한국정보전자통신기술학회논문지 (The Journal of Korea Institute of Information, Electronics, and Communication Technology)

  • 제12권5호
  • /
  • Pages.529-536
  • /
  • 2019
  • /
  • 2005-081X(pISSN)
  • /
  • 2288-9302(eISSN)
한국정보전자통신기술학회 (Korea Information Electronic Communication Technology)
권호 표지
DOI QR코드

DOI QR Code

고압전동기용 진동 감시 시스템의 계수 추출기법 성능 분석

The Performance Analysis of the Parameter Extracting Technique for the Vibration Monitoring System in High Voltage Motor

  • Park, Jung-Cheul (Department of Electronic Engineering, Gachon University) ;
  • Lee, Dal-Ho (Department of Electronic Engineering, Gachon University)
  • 투고 : 2019.09.18
  • 심사 : 2019.10.28
  • 발행 : 2019.10.29
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

본 논문에서는 회전체의 특징 파라미터들을 추출하기 위한 센서의 신호들을 수집하여 추출기법의 성능을 분석하고자 한다. 이를 위해, 모형 시험을 수행하기 위한 진동 테스트 리그를 개발하여 정상적으로 운전하에서의 신호특성을 분석하였다. 그 결과, 가속도 센서에서 측정한 불평형 질량에 따른 가속도 센서에서 측정된 원 데이터 진폭의 변화는 나타나지 않는 것으로 판단된다. FFT를 수행하여 불평형량이 증가함에 따라 회전 주파수인 20Hz의 진폭이 크게 증가하는 것을 알 수 있었다. 속도 센서의 불평형량 변화에 따른 분석결과도 가속도 센서와 같이 1X 하모닉 성분이 크게 증가하였다.정렬불량의 변화시 가속도 센서 데이터에는 특별한 진폭의 변화가 없었으며, Envelope 데이터의 경우 2X(40Hz)의 진폭이 정렬불량의 정도에 따라 증가되었다. 정렬불량의 변화시 속도 센서도 가속도 센서와 유사한 결과를 보였으며 주파수 스펙트럼에서 부하의 증가에 따라 600Hz에서 피크가 감소되었다.

In this paper, the signals of the sensor for extracting characteristic parameters of the rotor are collected and the performance of the extraction technique is analyzed. To this end, a vibration test league was developed for conducting model tests to analyze the signal characteristics under normal operation. As a result, it is judged that no change in the measured the raw data amplitude will occur in the acceleration sensor with the unbalanced mass measured from the acceleration sensor. Performing FFT showed a significant increase in amplitude of the rotational frequency of 20 Hz as the unbalanced mass increased. The analysis results according to the change in the unequal mass of the speed sensor also showed a significant increase in the 1X Harmonics component, such as the acceleration sensor. There was no change in the amplitude of the acceleration sensor data when the misalignment occurred, and for the Envelope data, the amplitude of 2X (40 Hz) was increased depending on the degree of misalignment. The velocity sensor at change of misalignment also showed similar results to the acceleration sensor, and the peak was reduced at 600 Hz as the load increased in the frequency spectrum.

키워드

참고문헌

  1. J.S.Kang,"Development of EMD- based Fault Diagnosis System for Induction Motor",Trans, korean Soc. Noise Vib.Eng., Vol.24, No.9, pp.675 - 681, 2014 https://doi.org/10.5050/KSNVE.2014.24.9.675
  2. S.S.Lee, S.J.Cho and U.P.Chon,"Fault Diagnosis System of Rotating Machines Using LPC Residual Signal Energy", Journal of the Institute of Signal Processing and System, Vol.6, No.3, pp.143-147,2005
  3. S.S.Son, "A Study on Improving High-Power Induction Motor Starting", JKIIECT, Vol.9,No.2 pp.178-184,2016
  4. L.Hwang, H,La S. K, Y.B.Kim,"A Study on Drive in Extending Break Power of The PMSM using series Resistor", JKIIECT, Vol.3.No1 pp.127-135,2012
  5. Muller,G.H. and Landdy,C.F.,"A Volvel Method to Detect Broken Rotor Bars in Squirrel Cage Induction Motors when Interbar Currents are Persent",IEEE Transactions on Energy Conversion, Vol. 18. No. 1,pp.7179,2003 https://doi.org/10.1109/TEC.2002.808338
  6. Dorrell,D.G.,Thomson, W.T. and Roach, S.,"Analysis of Airgap Flux,current and Vibration Signals as a Function of the Combination of Static and Dynamic Airgap Eccentricity in 3-phase Induction Motors",IEEE Transactions on Indstry Applications,Vol.33,No.1,pp.24-34,1997 https://doi.org/10.1109/28.567073
  7. S.,H.Chong, K.T. and Kum,Ar, R,Ravi, "Vibration Signal Analysis for Electrical Fault Dectection of Induction Machine Using Neural Networks," Neural Computing & Applications, Vol.20, No.2, pp.183-194,2011 https://doi.org/10.1007/s00521-010-0512-3
  8. D.H.Lee, J.C.Park,"Development of the Extracting Technique of the Character Parameter for the Vibration Monitoring System in High Voltage Motor", Journal of Korea Information Electron Communication Technology,Vol.12, No,4, pp.349-358, 2019
  9. J.H.Han, J.H.Song, K.H. Choi,"Dagmosis of Induction Motor Faults Using Inverter Input Current Analysis", Journal of the Korea Academia-Industrial cooperation Society, Vol.17, No.7, pp. 492-498,2016 https://doi.org/10.5762/KAIS.2016.17.7.492
  10. B.Xu,L.Sun,L.Xu, and G.Xu, "Improvement of the Hilbert method vis ESPRIT for detecting rotor fault in induction motors at low slip",IEEE Trans. Energy Convers, Vol.28. No.1, pp.225 -233, 2013 https://doi.org/10.1109/TEC.2012.2236557