DOI QR코드

DOI QR Code

RF Receiver design for Satellite Digital Audio Reception (Antenna)

  • Kim, Jang-Wook (Dept. of Information Electronic Engineering, Dongyang Mirae University) ;
  • Jeon, Joo-Seong (Mobile O&M Center, Korea Telecom Network Division)
  • Received : 2019.05.29
  • Accepted : 2019.07.16
  • Published : 2019.07.31

Abstract

This paper describes a design for a RF receiver to receive satellite digital audio service. The RF receiver designed in this study is a planar structure that is easy to install on the rooftop of a car and is compact in size. In addition, it can be applied to certain commercial models because it has low noise and high gain characteristics. The impedance bandwidth of antenna is 17.8%(415MHz), and the axial ratio is below 3dB as good properties for the bandwidth of 40MHz which is a satellite digital audio service band. Also, it had a broad radiation beamwidth of $95.41^{\circ}$ in H-plane and $117.45^{\circ}$ in E-plane. From the results of the field test of satellite digital audio service reception for the RF receiver, it demonstrated good C/N rate(10.2dB).

Keywords

CPTSCQ_2019_v24n7_71_f0001.png 이미지

Fig. 1. Microstrip patch antenna. (a) top view (b) side view (c) equivalent circuit

CPTSCQ_2019_v24n7_71_f0002.png 이미지

Fig. 2. Geometry of the proposed antenna. (a) patch (b)patch and power divider of antenna (c) power divider (d)side view

CPTSCQ_2019_v24n7_71_f0003.png 이미지

Fig. 3. Surface current distributions. (a) conventional patch (b) proposed patch

CPTSCQ_2019_v24n7_71_f0004.png 이미지

Fig. 4. Layout of a Low Noise Amplifier

CPTSCQ_2019_v24n7_71_f0005.png 이미지

Fig. 5. Geometry of the RF receiver. (a) patch antenna (top view) (b) power divider(bottom view) (c) low noise amplifier

CPTSCQ_2019_v24n7_71_f0006.png 이미지

Fig. 6. Measured axial ratio

CPTSCQ_2019_v24n7_71_f0007.png 이미지

Fig. 7. Measured return loss

CPTSCQ_2019_v24n7_71_f0008.png 이미지

Fig. 8. Radiation pattern. (a) H-plane (b) E-plane

CPTSCQ_2019_v24n7_71_f0009.png 이미지

Fig. 9. Measured gain curve

CPTSCQ_2019_v24n7_71_f0010.png 이미지

Fig. 10. Measured carrier signal of satellite digital audio

Table 1. Specifications for a design

CPTSCQ_2019_v24n7_71_t0001.png 이미지

Table 2. Measured results of the power divider

CPTSCQ_2019_v24n7_71_t0002.png 이미지

References

  1. SiriusXM, https://www.xm-radio-satellite.com/
  2. T. Yasin, T, R. Baktur, "Circularly Polarized Meshed Patch Antenna for Small Satellite Application," IEEE Antennas and Wireless Propagation Letters, vol. 12, pp.1057-1060, Aug. 2013. https://doi.org/10.1109/LAWP.2013.2280131
  3. H. Pues, A. V Capelle, "Accurate transmission-line model for the rectangular microstrip antenna," Proc. IEEE, vol. 131, pp.334-340, Dec. 2004.
  4. Jang-Wook Kim, Joo-Seong Jeon, "Design of Broadband Microstrip Patch Antenna for Mobile Communications," Journal of The Korea Society of Computer and Information, vol. 22, pp.67-74, April 2017. https://doi.org/10.9708/jksci.2017.22.04.067
  5. Xianming Qing, Zhi Ning Chen, "A wideband circularly polarized stacked slotted microstrip patch antenna," IEEE Antennas and Propagation Magazine, vol. 55, pp. 84-99, Apr. 2014.
  6. Nanjing Gao, Guoan Wu, Qinghua Tang, "Design of a Novel Compact Dual-Band Wilkinson Power Divider With Wide Frequency Ratio," IEEE Microwave and Wireless Components Letters, vol. 24, pp. 81-83, Feb. 2014. https://doi.org/10.1109/LMWC.2013.2290226
  7. Hee-Ran Ahn, Manos M. Tentzeris, "Novel Sub-Miniaturized Wilkinson Power Divider Based on Small Phase Delay," IEEE Microwave and Wireless Components Letters, vol. 29, pp.439-439, June 2019. https://doi.org/10.1109/LMWC.2019.2902955
  8. ITU-R BO.1130-4, https://www.itu.int/rec/
  9. Microwave Studio, Computer Simulation Technology Inc.
  10. RFHIC, http://rfhic.com/prod/view.html?idx=292