DOI QR코드

DOI QR Code

Investigation on compression properties of seawater-sea sand concrete

  • Chen, Zongping (College of Civil Engineering and Architecture, Guangxi University) ;
  • Mo, Linlin (College of Civil Engineering and Architecture, Guangxi University) ;
  • Song, Chunmei (College of Civil Engineering and Architecture, Guangxi University) ;
  • Zhang, Yaqi (College of Civil Engineering and Architecture, Guangxi University)
  • 투고 : 2021.03.06
  • 심사 : 2021.06.21
  • 발행 : 2021.08.25

초록

This paper introduces the experimental results of the influence of sea sand replacement rate and mixing water on the basic mechanical properties of sea sand concrete. A total of thirty test blocks were designed for uniaxial compression test. In this test two parameters were considered: (a) sea sand replacement ratio (i.e., 0%, 25%, 50%,75%, 100%); (b) water for mixing (i.e., freshwater, seawater). The entire stress-strain curve of sea sand concrete under uniaxial compression was obtained. Based on the test results, the influence of sea sand replacement rate and mixing water on the peak stress, peak strain, and deformation performance of sea sand concrete were analyzed. Test results showed that the stress-strain curves of seawater sea sand concrete were steeper than that of ordinary concrete, which indicated that seawater sea sand concrete was slightly more brittle. On the whole, the sea sand replacement rate had no significant effect on the axial compressive properties of sea sand concrete. Under the same sea sand replacement rate, the deformation performance of freshwater sea sand concrete (FSC) was slightly greater than that of seawater sea sand concrete (SSC). Seawater had an enhanced effect on the early strength development of sea sand concrete.

키워드

과제정보

This research report was financially supported by the National Natural Science Foundation of China (No. 51578163), Bagui Scholars Special Funding Project ([2019] No. 79) and the Science and Technology Base and Talent Special Project of Guangxi (No. AD21075031). The authors are very grateful for the support of the above project funds.

참고문헌

  1. Ayinde, O.O., Zuo, X.B. and Yin, G.J. (2019), "Numerical analysis of concrete degradation due to chloride-induced steel corrosion", Adv. Concrete Constr., 7(4), 203-210. http://doi.org/10.12989/acc.2019.7.4.203.
  2. Belkacem, B., Madani, B., Khadra. B. and Michele, Q. (2014), "Effect of the type of sand on the fracture and mechanical properties of sand concrete", Adv. Concrete Constr., 2(1), 13-27. http://doi.org/10.12989/acc.2014.2.1.013.
  3. Cagatay, I.H. (2004), "Experimental evaluation of buildings damaged in recent earthquakes in Turkey", Eng. Fail. Anal., 12(3), 440-452. https://doi.org/10.1016/j.engfailanal.2004.02.007.
  4. Chapman, G.P. and Roeder, A.R. (1970), "The effect of sea shells in concrete aggregates", Concrete, 4(2), 71-79.
  5. Deepankar, K.A., Bhupinder, S. and Surender, K.V. (2016), "The effect of attack of chloride and sulphate on ground granulated blast furnace slag concrete", Adv. Concrete Constr., 4(2), 107-121. http://doi.org/10.12989/acc.2016.4.2.107.
  6. Dias, W.P.S., Seneviratne, G.A.P.S.N. and Nanayakkara, S.M.A. (2007), "Offshore sand for reinforced concrete", Constr. Build. Mater., 22(7), 1377-1384. https://doi.org/10.1016/j.conbuildmat.2007.04.006.
  7. Etxeberria, M., Fernandez, J.M. and Limeira, J. (2016), "Secondary aggregates and seawater employment for sustainable concrete dyke blocks production: Case study", Constr. Build. Mater., 133, 586-595. https://doi.org/10.1016/j.conbuildmat.2016.03.097.
  8. Ghorab, H.Y., Hilal, M.S. and Antar, A. (1990), "Effect of mixing and curing waters on the behavior of cement pastes and concrete part II: properties of cement paste and concrete", Cement Concrete Res., 20(1), 69-72. https://doi.org/10.1016/0008-8846(90)90117-G.
  9. Guo, Z.H. (2013), Principles of Reinforced Concrete, Tsinghua University Press, Beijing, China.
  10. Islam, M.M., Islam, M.S. and Al-Amin, M. (2012), "Suitability of sea water on curing and compressive strength of structural concrete", J. Civil Eng., 40(1), 37-45.
  11. Karthikeyan, M. and Nagarajan, V. (2017), "Chloride analysis of sea sand for making concrete", Nat. Acad. Sci. Lett., 40(1), 29-31. https://doi.org/10.1007/s40009-016-0493-6.
  12. Li, D.W., Wei, R., Li, L., Guan, X.T. and Mi, X.M. (2019), "Pitting corrosion of reinforcing steel bars in chloride contaminated concrete", Constr. Build. Mater., 199, 359-368. https://doi.org/10.1016/j.conbuildmat.2018.12.003.
  13. Limeira, J., Agullo, L. and Etxeberria, M. (2012), "Dredged marine sand as a new source for construction materials", Mater. Constr., 62(305), 7-24. https://doi.org/10.3989/mc.2011.61710.
  14. Liu, W., Pu, Z.L., Sun, H.F., He, Z.M. and Xing, F. (2016), "Influence factors of chloride content in dredged marine sand", J. Build. Mater., 19(5), 921-926. https://doi.org/10.3969/j.issn.1007-9629.2016.05.023.
  15. Liu, W., Xie, Y.J., Dong, B.Q. and Xing, F. (2014), "Study on characteristics of dredged marine sand and the mechanical properties of concrete made with dredged marine Sand", Bull. Chin. Ceram. Soc., 33(1), 15-22. https://doi.org/10.16552/j.cnki.issn1001-1625.2014.01.006.
  16. Ma, H.Y., Da, B., Yu, H.F. and Wu, Z.Y. (2018), "Research on flexural behavior of coral aggregate reinforced concrete beams", China Ocean Eng., 32(5), 593-604. https://doi.org/10.1007/s13344-018-0061-6.
  17. Mohammed, T.U., Hamada, H. and Yamaji, T. (2004), "Performance of seawater-mixed concrete in the tidal environment", Cement Concrete Res., 34(4), 593-601. https://doi.org/10.1016/j.cemconres.2003.09.020.
  18. Safi, B., Saidi, M., Daoui, A., Bellal, A., Mechekak, A. and Toumi, K. (2015), "The use of seashells as a fine aggregate (by sand substitution) in self-compacting mortar (SCM)", Constr. Build. Mater., 78, 430-438. https://doi.org/10.1016/j.conbuildmat.2015.01.009.
  19. Sajal, K.P., Subrata, C. and Sudhirkumar, V.B. (2014), "Chloride diffusion study in different types of concrete using finite element method (FEM)", Adv. Concrete Constr., 2(1), 39-56. https://doi.org/10.12989/acc.2014.2.1.039.
  20. Teng, J.G., Xiang, Y. and Fang, Z. (2019), "Development and mechanical behaviour of ultra-high-performance sea-water seasand concrete", Adv. Struct. Eng., 22(14), 3100-3120. https://doi.org/10.1177/1369433219858291.
  21. The Profession Standard of China (2011), Specification for Mix Proportion Design of Ordinary Concrete, (JGJ 55-2011), China Architecture & Building Press, Beijing, China.
  22. The State Standard of China (2011), Pebble and Crushed Stone for Construction, (GB/T 14685-2011), China Standard Press, Beijing, China.
  23. The State Standard of China (2019), Standard for Test Method of Mechanical Properties on Ordinary Concrete, (GB/T 50081-2019), China Standard Press, Beijing, China.
  24. Wu, S., Liu, J.Z. and Dai, Y.H. (2016), "Study on the influence of chloride ions content on the sea sand concrete performance", Am. J. Civil Eng., 4(2), 50-54. https://doi.org/10.11648/j.ajce.20160402.12.
  25. Xiao, J.Z., Qiang, C.B., Antonio, N. and Zhang, K.J. (2017), "Use of sea sand seawater in concrete construction: current status and future opportunities", Constr. Build. Mater., 155, 1101-1111. https://doi.org/10.1016/j.conbuildmat.2017.08.130.
  26. Xiao, J.Z., Zhang, P., Zhang, Q.T., Shen, J., Li, Y. and Zhou, Y. (2018), "Basic mechanical properties of seawater sea-sand recycled concrete", J. Arch. Civil Eng., 35(2), 16-22. https://doi.org/10.3969/j.issn.1673-2049.2018.02.004.
  27. Yang, E.I., Kim, M.Y., Park, H.G. and Yi, S.T. (2010), "Effect of partial replacement of sand with dry oyster shell on the long-term performance of concrete", Constr. Build. Mater., 24(5), 758-765. https://doi.org/10.1016/j.conbuildmat.2009.10.032.
  28. Yang, I.H., Yoon, Y.S. and Kwon, S.J. (2020), "Chloride penetration in anchorage concrete of suspension bridge during construction stage", Adv. Concrete Constr., 10(1), 13-20. http://doi.org/10.12989/acc.2020.10.1.013.
  29. Zhang, Q.T., Xiao, J.Z., Zhang, P. and Zhang, K.J. (2019), "Mechanical behaviour of seawater sea-sand recycled coarse aggregate concrete columns under axial compressive loading", Constr. Build. Mater., 229, 117050. https://doi.org/10.1016/j.conbuildmat.2019.117050.
  30. Zhou, X.H., Tu, X., Chen, A. and Wang, Y.Q. (2019), "Numerical simulation approach for structural capacity of corroded reinforced concrete bridge", Adv. Concrete Constr., 7(1), 11-22. http://doi.org/10.12989/acc.2019.7.1.011.