DOI QR코드

DOI QR Code

Behavior of geopolymer and conventional concrete beam column joints under reverse cyclic loading

  • Raj, S. Deepa (Department of Civil Engineering, College of Engineering Trivandrum) ;
  • Ganesan, N. (Department of Civil Engineering, National Institute of Technology) ;
  • Abraham, Ruby (Rajiv Gandhi Institute of Technology) ;
  • Raju, Anumol (Department of Civil Engineering, College of Engineering Trivandrum)
  • 투고 : 2016.09.21
  • 심사 : 2016.12.08
  • 발행 : 2016.09.25

초록

An experimental investigation was carried out on the strength and behavior plain and fiber reinforced geopolymer concrete beam column joints and the results were compared with plain and steel fiber reinforced conventional concrete beam column joints. The volume fraction of fibers used was 0.5%. A total of six Geopolymer concrete joints and four conventional concrete joints were cast and tested under reversed cyclic loading to evaluate the performance of the joints. First crack load, ultimate load, energy absorption capacity, energy dissipation capacity stiffness degradation and moment-curvature relation were evaluated from the test results. The comparison of test results revealed that the strength and behavior of plain and fiber reinforced geopolymer concrete beam column joints are marginally better than corresponding conventional concrete beam column joints.

키워드

과제정보

연구 과제 주관 기관 : Kerala State Council for Science Technology and Environment (KSCSTE)

참고문헌

  1. Al Bakri, M.M., Mohammed, H., Kamarudin, H., Niza, I.K. and Zarina, Y. (2011), "Review on fly ash-based geopolymer concrete without portland cement", J. Eng. Tech. Res., 3(1), 1-4.
  2. Bakharev, T. (2005), "Geopolymeric materials prepared using class F fly ash and elevated temperature curing", Cement Concrete Res., 35(6), 1224-1232. https://doi.org/10.1016/j.cemconres.2004.06.031
  3. Dattatreya, J.K., Rajamane, N.P., Sabitha, D., Ambily, P.S. and Nataraja, M.C. (2011), "Flexural behaviour of reinforced geopolymer concrete beams", J. Civil Struct. Eng., 2(1), 138.
  4. Ganesan, N., Indira, P.V. and Sabeena, M.V. (2014), "Behaviour of hybrid fibre reinforced concrete beam-column joints under reverse cyclic loads", Mater. Des., 54, 686-693. https://doi.org/10.1016/j.matdes.2013.08.076
  5. Ganesan, N., Abraham, R. and Raj, S.D. (2015), "Durability characteristics of steel fibre reinforced geopolymer concrete", Constr. Build. Mater., 93, 471-476. https://doi.org/10.1016/j.conbuildmat.2015.06.014
  6. Ganesan, N., Ruby, A. and Deepa, R.S. (2015), "Durability characteristics of steel fiber reinforced geopolymer concrete", Constr. Build. Mater., 93, 471-476 https://doi.org/10.1016/j.conbuildmat.2015.06.014
  7. Haach, V.G., El, A.L.H.D.C. and El Debs, M.K. (2008), "Evaluation of the influence of the column axial load on the behavior of monotonically loaded R/C exterior beam-column joints through numerical simulations", Eng. Struct., 30(4), 965-975. https://doi.org/10.1016/j.engstruct.2007.06.005
  8. Hardjito, D., Wallah, S.E., Sumajouw, D.M. and Rangan, B.V. (2004), "On the development of fly ash-based geopolymer concrete", ACI Mater. J.-Am. Concrete Inst., 101(6), 467-472.
  9. IS 383 (1970) (Reaffirmed 2002), "Specifications for coarse and fine aggregate from natural sources for concrete", Code of Practice, 2nd Revision, BIS, New Delhi.
  10. IS: 10262 (2009), "Recommended guidelines for concrete mix design"-Code of Practice, BIS, New Delhi.
  11. IS: 12269 (1987) (Reaffirmed on 1999), "Specification for 53 grade ordinary Portland cement", Code of Practice, BIS, New Delhi.
  12. Kannapiran, K., Sujatha, T. and Nagan, S. (2013), "Resistance of reinforced geopolymer concrete beams to acid and chloride migration", Asian J. Civil Eng., 14, 225-238.
  13. Rangan, B.V. (2006), "Studies on low calcium fly ash based geopolymer concrete", Indian Concrete J., 9-17.
  14. Sarker, P.K. (2009), "Analysis of geopolymer concrete columns", Mater. Struct., 42(6), 715-724. https://doi.org/10.1617/s11527-008-9415-5
  15. Sarker, P.K. (2011), "Bond strength of reinforcing steel embedded in fly ash-based geopolymer concrete", Mater. Struct., 44(5), 1021-1030. https://doi.org/10.1617/s11527-010-9683-8
  16. Sujatha, T., Kannapiran, K. and Nagan, S. (2012), "Strength assessment of heat cured geopolymer concrete slender column", Asian J. Civil Eng., 13(5), 635-646.

피인용 문헌

  1. Development of mix design method for geopolymer concrete vol.5, pp.4, 2016, https://doi.org/10.12989/acc.2017.5.4.377
  2. Role of fibers on the performance of geopolymer concrete exterior beam column joints vol.9, pp.2, 2016, https://doi.org/10.12989/acc.2020.9.2.115
  3. Thermal and compressive behaviors of fly ash and metakaolin-based geopolymer vol.30, pp.None, 2016, https://doi.org/10.1016/j.jobe.2020.101307
  4. Bond properties of steel and sand-coated GFRP bars in Alkali activated cement concrete vol.75, pp.1, 2020, https://doi.org/10.12989/sem.2020.75.1.123
  5. Experimental investigations on the structural behaviour of reinforced geopolymer beams produced from recycled construction materials vol.41, pp.None, 2016, https://doi.org/10.1016/j.jobe.2021.102776
  6. Shear behaviour of reinforced construction and demolition waste-based geopolymer concrete beams vol.47, pp.None, 2016, https://doi.org/10.1016/j.jobe.2021.103861