A Study on a High-Temperature/High-Pressure Washing System in which High-Temperature Water is Generated in a Low-Pressure Boiler and High-Pressure Water is Generated Thereafter in a Compressor

저압보일러에서 고온의 온수 생성 후 압축기에서 고압수를 생성하는 고온·고압 세척시스템에 관한 연구

  • 조동현 (대진대학교 컴퓨터응용기계공학과)
  • Received : 2018.11.26
  • Accepted : 2019.01.13
  • Published : 2019.01.31


This study was conducted on a high-temperature/high-pressure washer in which low-pressure cold water in a boiler is heated to a temperature range of $70{\sim}80^{\circ}C$ by supplying diesel combustion heat. The high-temperature water is sent to a compressor to increase its pressure to 200 bar, thereby making high-temperature/high-pressure water, which is sprayed through a spray nozzle. In the results of this study, the spray temperature of the high-pressure washing was shown to be the highest when the ratio between the actual amount of combustible air and the theoretical amount of air was 1:1 and the energy consumption rate of the low-pressure boiler type high-pressure washer was shown to be much lower than that of the high-pressure boiler type high-pressure washer.



  1. Kim, S. I., Park, S. H., Park, G. I., "A Study on the Flow Characteristic around Automobile Engine Cylinder Head," Proceedings of the KSMPE Autumn Conference 2017, pp.188-189, 2017.
  2. Lee, D. Y., "Plastic Processing," Moon Un Dang Pub, pp. 74-76, 2004.
  3. Tehrani, M. S., and Hartley, P. and Naeini, H. M. and Khademizadeh, H., "Localised Edge Buckling in cold Roll-Forming of Symmetric Channel Section," Thin-Walled Structures, Vol. 44, No. 2, 2006.
  4. Lee, S. Y., "Analysis of Roll Forming Process for Pipe using Rigid-Plastic Finite element method," Thesis of Degree of M.Sc. Sogang Univ., pp.50-61 , 2001.
  5. Choi, G. G., "A Study about Analysis of Roll Forming Process using Rigid-Plastic Finite Element Method and Forming Limit in Sheet Metal Forming," Thesis of Degree of M.Sc. Sogang Univ, pp 42-44, 2001
  6. Yang, D. H., Park, H. K., "Numerical Analyses of Fuel Sprays in a Constant Volume Chamber," KSME, pp. 975-977, 2003.
  7. Kuk, Y. H., Choi, H. J., "Analysis of Fluid-Structure Interaction of Cleaning System of Micro Drill Bits," Journal of the Korean Society of Manufacturing Process Engineers, Vol. 15, No.1, pp.8-13, 2016.
  8. Choi, H.-J., S, Y.-B., Park, C.-W., Lee, S.-Y, Choi, S.-D., "Study of Turbine Module Design for Die Casting Mold Release Injection Robot System," Journal of the Korean Society of Manufacturing Process Engineers, Vol.14 No.5, pp. 1-7, 2015.