DOI QR코드

DOI QR Code

Seismic response of skewed bridges including pounding effects

  • Kun, Chern (Department of Civil and Environmental Engineering, Faculty of Engineering, The University of Auckland) ;
  • Yang, Ziqi (Department of Civil and Environmental Engineering, Faculty of Engineering, The University of Auckland) ;
  • Chouw, Nawawi (Department of Civil and Environmental Engineering, Faculty of Engineering, The University of Auckland)
  • 투고 : 2017.10.13
  • 심사 : 2018.03.23
  • 발행 : 2018.05.25

초록

The seismic vulnerability of skewed bridges had been observed in many past earthquakes. Researchers have found that the in-plane rotation of the girders was one of the main reasons for the vulnerability of these types of bridges. To date, not many experimental works have been done on this topic, especially those including pounding between adjacent structures. In this study, shake table tests were performed on a bridge-abutment system consisting of a straight, $30^{\circ}$, and $45^{\circ}$ bridge with and without considering pounding. Skewed bridges with the same fundamental frequency and those having the same girder mass as the straight bridge were studied. Under the loadings considered, skewed bridges with the same frequency as the straight tend to have smaller responses than those with the same mass. The average maximum bending moment developed in the piers of the $30^{\circ}$ bridge with the same mass as that of the straight when pounding was not considered was 1.6 times larger than when the frequencies were the same. It was also found that the NZTA recommendations for the seat lengths of skewed bridges could severely underestimate the relative displacements of these types of bridges in the transverse direction, especially when pounding occurs. In the worst case, the average transverse displacement of the $45^{\circ}$ bridge was about 2.6 times the longitudinal displacement of the straight, which was greatly over the limit suggested by the NZTA of 1.25 times.

키워드

참고문헌

  1. Anagnostopoulos, S.A. and Karamaneas, C.E. (2008), "Use of collision shear walls to minimize seismic separation and to protect adjacent buildings from collapse due to earthquakeinduced pounding", Earthq. Eng. Struct. Dyn., 37(12), 1371-1388. https://doi.org/10.1002/eqe.817
  2. Buckingham, E. (1914), "On physically similar systems: Illustrations of the use of dimensional equations", Phys. Rev., 4(4), 345-376. https://doi.org/10.1103/PhysRev.4.345
  3. Catacoli, S., Ventura, C.E., Finn, W.D.L. and Taiebat, M. (2014), "In-plane rotational demands of skewed bridges due to earthquake induced pounding", The Tenth U.S. National Conference on Earthquake Engineering, Anchorage, Alaska, US.
  4. Chen, Y., Larkin, T. and Chouw, N. (2017), "Experimental assessment of contact forces on a rigid base following footing uplift", Earthq. Eng. Struct. Dyn., 46, 1835-1854. https://doi.org/10.1002/eqe.2885
  5. Chouw, N. (1996), "Effect of the earthquake on 17th of January 1995 on Kobe", Proceedings of the D-A-CH meeting of the German, Austrian and Swiss Society for Earthquake Engineering and Structural Dynamics, University of Graz, Austria, 135-169.
  6. Chouw, N. and Hao, H. (2005), "Study of SSI and non-uniform ground motion effect on pounding between bridge girders", Soil Dyn. Earthq. Eng., 25, 717-728. https://doi.org/10.1016/j.soildyn.2004.11.015
  7. Chouw, N. and Hao, H. (2008), "Significance of SSI and nonuniform near-fault ground motions in bridge response II: Effect on response with modular expansion joint", Eng. Struct., 30(1), 154-162. https://doi.org/10.1016/j.engstruct.2007.02.020
  8. Chouw, N., Hao, H. and Su, H. (2006), "Multi-sided pounding response of bridge structures with non-linear bearings to spatially varying ground excitation", Adv. Struct. Eng., 9(1), 55-66. https://doi.org/10.1260/136943306776232936
  9. Deepu, S.P., Prajapat, K. and Ray-Chaudhuri, S. (2014), "Seismic vulnerability of skew bridges under bi-directional ground motions", Eng. Struct., 71, 150-160. https://doi.org/10.1016/j.engstruct.2014.04.013
  10. Dimitrakopoulos, E.G. (2011). "Seismic response analysis of skew bridges with pounding deck-abutment joints", Eng. Struct., 33(3), 813-826. https://doi.org/10.1016/j.engstruct.2010.12.004
  11. Dimitrakopoulos, E.G. (2013), "Nonsmooth analysis of the impact between successive skew bridge-segments", Nonlin. Dyn., 74(4), 911-928. https://doi.org/10.1007/s11071-013-1012-7
  12. Huang, H., Shenton, H. and Chajes, M. (2004), "Load distribution for a highly skewed bridge: Testing and analysis", J. Bridge Eng., 9(6), 558-562. https://doi.org/10.1061/(ASCE)1084-0702(2004)9:6(558)
  13. Huo, Y. and Zhang, J. (2013), "Effects of pounding and skewness on seismic responses of typical multispan highway bridges using the fragility function method", J. Bridge Eng., 18(6), 499-515. https://doi.org/10.1061/(ASCE)BE.1943-5592.0000414
  14. Jennings, P.C. (1971), "Engineering features of the San Fernando earthquake of February 9, 1971", Casadena, California: National Science Foundation and Earthquake Research Affiliates of the California Institute of Technology.
  15. Kaviani, P., Zareian, F. and Taciroglu, E. (2012), "Seismic behaviour of reinforced concrete bridges with skew-angled seat type abutment", Eng. Struct., 45, 137-150. https://doi.org/10.1016/j.engstruct.2012.06.013
  16. Kawashima, K., Unjoh, S., Hoshikuma, J.I. and Kosa, K. (2011), "Damage of bridges due to the 2010 Maule, Chile, earthquake", J. Earthq. Eng., 15(7), 1036-1068. https://doi.org/10.1080/13632469.2011.575531
  17. Khatiwada, S. and Chouw, N. (2013), "A shake table investigation on interaction between buildings in a row", Coupl. Syst. Mech., 2(2), 175-190. https://doi.org/10.12989/csm.2013.2.2.175
  18. Khatiwada, S., Larkin, T. and Chouw, N. (2014), "Influence of mass and contact surface on pounding response of RC structures", Earthq. Struct., 7(3), 385-400. https://doi.org/10.12989/eas.2014.7.3.385
  19. Kun, C., Jiang, L. and Chouw, N. (2017), "Influence of pounding and skew angle on seismic response of bridges", Eng. Struct., 148, 890-906. https://doi.org/10.1016/j.engstruct.2017.07.024
  20. Kwon, O.S. and Jeong, S.H. (2013), "Seismic displacement demands on skewed bridge decks supported on elastomeric bearings", J. Earthq. Eng., 17(7), 998-1022. https://doi.org/10.1080/13632469.2013.791894
  21. Li, B., Bi, K., Chouw, N., Butterworth, J.W. and Hao, H. (2012), "Experimental investigation of spatially varying effect of ground motions on bridge pounding", Earthq. Eng. Struct. Dyn., 41(14), 1959-1976. https://doi.org/10.1002/eqe.2168
  22. Li, B., Bi, K., Chouw, N., Butterworth, J.W. and Hao, H. (2013), "Effect of abutment excitation on bridge pounding", Eng. Struct., 54, 57-68. https://doi.org/10.1016/j.engstruct.2013.03.034
  23. Makris, N. (2014), "The role of the rotational inertia on the seismic resistance of free-standing rocking columns and articulated frames", Bull. Seismol. Soc. Am., 104(5), 2226-2239. https://doi.org/10.1785/0120130064
  24. Maragakis, E. (1985), "A model for the rigid body motions of skew bridges", Casadena, California: California Institute of Technology, Retrieved from http://www.scopus.com/inward/record.url?eid=2-s2.0-0021938781&partnerID=40&md5=213fecabcd83a8e2c7e5c23349bb4ab2.
  25. Meng, J.Y., Lui, E.M. and Liu, Y. (2001), "Dynamic response of skew highway bridges", J. Earthq. Eng., 5(2), 205-223. https://doi.org/10.1080/13632460109350392
  26. Mitchell, D., Bruneau, M., Saatcioglu, M., Williams, M., Anderson, D. and Sexsmith, R. (1995), "Performance of bridges in the 1994 Northridge earthquake", Can. J. Civil Eng., 22(2), 415-427. https://doi.org/10.1139/l95-050
  27. New Zealand Transport Agency (2016), Bridge Manual (SP/M/022), Wellington, New Zealand.
  28. Qin, X., Chen, Y. and Chouw, N. (2013), "Effect of uplift and soil nonlinearity on plastic hinge development and induced vibrations in structures", Adv. Struct. Eng., 16(1), 135-147. https://doi.org/10.1260/1369-4332.16.1.135
  29. Shao, G., Jiang, L. and Chouw, N. (2014), "Experimental investigations of the seismic performance of bridge piers with rounded rectangular cross-sections", Earthq. Struct., 7(4), 463-484. https://doi.org/10.12989/eas.2014.7.4.463
  30. Soleimani, F. (2017), "Fragility of California bridges-Development of modification factors", Doctoral Dissertation, Georgia Institute of Technology, Georgia, USA.
  31. Soleimani, F., Vidakovic, B., DesRoches, R. and Padgett, J. (2017), "Identification of the significant uncertain parameters in the seismic response of irregular bridges", Eng. Struct., 141, 356-372. https://doi.org/10.1016/j.engstruct.2017.03.017
  32. Standards New Zealand Technical Committee (2004), Structural design actions Part 5: Earthquake actions - New Zealand, NZS 1170.5: 2004, Wellington, New Zealand.
  33. Sullivan, I.T. (2010), "Analytical seismic fragility curves for skewed multi-span steel girder bridges", Doctoral Dissertation, Clemson University, South Carolina, USA.
  34. Wakefield, R.R., Nazmy, A.S. and Billington, D.P. (1991), "Analysis of seismic failure in skew RC bridge", J. Struct. Eng., 117(3), 972-986. https://doi.org/10.1061/(ASCE)0733-9445(1991)117:3(972)
  35. Watanabe, G. and Kawashima, K. (2004), "Effectiveness of cablerestrainer for mitigating rotation of a skewed bridge subjected to strong ground shaking", The 13th World Conference on Earthquake Engineering, Vancouver, Canada.
  36. Weiser, J. and Maragakis, M. (2013), "Seismic performance of highway bridges with seat-type abutments subjected to nearfault ground motions", Proceedings of the 2013 Structures Congress, 827-838.
  37. Won, J., Mha, H., Cho, K. and Kim, S. (2008), "Effects of the restrainer upon bridge motions under seismic excitations", Eng. Struct., 30(12), 3532-3544. https://doi.org/10.1016/j.engstruct.2008.05.021
  38. Wood, J. and Jennings, P. (1971), "Damage to freeway structures in the San Fernando earthquake", Bull. NZ Soc. Earthq. Eng., 4(3), 347-76.
  39. Yang, C.S., Werner, S.D. and DesRoches, R. (2015), "Seismic fragility analysis of skewed bridges in the Central and Southeastern United States", Eng. Struct., 83, 116-128. https://doi.org/10.1016/j.engstruct.2014.10.025
  40. Yashinsky, M. (2011), "Lessons learned from the February 27, 2010 Maule, Chile earthquake", Caltrans Office of Earthquake Engineering, Retrieved from http://www.dot.ca.gov/hq/esc/earthquake_engineering/damage_report/Lessons_Learned.pdf.
  41. Zakeri, B., Padgett, J. and Amiri, G. (2014), "Fragility analysis of skewed single-frame concrete box-girder bridges", J. Perform. Constr. Facil., 28(3), 571-582. https://doi.org/10.1061/(ASCE)CF.1943-5509.0000435
  42. Zakeri, B., Padgett, J. and Amiri, G. (2015), "Fragility assessment for seismically retrofitted skewed reinforced concrete box girder bridges", J. Perform. Constr. Facil., 29(2), 04014043. https://doi.org/10.1061/(ASCE)CF.1943-5509.0000502

피인용 문헌

  1. Experimental Evaluation of the Seismic Response of Skewed Bridges with Emphasis on Poundings between Girder and Abutments vol.2019, pp.None, 2018, https://doi.org/10.1155/2019/4069817
  2. Response modification factor and seismic fragility assessment of skewed multi-span continuous concrete girder bridges vol.20, pp.4, 2021, https://doi.org/10.12989/eas.2021.20.4.389