Structural Engineering and Mechanics

  • 제74권3호
  • /
  • Pages.435-443
  • /
  • 2020
  • /
  • 1225-4568(pISSN)
  • /
  • 1598-6217(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Failure characteristics of columns intersected by slabs with different compressive strengths

  • Choi, Seung-Ho (Department of Architectural Engineering, University of Seoul) ;
  • Hwang, Jin-Ha (Department of Architectural Engineering, University of Seoul) ;
  • Han, Sun-Jin (Department of Architectural Engineering, University of Seoul) ;
  • Kang, Hyun (Fire Research Institute, Korea Institute of Civil Engineering & Building Technology (KICT)) ;
  • Lee, Jae-Yeon (Division of Architectural Engineering, Mockwon University) ;
  • Kim, Kang Su (Department of Architectural Engineering, University of Seoul)
  • 투고 : 2019.09.18
  • 심사 : 2020.02.20
  • 발행 : 2020.05.10
⟨ 이전 논문 다음 논문 ⟩

초록

The objective of this study was to determine the effective compressive strength of a column-slab connection with different compressive strengths between the column and slab concrete. A total of eight column specimens were fabricated, among which four specimens were restrained by slabs while the others did not have any slab, and the test results were compared with current design codes. According to ACI 318, the compressive strength of a column can be used as the effective compressive strength of the column-slab connection in design when the strength ratio of column concrete to slab concrete is less than 1.4. Even in this case, however, this study showed that the effective compressive strength decreased. The specimen with its slab-column connection zone reinforced by steel fibers showed an increased effective compressive strength compared to that of the specimen without the reinforcement, and the interior column specimens restrained with slabs reached the compressive strength of the column.

키워드

과제정보

This research was supported by the National Research Foundation of Korea (NRF) (2017R1D1A3B03028005) for Jae-Yeon Lee. Also, this research was supported by the 2019 Research Fund of the University of Seoul for Kang Su Kim.

참고문헌

  1. ACI 228.2R-13 (2013), "Nondestructive test methods for evaluation of concrete in structures", American Concrete Institute Report, Farmington Hills, U.S.A.
  2. ACI Committee 318 (2014), Building Code Requirements for Structural Concrete and Commentary, American Concrete Institute.
  3. Al-Kamal, M.K. (2019), "Nominal Flexural Strengths of High-Strength Concrete Beams", Adv. Concr. Constr., 7(1), 1-9. https://doi.org/10.12989/acc.2019.7.1.001.
  4. Al-Kamal, M.K. (2019), "Nominal Axial and Flexural Strengths of High-Strength Concrete Columns", Comput. Concrete, 24(1), 85-94. https://doi.org/10.12989/cac.2019.24.1.085.
  5. Bauchkar, S.D., and Chore, H.S. (2018), "Experimental study on rheology, strength and durability properties of high strength selfcompacting concrete", Comput. Concrete, 22(2), 183-196. https://doi.org/10.12989/cac.2018.22.2.183.
  6. Bouzid, H., and Kassoul, A. (2018), "Curvature Ductility Prediction of High Strength Concrete Beams", Struct. Eng. Mech., 66(2), 195-201. https://doi.org/10.12989/sem.2018.66.2.195.
  7. Bianchini, A.C., Woods, R.E., and Kesler, C.E. (1960), "Effect of Floor Concrete Strength on Column Strength", ACI J. Proc., 56(5), 1149-1170. https://doi.org/10.14359/8135.
  8. CSA Committee A23.3 (2014), Canadian Standards Association Design of Concrete Structure, Canadian Standards Association.
  9. Choi, H.K., Bae, B.I., and Choi, C.S. (2015), "Mechanical Characteristics of Ultra High Strength Concrete with Steel Fiber under Uniaxial Compressive Stress", J. Korea Concr. Inst. 27(5), 521-530. https://doi.org/10.4334/JKCI.2015.27.5.521.
  10. Choi, S.H. (2019), "Effective Compressive Strengths of High Strength Concrete Columns Intersected by Normal Strength Concrete Slab", Ph.D. Dissertation, Department of Architectural Engineering, University of Seoul.
  11. Choi, S.H., Lee, D.H., Hwang, J.H., Oh, J.Y., Kim, K.S. and Kim, S.H. (2018), "Effective Compressive Strength of Corner and Exterior Concrete Columns intersected by Slabs with Different Compressive Strengths", Arch. Civ. Mech. Eng. 18(3), 731-741. https://doi.org/10.1016/j.acme.2017.11.001.
  12. Gamble, W.L., and Klinar, J.D. (1991), "Tests of High-Strength Concrete Columns with Intervening Floor Slabs", ASCE J. Struct. Eng. 117(5), 1462-1476. https://doi.org/10.1061/(ASCE)0733-9445(1991)117:5(1462).
  13. Hwang, J.H., Lee, D.H., Kim, K.S., Ju, H.J., and Seo, S.Y. (2013), "Evaluation of Shear Performance of Steel Fiber Reinforced Concrete Beams using a Modified Smeared-Truss Model", Mag. Concrete Res., 64(5), 283-296. https://doi.org/10.1680/macr.12.00009.
  14. Karl, K.W., Lee, D.H., Hwang, J.H., Kim, K.S., and Choi, I.S. (2011), "Revision on Material Strength of Steel Fiber-Reinforced Concrete", Int. J. Concr. Struct. M., 5(2), 87-96. https://doi.org/10.4334/IJCSM.2011.5.2.87.
  15. Kayani, M.K. (1992), "Load Transfer from High-Strength Concrete Columns through Lower Strength Concrete Slabs", Ph.D. Dissertation, Department of Civil Engineering, University of Illinois, Urbana-Champaign, III.
  16. Lee, S.C., and Mendis, P. (2004), "Behavior of High-Strength Concrete Corner Columns Intersected by Weaker Slabs with Different Thicknesses", ACI Struct. J., 101(1), 11-18. https://doi.org/10.14359/12993.
  17. Lee, J.H., Yang, J.M., Lee, S.H., and Yoon, Y.S. (2007), "Improved Transmission of UHSC Column Loads by Puddling of Fiber Reinforced UHSC", J. Korea Concr. Inst., 19(2), 209-216. https://doi.org/10.4334/JKCI.2007.19.2.209.
  18. Nematzadeh, M., and Fallah-Valukolaee, S. (2017), "Effectiveness of fibers and binders in high-strength concrete under chemical corrosion", Struct. Eng. Mech., 64(2), 243-257. https://doi.org/10.12989/sem.2017.64.2.243.
  19. McHarg, P.J., Cook, W.D., Mitchell, D., and Yoon, Y.S. (2000), "Improved Transmission of High-Strength Concrete Column Loads through Normal Strength Concrete Slabs", ACI Struct. J., 97(1), 149-157. https://doi.org/10.14359/845.
  20. Ospina, C.E., and Alexander, S.D.B. (1998), "Transmission of Interior Concrete Column Loads Through Floors", ASCE J. Struct. Eng., 124(6), 602-610. https://doi.org/10.1061/(ASCE)0733-9445(1998)124:6(602).
  21. Portella, G. (2002), "Transmission of High-Strength Concrete Column Loads Through Normal-Strength Concrete Slabs", M.Sc Dissertation, Department of Civil Engineering, University of Melbourne, Victoria, Australia.
  22. Shah, A.A., Dietz, J., Tue, N.V., and Koenig, G. (2005), "Experimental Investigation of Column-Slab Joints", ACI Struct. J., 102(1), 103-113. https://doi.org/10.14359/13535.
  23. Shu, C.C., and Hawkins, N.M. (1992), "Behavior of Columns Continuous Through Concrete Floors", ACI Struct. J., 89(4), 405-414. https://doi.org/10.14359/3023.
  24. Urban, T.S., and Goldyn, M.M. (2015), "Behaviour of Eccentrically Loaded High-Strength Concrete Columns Intersected by Lower-Strength Concrete Slabs", Struct. Concr., 16(4), 480-495. https://doi.org/10.1002/suco.201400114.