Acknowledgement
This work was supported by the national science and technology major project of advanced technology research on structural health inspection and evaluation of NPPs (Grant No. 2018ZX06002008), and national key project of research on earthquake emergency disposal technology of NPPs (Grant No. 2017YFC1500804). This financial support is gratefully acknowledged.
References
- A.A. Markou, G. Stefanou, G.D. Manolis, Stochastic response of structures with hybrid base isolation systems, Eng. Struct. 172 (2018) 629-643. https://doi.org/10.1016/j.engstruct.2018.06.051
- D. De Domenico, E. Gandelli, V. Quaglini, Effective base isolation combining low-friction curved surface sliders and hysteretic gap dampers, Soil Dynam. Earthq. Eng. 130 (2020) 105989. https://doi.org/10.1016/j.soildyn.2019.105989
- A. De Luca, L.G. Guidi, Base isolation issues in Italy: integrated architectural and structural designs, Soil Dynam. Earthq. Eng. 130 (2020) 105912. https://doi.org/10.1016/j.soildyn.2019.105912
- A. De Luca, L.G. Guidi, State of art in the worldwide evolution of base isolation design, Soil Dynam. Earthq. Eng. 125 (2019) 105722. https://doi.org/10.1016/j.soildyn.2019.105722
- R. Lo Frano, G. Forasassi, Isolation systems influence in the seismic loading propagation analysis applied to an innovative near term reactor, Nucl. Eng. Des. 240 (2010) 3539-3549. https://doi.org/10.1016/j.nucengdes.2010.07.023
- A.S. Whittaker, M. Kumar, Seismic isolation of nuclear power plants, Nuclear Engineering and Technology 46 (2014) 569-580. https://doi.org/10.5516/NET.09.2014.715
- A.S. Whittaker, P. Sollogoub, M.K. Kim, Seismic isolation of nuclear power plants: past, present and future, Nucl. Eng. Des. 338 (2018) 290-299. https://doi.org/10.1016/j.nucengdes.2018.07.025
- Ch Coladant, Seismic isolation of nuclear power plants-EDF's philosophy[J], Nucl. Eng. Des. 127 (1991) 243-251. https://doi.org/10.1016/0029-5493(91)90048-M
- R. Lo Frano, Benefits of seismic isolation for nuclear structures subjected to severe earthquake, Science and Technology of Nuclear Installations (2018) 1-11. Article ID 8017394,page.
- K.L. Ryan, S. Soroushian, E.M. Maragakis, E. Sato, T. Sasaki, T. Okazaki, Seismic simulation of an integrated ceiling-partition wall-piping system at E-Defense. I: three-dimensional structural response and base isolation, J. Struct. Eng. 142 (2016), 04015130. https://doi.org/10.1061/(ASCE)ST.1943-541X.0001384
- A.J. Papazoglou, A.S. Elnashai, Analytical and field evidence of the damaging effect of vertical earthquake ground motion, Earthq. Eng. Struct. Dynam. 25 (1996) 1109-1137. https://doi.org/10.1002/(SICI)1096-9845(199610)25:10<1109::AID-EQE604>3.0.CO;2-0
- Y. Bozorgnia, M. Niazi, K.W. Compbell, Characteristics of free-field vertical ground motion during the Northridge Earthquake, Earthq. Spectra 11 (4) (1995) 515-525. https://doi.org/10.1193/1.1585825
- J. Xie, Z. Wen, Characteristics of near-fault vertical and horizontal ground motion from the 2008 Wenchuan earthquake, Chin. J. Geophys. 53 (8) (2010) 1796-1805. https://doi.org/10.3969/j.issn.0001-5733.2010.08.005
- J. Suhara, R. Matsumoto, S. Oguri, Y. Okada, K. Inoue, K. Takahashi, 3-D seismic isolation device with rolling seal type air spring, in: 18th International Conference on Structural Mechanics in Reactor Technology (SMiRT18), SMiRT18, Beijing, China, 2005, pp. 3381-3391.
- M. Morishita, K. Inoue, T. Fujita, Development of three-dimensional seismic solation systems for fast reactor application, Journal of Japan Association for Earthquake Engineering 4 (2004) 305-310. https://doi.org/10.5610/jaee.4.3_305
- J. Suhara, T. Tamura, Y. Okada, K. Umeki, Development of three dimensional seismic isolation device with laminated rubber bearing and rolling seal type air spring, in: ASME 2002 Pressure Vessels and Piping Conference, vol. 2, American Society of Mechanical Engineer, Vancouver, BC, Canada, 2002, pp. 43-48.
- A. Kashiwazaki, T. Shimada, T. Fujiwaka, S. Moro, Study on 3-dimensional base isolation system applying to new type power plant reactor, in: Transaction of the 17th International Conference on Structural Mechanics in Reactor Technology (SMiRT 17), vol. 2, SMiRT17, Prague, Czech Republic, 2003.
- S. Kitamura, S. Okamura, K. Takahashi, Experimental study on vertical component seismic isolation system with coned disk spring, in: Proceedings of the ASME Pressure Vessels and Piping Conference-Seismic Engineering, 2005, pp. 175-181. Denver, Colorado, USA.
- S. Kitamura, M. Morishita, Study on vertical component seismic isolation system with coned disk spring, in: Pressure Vessels and Piping Division, San Diego, California, USA, 2004, pp. 21-28.
- M. Morishita, S. Kitamura, S. Moro, Y. Kamishima, S. Takahiro, Study on 3-dimensional seismic isolation system for next generation nuclear power plant-vertical component isolation system with coned disk spring, Technical Report No. 620, in: Proceedings, 13th World Conference on Earthquake Engineering, 2004. Vancouver, BC, Canada.
- S. Okamura, Y. Kamishima, K. Negishi, Y. Sakamoto, S. Kitamura, S. Kotake, Seismic isolation design for JSFR, J. Nucl. Sci. Technol. 48 (2011) 688-692. https://doi.org/10.3327/jnst.48.688
- A. Matsuda, S. Yabana, Evaluation for mechanical properties of laminated rubber bearings using finite element analysis, J. Pressure Vessel Technol. 126 (1) (2004) 134-140. https://doi.org/10.1115/1.1636784
- F. Naeim, J.M. Kelly, Design of Seismic Isolated Structures: from Theory to Practice, John Wiley & Sons Inc, 1999.
- W. Witarto, S.J. Wang, C.Y. Yang, J. Wang, Y.L. Mo, K.C. Chang, Yu Tang, Three-dimensional periodic materials as seismic base isolator for nuclear infrastructure, AIP Adv. 9 (4) (2019), 045014. https://doi.org/10.1063/1.5088609
- Y.L. Mo, W. Witarto, K.-C. Chang, S.-J. Wang, Y. Tang, R.P. Kassawara, Periodic material-based three-dimensional (3D) seismic base isolators for small modular reactors, in: Concrete Structure in Earthquake, 2019, pp. 1-16. Singapore.
- Z. Zhou, J. Wong, S. Mahin, Potentiality of using vertical and three-dimensional isolation systems in nuclear structures, Nuclear Engineering and Technology 48 (5) (2016) 1237-1251. https://doi.org/10.1016/j.net.2016.03.005
- J.O. Almen, A. Laszlo, The Uniform-Section Disc Spring vol. 58, Transactions of American Society of Mechanical Engineers, 1936, pp. 305-314. RP-58-10.
- China National Standardization Management Committee, Disc spring (2005) (GB/T1972-2005).
- Y. Zhao, J. Su, X. Zhou, Y. Sui, Design and performance test of combined disk spring bearing for vertical-isolated buildings, J. Beijing Univ. Technol. 35 (7) (2009) 892-898.
- Westinghouse Electric Corporation, AP1000 design control document, Rev. 19 (2011).
- RG 1.60, Rev.1, Design Response Spectra for Seismic Design of Nuclear Power Plants, U.S. Nuclear Regulatory Commission, 1973.
- RG 1.92, Rev.2, Combining Modal Responses and Spatial Components in Seismic Response Analysis, U.S. Nuclear Regulatory Commission, 2006.