $non-180^{\circ}$ domain structures were observed from PFM images, and their habit planes were identified using electron backscatter diffraction in conjunction with PFM data. By externally applied mechanical stress, needle-like $non-180^{\circ}$ domain patterns were broadened via domain wall motions. This was interpreted via phenomenological approach such that the total energy minimization can be achieved by domain wall motion rather than domain nucleation mainly due to the local gradient energy. Meanwhile, no motion was observed from curvy $180^{\circ}$ domain walls under the mechanical stress, validating that $180^{\circ}$ domain walls are not directly influenced by mechanical stress.

• Journal of the Korean Ceramic Society
• /
• v.37 no.9
• /
• pp.871-878
• /
• 2000

본 연구는 3mol% Pb(Sb$_{1}$2/Nb$_{1}$2/)O$_3$가 첨가된 상경계 영역의 Pb(Zr,Ti)O$_3$(PSN-PZT) 세라믹스에 대하여 RT66A와 광섬유센서를 이용하여, 교류강전계 하에서 압전 및 유전특성을 조사하였다. PSN-PZT 세라믹스의 압전 및 유전 특성에 미치는 non-180$^{\circ}$분역 재배열의 영향을 평가하기 위하여 RT66A와 MTI-2000 Fotonic$^{TM}$ sensor를 이용하여 인가전계와 주파수의 함수로 전계유기변위를 측정하였다. 그 결과, 교류강전계 하에서 전계유기변위는 강전계, 저주파수에서 큰 이력현상을 나타내고, 전계유기변위로부터 결정된 유효압전상수는 주파수가 감소할수록 증가하는 거동을 나타내고 있으며, 이러한 거동은 non-180$^{\circ}$분역 재배열의 영향으로 해석되었다.

• Journal of The Korean Radiological Technologist Association
• /
• v.29 no.1
• /
• pp.67-71
• /
• 2003

Purpose : 201Tl Myocardium SPECT Test uses $180^{\circ}$ reorganization due to the energy diffusion decrease by backbone and muscles, but $^{99m}Tc$-Tetrofosmin Myocardium SPECT Test can get more information by $360^{\circ}$

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.31A no.6
• /
• pp.18-25
• /
• 1994

If a 4-port network is terminated by arbitrary impedances, there are great advantageges in composing systems with it. The distributed 3-dB $O^{\circ}$/180$^{\circ}$ hybrid with the impedances asymmetrically terminated is presented. In the band of UHF and VHF. on the basis of it , the new design method of small sized- hybrid using both lumped and distributed elements is also presented and analyzed At the center frequency of 900MHz. 3-dB $O^{\circ}$/180$^{\circ}$hybrid on the RT/Duroid substrate of ${\varepsilon}_{r}$=2.2, h=0.76mm is design and tested. Agreements are obtained between measured and theoretical results and at the same time the occupied area of it is reduced more than 70% compared with only distributed-type circuits.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.4
• /
• pp.401-412
• /
• 2003

In this paper, a broadband phase shifter structure using a new switched network was proposed. A new reference network is composed of coupled lines and 45$^{\circ}$open and short stubs, which are shunted at the edge points of a main line, respectively, A delay network is composed of only a standard transmission line. It is possible to design a broadband 180$^{\circ}$phase shifter that phase dispersive characteristics by an impedance ratio R of coupled lines and greater phase dispersive characteristics by characteristic impedances Zm, Zs of a main line and stubs are used together. By considering a structure symmetry, the even and odd mode analysis was performed to obtain theoretical S-parameters of the proposed phase shifter. Also, through computer simulation on the basis of derived equations, design graphs were presented to optimally design a 180$^{\circ}$broadband phase shifter. Design graphs provide the values of characteristic impedances Zm, Zs, and I/O match and phase bandwidths. To verify electrical performances of the broadband phase shifter proposed in this paper, low different 180$^{\circ}$phase shifters, operated at the center frequency 3 GHz were designed and fabricated using design graphs, and were experimented. One of them was designed as a standard Schiffman structure to compare with electrical performances. Measured results of each phase shifter to satisfy simultaneously design conditions of I/O match （VSWR=1.15:1) and maximum phase deviation $({\varepsilon}_{{\Delta}{\phi}}＝{\pm}2^{\circ})$ were well in agreement with corresponding simulation results over impedance match and phase error bandwidths, and showed broadband characteristics.

• Membrane Journal
• /
• v.29 no.1
• /
• pp.18-29
• /
• 2019

The dead-end ultrafiltration (UF) of BSA protein solution was performed to investigate the defouling effects of natural convection instability flow (NCIF) induced in membrane module. The permeate fluxes were measured according to the inclined angles ($0{\sim}180^{\circ}$) of membrane module with respect to gravity, and analyzed using the blocking filtration model. NCIF are more induced as the inclined angles increased from $0^{\circ}$ to $180^{\circ}$, and the induced NCIF enhances flux. Comparing the fluxes at $0^{\circ}$ inclined angle (no NCIF induction) and $180^{\circ}$ (maximum NCIF induction), the flux enhancements by NCIF induction are increased about 5 times in the short-term UF operation (2 hours) and about 17 times in the long-term operation (20 hours). As applying the blocking filtration model, it is more suitable to analyze the flux results by using the intermediate blocking model in the early times of UF operation within 15 minutes and then thereafter times by using the cake filtration model. NCIF induced at $180^{\circ}$ inclined angle reduces the intermediate blocking fouling at about 67% in the early times operation and thereafter the cake layer fouling at about 99.9%. The main defouling mechanism of NCIF induced in the membrane module is suppress the formation of protein cake layer.

• Korean Journal of Food Science and Technology
• /
• v.29 no.5
• /
• pp.860-868
• /
• 1997

The effects of oil unsaponifiables (8 species) and methanolic plant extracts (53 species) on the thermal oxidation of oils during 14 or 16 hour heating at $180^{\circ}C$ were studied by analyzing the fatty acid composition of soybean oil or cottonseed oil. All the unsaponifiables tested did not show any antioxidative activities on the thermal oxidation of soybean oil. However, among the 53 species of methanolic plant extracts, some species (Rheum undulatum L., Chelidonium majus L. var. asiaticum and Eugennia caryopyllata T.) showed very strong antioxidative activities on the thermal oxidation of cottonseed oil. The antioxidative activities of methanolic extracts of these 3 species on thermal oxidation of cottonseed oil during an extended heating period were also studied by heating cottonseed oils for 7 hours a day for 8 days at $180^{\circ}C$. The methanolic extracts of Chelidonium majus L. v. asiaticum and Eugennia caryopyllata T. greatly reduced both polymer formation and linoleic acid decomposition after the 8 day heating at $180^{\circ}C$. However, the methanolic extracts of Rheum undulatum L. was effective for the reduction of polymer formation, but not for the reduction of linoleic acid decomposition.

• Journal of the Korean Wood Science and Technology
• /
• v.43 no.4
• /
• pp.438-445
• /
• 2015

Among several thermal wood modification methods German oil heating technology was applied to Korean pine specimens by heat treatment at $180^{\circ}C$ and $200^{\circ}C$. In addition the matched specimens were heat-treated by Thermowood method. The heat-treated specimens were planed and their colors were measured with a colorimeter at 1 mm and 4 mm below the surfaces. The average lightness index (L*) of Oil-180 specimens was the largest followed by Oil-200 and Tmo-200 specimens. The average redness indexes (a*) of all specimens were increased by heat treatment, while the average yellowness indexes (b*) were variable. The average color differences (${\Delta}E*$) of Oil-200 and Tmo-200 specimens were above 30.0, while that of Oil-180 specimens was only 18.4. It can be concluded that the colors of the heat-teated specimens were uniformly changed because their average color difference indexes (${\Delta}E*$) between the inner layers were below 6.0.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.36 no.3
• /
• pp.262-268
• /
• 2007

This study was conducted to investigate various physiochemical activities of carrageenan hydrolysates obtained with organic acid treatments. The hydrolysates treated with citrate and malate at $100^{\circ}C,\;110^{\circ}C\;and\;120^{\circ}C$ had antimicrobial activities against Bacillus cereus and Bacillus subtilis. Especially, the hydrolysates with malate at $120^{\circ}C$ for 180 min treatment had the strongest antimicrobial activity to Bacillus subtilis. Regardless of the hydrolysis conditions, inhibition ratios of tyrosinase activity by citrate and malate under $100{\sim}120^{\circ}C$ were over 97%. Especially, the inhibition ratios for tyrosinase activity of the hydrolysates obtained with citrate at $100^{\circ}C$ for 180 min and at $120^{\circ}C$ for 90 min were 99.4% and 98.2%, respectively. Also, the inhibition ratios for tyrosinase activity of the hydrolysates obtained with malate under the same conditions were about 99.5% and 99.3%, respectively. The APTT as anticoagulant activity of carrageenan hydrolysates with 0.3% malate and citrate at $80^{\circ}C$ for 180 min were $2,451{\pm}18(sec)\;and\;1,617{\pm}15(sec)$, respectively.