DOI QR코드

DOI QR Code

Additional power conservation in 200W power plant with the application of high thermal profiled cooling liquid & improved deep learning based maximum power point tracking algorithm

  • Raj G. Chauhan (Department of Electrical Engineering, Madhav Institute of Technology and Science) ;
  • Saurabh K. Rajput (Department of Electrical Engineering, Madhav Institute of Technology and Science) ;
  • Himmat Singh (Department of Electrical Engineering, Madhav Institute of Technology and Science)
  • 투고 : 2021.08.11
  • 심사 : 2022.09.09
  • 발행 : 2022.09.25

초록

This research work focuses to design and simulate a 200W solar power system with electrical power conservation scheme as well as thermal power conservation modeling to improve power extraction from solar power plant. Many researchers have been already designed and developed different methods to extract maximum power while there were very researches are available on improving solar power thermally and mechanically. Thermal parameters are also important while discussing about maximizing power extraction of any power plant. A specific type of coolant which have very high boiling point is proposed to be use at the bottom surface of solar panel to reduce the temperature of panel in summer. A comparison between different maximum power point tracking (MPPT) technique and proposed MPPT technique is performed. Using this proposed Thermo-electrical MPPT (TE-MPPT) with Deep Learning Algorithm model 40% power is conserved as compared to traditional solar power system models.

키워드

과제정보

We thank Er. Arun Kumar Yadav (Researcher at Sapro Electronics & Electricals Ind. Pvt. Ltd.) for his assistance in EGW coolant data analysis and basic designing concepts of deep learning architecture in simulink.

참고문헌

  1. Arora, A. and Gaur, P. (2015), "Comparison of ann and anfis based mppt controller for grid connected pv systems", Proceedings of the Annual IEEE India Conference (INDICON), New Delhi, India, December.
  2. Bashir, M.A., Ali, H.M., Ali, M., Khalil, S. and Siddiqui, A.M. (2014), "Comparison of performance measurements of photovoltaic modules during winter months in Taxila, Pakistan", Int. J. Photoenergy, https://doi.org/10.1155/2014/898414.
  3. Bashir, M.A., Ali, H.M., Amber, K.P., Bashir, M.W., Hassan, A., Imran, S. and Sajid, M. (2018), "Performance investigation of photovoltaic modules by back surface water cooling", Therm. Sci., 22(6), 2401-2411. https://doi.org/ 10.2298/TSCI160215290B.
  4. Chatterji, S., Shimi, S.L. and Kumar, A. (2014), "Fuzzy adaptive proportional-integral-derivative controller with dynamic setpoint adjustment for maximum power point tracking in solar photovoltaic system", Syst. Sci. Control Eng., 2(1) 562-582. http://doi.org/10.1080/21642583.2014.956267.
  5. Choudhary, D. and Saxena, A.R. (2014), "Incremental conductance MPPT algorithm for PV system implemented using DC-DC buck and boost converter", Int. J. Eng. Res. Appl., 4(8).
  6. Du, D., Darkwa, J. and Kokogiannakis, G. (2013), "Thermal management systems for photo voltaic (PV) installations: a critical review", Solar Energ., 97, 238-254. https://doi.org/10.1016/j.solener.2013.08.018.
  7. Gonzalez-Longatt, F.M. (2005), "Model of photovoltaic module in matlabTM", Proceedings of the 2nd Conference of American Electrical, Electronic and Computer Engineering Students, USA.
  8. Hasanuzzaman, M., Malek, A.B.M.A., Islam, M.M., Pandey, A.K. and Rahim, N.A. (2016), "Global advancement of cooling technologies for P.V. systems: a review", Solar Energ., 137, 25-45. https://doi.org/10.1016/j.solener.2016.07.010.
  9. Hussein, S.N. (2016), "Comparison between perturb & observe, incremental conductance and fuzzy logic mppt techniques at different weather conditions", Int. J. Innov. Res. Sci. Eng. Technol., 5(7), 12556-12569. https://doi.org/10.15680/ijirset.2016.0507069.
  10. Khan, A., Ali, H.M., Nazir, R., Ali, R., Munir, A., Ahmad, B. and Ahmad, Z. (2019), "Experimental investigation of enhanced heat transfer of a car radiator using ZnO nano particles in H2O-ethylene glycol mixture", J. Therm. Anal. Calorimetry, 138(5), 3007-3021. http://doi.org/10.1007/s10973-019-08320-7.
  11. Koteswararao, B., Radha, K., Vijay, P. and Raja N. (2016), "Experimental analysis of solar panel efficiency with different modes of cooling", Int. J. Eng. Technol., 8(3), 1451-1456.
  12. Lin, C., Saunders, J. and Watkins, S. (2000), "The effect of changes in ambient and coolant radiator inlet temperatures and coolant flowrate on specific dissipation", Proceedings of the SAE 2000 World Congress, Detroit, Michigan, USA, March. http://doi.org/10.4271/2000-01-0579.
  13. Mohapatra, S.C. (2006), An Overview of Liquid Coolants for Electronics Cooling, Electronics Cooling, May.
  14. Narendiran, S. and Sahoo, S.K. (2014), "Modelling and simulation of solar photovoltaic cell for different insolation values based on matlab/simulink environment", Appl. Mech. Mater., 550, 137-143. https://doi.org/10.4028/www.scientific.net/amm.550.137.
  15. Narendiran, S., Sahoo, S.K. and Das, R. and Sahoo, A.K. (2016), "Fuzzy logic controller based maximum power point tracking for pv system", Proceedings of the 3rd International Conference on Electrical Energy Systems (ICEES), Chennai, India, March.
  16. Nema, S., Nema, R.K. and Agnihotri, G. (2010), "MATLAB/simulink based study of photovoltaic cells / modules / array and their experimental verification", Int. J. Energ. Environ., 1(3), 487-500.
  17. Ramesh, T., Saravanan, R. and Sekar S. (2018), "Analysis of ANFIS MPPT controllers for partially shaded stand alone photovoltaic system with multilevel inverter", Int. J. Robot. Autom., 7(2), 140-148. http://doi.org/10.11591/ijra.v7i2.
  18. Salman, S., Ai, X. and Zhouyang, Wu, Z. (2018), "Design of a P-&-O algorithm based MPPT charge controller for a stand-alone 200W PV system", Protection and Control of Modern Power Systems, 3(1). https://doi.org/10.1186/s41601-018-0099-8.
  19. Shankara, R.P., Banapurmath, N.R. and D'Souza, A. (2022), "An insight into the performance of radiator system using ethylene glycol-water based graphene oxide nanofluids", Alexandria Eng. J., 61(7), 5155-5167. https://doi.org/10.1016/j.aej.2021.10.037.
  20. Tsai, H.L., Tu, C.S. and Su, Y.J. (2008), "Development of generalized photovoltaic model using matlab/simulink", Proceedings of the World Congress on Engineering and Computer Science WCECS, San Francisco, USA, October.
  21. Wang, P., Kosinski, J.J., Anderko, A., Springer, R.D., Lencka, M.M. and Liu, J. (2013), "Ethylene glycol and its mixtures with water and electrolytes: Thermodynamic and transport properties", Am. Chem. Soc., 52, 15968-15987, https://doi.org/10.1021/ie4019353.
  22. Wilson, J. (2009), "Antifreeze Coolants, February.