Acknowledgement
Supported by : 기획재정부
References
- R. Malloy, "Plastic Part Design for Injection Molding", Hanser Publications, Second edition, 2010.
- L. L. Zonder, S. Nadav, "Precision Prototyping: The Role of 3D Printed Molds in the Injection Molding Industry", White Paper by Stratasys Inc, 2013.
- R. A. Harris, N. Hopkinson, P. M. Dickens, R. Hague, "The selection of mould design variables in direct stereolithography injection mould tooling", Journal of Engineering Manufacture IMechE Proceeding part B, Vol. 216, pp. 499-505, 2002. https://doi.org/10.1243/0954405021520193
- J. G. Kovacs, G. Kortelyesi, N.K. Kovacs, A Suplicz, "Evaluation of measured and calculated thermal parameters of a photopolymer", Int. Commun. Heat Mass Trans, Vol. 38, pp. 863-867, 2011. https://doi.org/10.1016/j.icheatmasstransfer.2011.04.001
- H. Hassan, N. Regnier, C. Pujos, E. Arquis, G. Defaye, "Modeling the effect of cooling system on the shrinkage and temperature of the polymer by injection molding", Applied Thermal Engineering, Vol. 30, pp. 1547-1557, 2010. https://doi.org/10.1016/j.applthermaleng.2010.02.025
- F. Marin, J. R. Miranda, A. F. Souza, "Study of the design of cooling channels for polymers injection molds", Polymer Engineering and Science, Vol. 58, pp. 552-559, 2017.
- H. Hassan, N. Regnier, C. Le Bot, C. Pujos, G. Defaye, "3D study of cooling system effect on the heat transfer during polymer injection molding", Int. J. Therm, Vol. 49, pp. 161-169, 2010. https://doi.org/10.1016/j.ijthermalsci.2009.07.006
- H. Hassan, N. Regnier, C. Lebot, C. Pujos, G. Defaye, "Effect of cooling system on the polymer temperature and solidification during injection molding", Applied Thermal Engineering, Vol. 29, pp. 1786-1791, 2009. https://doi.org/10.1016/j.applthermaleng.2008.08.011
- Y. Liu, M. Gehde, "Evaluation of heat transfer coefficient between polymer and cavity wall for improving cooling and crystallinity results in injection molding simulation", App. Therm, Vol. 80, pp. 238-246, 2015. https://doi.org/10.1016/j.applthermaleng.2015.01.064
- G. A. Mendible, J. A. Rulander, S. P. Johnston, "Comparative study of rapid and conventional tooling for plastics injection molding", Rapid Prototyping Journal, Vol. 23, pp. 344-352, 2017. https://doi.org/10.1108/RPJ-01-2016-0013