DOI QR코드

DOI QR Code

Seismic performance of beam-to- SST column connection with external diaphragm

  • Rong, Bin (Department of Civil Engineering, Tianjin University) ;
  • Yin, Shuhao (Department of Civil Engineering, Tianjin University) ;
  • Zhang, Ruoyu (Department of Civil Engineering, Tianjin University) ;
  • Wang, Lei (Department of Civil Engineering, Tianjin University) ;
  • Yang, Ziheng (Department of Civil Engineering, Tianjin University) ;
  • Li, Hongtao (Department of Civil Engineering, Tianjin University) ;
  • Wan, Wenyu (Department of Civil Engineering, Tianjin University)
  • Received : 2019.09.24
  • Accepted : 2020.12.03
  • Published : 2020.12.25

Abstract

This paper aims to study the seismic performance of external diaphragm connection between SST (square steel tube) column and H-shaped beam through experimental and analytical study involving finite element (FE) method and theoretical analysis. In the experimental study, three external diaphragm connection specimens with weak panel zone were tested under axial pressure on the top of the column and antisymmetric cyclic loads at the beam end to investigate the seismic performance of the panel zone. The hysteretic behavior, failure mode, stiffness and ductility of the specimens were discussed. Key point to be explored was the influence of the thickness of the steel tube flange on the shear capacity of the specimens. In the analytical study, three simplified FE models were developed to simulate the seismic behavior of the specimens for further analysis on the influence of steel tube flange. Finally, four existing calculation formulas for the shear capacity of the external diaphragm connection were evaluated through comparisons with the results of experiments and FE analysis, and application suggestions were put forward.

Keywords

Acknowledgement

The research was funded by the National Natural Science Foundations of China (NSFC) coded 51468061.

References

  1. AIJ (1987), AIJ Standards for Structural Calculation of Steel Reinforced Concrete Structures, Architectural Institute of Japan; Tokyo, Japan.
  2. Bathe, K.J. (1996), "Finite Element Procedures", Prentice Hall; Englewood Cliffs, New Jersey.
  3. Brunesi, E., Nascimbene, R. and Rassati, G.A. (2014), "Response of partially-restrained bolted beam-to-column connections under cyclic loads", J. Constr. Steel Res., 97, 24-38. https://doi.org/10.1016/j.jcsr.2014.01.014.
  4. Brunesi, E., Nascimbene, R. and Rassati, G.A. (2015), "Seismic response of MRFs with partially-restrained bolted beam-to-column connections through FE analyses", J. Constr. Steel Res., 107, 37-49. https://doi.org/10.1016/j.jcsr.2014.12.022.
  5. Cao, S., Shu, G.P., Lin, K.H. and Qin, Y. (2018), "Experimental seismic behaviour of bottom-through-diaphragm and top-ring connection to SST columns", J. Constr. Steel Res., 150, 249-260. https://doi.org/10.1016/j.jcsr.2018.08.025.
  6. CECS 159:2004 (2004), Technical specification for structures with concrete-filled rectangular steel tube members, China Association for Engineering Construction Standardization; Beijing, China.
  7. Dessouki, A.K., Yousef, A.H. and Fawzy, M.M. (2015), "Investigation of in-plane moment connections of I-beams to square concrete-filled steel tube columns under gravity loads", Hbrc J., 11(1), 43-56. https://doi.org/10.1016/j.hbrcj.2014.02.011.
  8. Du, G.F., Bie, X.M., Li, Z. and Guan, W.Q. (2018), "Study on constitutive model of shear performance in panel zone of connections composed of CFSSTCs and steel-concrete composite beams with external diaphragms", Eng. Struct., 155, 178-191. https://doi.org/10.1016/j.engstruct.2017.11.024.
  9. Fukumoto, T. and Morita, K. (2005), "Elastoplastic Behavior of Panel Zone in Steel Beam-to-Concrete Filled Steel Tube Column Moment Connections", J. Struct. Eng., 131(12), 1841-1853. https://doi.org/10.1061/(ASCE)0733-9445(2005)131:12(1841).
  10. GB/T 228.1-2010 (2010), Metallic Materials-Tensile Testing-Part 1: Method of test at room temperature, Standardization Administration of the People's Republic of China; Beijing, China.
  11. Huang, B.S. (2012), "Quasi-static experimental study of outer diaphragm connections between square concrete filled steel tube columns and steel beams", China Civil Eng. J., 45(5), 49-57. http://doi.org/10.15951/j.tmgcxb.2012.05.018.
  12. JGJ/T 101-2015 (2015), Specification for seismic test of buildings, Ministry of Housing and Urban-Rural Development of the People's Republic of China; Beijing, China.
  13. Lee, S. H., Kim, Y.H. and Choi, S.M. (2012), "Shear strength formula of CFST column-beam pinned connections", Steel Compos. Struct., 13(5), 409-421. https://doi.org/10.12989/scs.2012.13.5.409.
  14. Liu, X.G., Tao, M.X., Fan, J.S. and Hajjar, J.F. (2014), "Comparative study of design procedures for CFST-to-steel girder panel zone shear strength", J. Constr. Steel Res., 94(94), 114-121. http://doi.org/10.1016/j.jcsr.2013.11.010.
  15. Morino, S., Kawaguchi, J., Yasuzaki, C. and Kanazawa, S. (1993), "Behavior of Concrete-Filled Steel Tubular Three-Dimensional Subassemblages", Research Reports of the Faculty of Engineering Mie University., 16, 61-78.
  16. Mou, B. and Bai, Y.T. (2018), "Experimental investigation on shear behavior of steel beam-to-CFST column connections with irregular panel zone", Eng. Struct., 168, 487-504. https://doi.org/10.1016/j.engstruct.2018.04.029.
  17. Nakashima, M., Inoue, K. and Tada, M. (1998), "Classification of damage to steel buildings observed in the 1995 HyogokenNanbu Earthquake", Eng. Struct., 20(4-6), 271-281. https://doi.org/10.1016/S0141-0296(97)00019-9.
  18. Nascimbene, R. (2014), "Towards non-standard numerical modeling of thin-shell structures: geometrically linear formulation", Int. J. Comput. Method. Eng. Sci. Mech., 15(2), 126-141. https://doi.org/10.1080/15502287.2013.874058.
  19. Nie, J.G. and Qin, K. (2007), "Research on shear performance of concrete-filled square steel tubular column connections", J. Build. Struct., 28(4), 8-17. https://doi.org/10.14006/j.jzjgxb.2007.04.003.
  20. Nie, J.G., Qin, K. and Cai, C.S. (2008), "Seismic behavior of connections composed of CFSSTCs and steel-concrete composite beams - finite element analysis", J. Constr. Steel Res., 64(6), 680-688. https://doi.org/10.1016/j.jcsr.2007.12.003.
  21. Nishiyama, I., Fujimoto, T., Fukumoto, T. and Yoshioka, K. (2004), "Inelastic Force-Deformation Response of Joint Shear Panels in Beam-Column Moment Connections to Concrete-Filled Tubes", J. Struct. Eng., 130(2), 244-252. https://doi.org/10.1061/(ASCE)0733-9445(2004)130:2(244).
  22. Rong, B., Liu, S., Yan, J.B. and Zhang, R.Y. (2018), "Shear behaviour of panel zone in through-diaphragm connections to steel tubular columns", Thin-Walled Structures., 122, 286-299. https://doi.org/10.1016/j.tws.2017.10.029
  23. Rong, B., Yang, Z.H., Zhang, R.Y., Feng, C.X. and Ma, X. (2019), "Postbuckling Shear Capacity of External Diaphragm Connections of CFST Structures", J. Struct. Eng., 145(5). https://doi.org//10.1061/(ASCE)ST.1943-541X.0002325.
  24. Wang, J., Zhu, H.M., Uy, B., Patel, V., Aslani, F. and Li, D.X. (2018), "Moment-rotation relationship of hollow-section beamto-column steel joints with extended end-plates", Steel Compos. Struct., 29(6), 717. https://doi.org/10.12989/scs.2018.29.6.717.
  25. Wang, W.D., Han, L.H. and You, J.T. (2006), "Experimental studies on hysteretic behaviors of steel beam to concrete filled SHS column connections with stiffening ring", China Civil Eng. J., 39(9), 17-20. https://doi.org/10.15951/j.tmgcxb.2006.09.003.
  26. Wang, Y.D., Koetaka, Y., Chan, I. and Nakano, T. (2019), "Cyclic behavior of beam-column joints with various yielding modes", J. Constr. Steel Res., 159, 245-259. https://doi.org/10.1016/j.jcsr.2019.04.020.
  27. Yu, Y.J., Lan, L.F., Chen, Z.H. and Huang, J. (2019), "Mechanical and seismic behaviors of bottom-flange-bolted upper-flange-welded through-diaphragm connections", J. Constr. Steel Res., 156, 86-95. https://doi.org/10.1016/j.jcsr.2019.01.015.
  28. Zhang, D.X., Gao, S.B. and Gong, J.H. (2012), "Seismic behaviour of steel beam to circular CFST column assemblies with external diaphragms", J. Constr. Steel Res., 76(76), 155-166. https://doi.org/10.1016/j.jcsr.2012.03.024.