DOI QR코드

DOI QR Code

Influence of axial load and loading path on the performance of R.C. bridge piers

  • 투고 : 2014.07.21
  • 심사 : 2015.02.06
  • 발행 : 2015.04.25

초록

Piers are the most vulnerable part of a bridge structure during an earthquake event. During Kobe earthquake in 1995, several bridge piers of the Hanshin Expressway collapsed for more than 600m of the bridge length. In this paper, the most important results of an experimental and analytical investigation of ten reinforced concrete bridge piers specimens with the same cross section subjected to constant axial (or variable) load and reversed (or one direction) cycling loading are presented. The objective was to investigate the main parameters influencing the seismic performance of reinforced concrete bridge piers. It was found that loading history and axial load intensity had a great influence on the performance of piers, especially concerning strength and stiffness degradation as well as the energy dissipation. Controlling these parameters is one of the keys for an ideal seismic performance for a given structure during an eventual seismic event. Numerical models for the tested specimens were developed and analyzed using SeismoStruct software. The analytical results show reasonable agreement with the experimental ones. The analysis not only correctly predicted the stiffness, load, and deformation at the peak, but also captured the post-peak softening as well. The analytical results showed that, in all cases, the ratio, experimental peak strength to the analytical one, was greater than 0.95.

키워드

과제정보

연구 과제 주관 기관 : National Earthquake Engineering Research Center

참고문헌

  1. ACI (2011), Building Code Requirements for Structural Concrete and Commentary, ACI 318-11, American Concrete Institute, Detroit.
  2. Acun, B. (2010), "Energy based seismic performance assessment of reinforced concrete columns", Ph.D. Thesis, Middle East technical University, Ankara.
  3. Acun, B. and Sucuoglu, H. (2012), "Energy dissipation capacity of reinforced concrete columns under cyclic displacements", ACI Struct. J., 109 (4), 531-540.
  4. A lvarez, J.J., Aparicio, A.C., Jara, J.M. and Jara, M. (2012), "Seismic assessment of a long-span arch bridge considering the variation in axial forces induced by earthquakes", Eng. Struct., 34, 69-80. https://doi.org/10.1016/j.engstruct.2011.09.013
  5. Bae, S. and Bayrak, O. (2008), "Seismic performance of full-scale reinforced concrete columns", ACI Struct. J., 105 (2), 123-133.
  6. Bechtoula, H., Kono, S. and Watanabe, F. (2005), "Experimental and analytical investigations of seismic performance of cantilever reinforced concrete columns under varying transverse and axial loads", J. Asian Architect. Build. Eng., 4(2), 467-474. https://doi.org/10.3130/jaabe.4.467
  7. Bechtoula, H., Sakashita, M., Kono, S., Fumio, W. (2006), "Seismic design proposal based on a study on RC columns and frame sub-assemblage", Federation Internationale du Beton, Proceedings of the 2nd International Congress, ID 9-31, Naples, Italy.
  8. Chang, S.Y. (2010), "Experimental studies of reinforced concrete bridge columns under axial load plus biaxial bending", J. Struct. Eng. ASCE, 136(1), 12-25. https://doi.org/10.1061/(ASCE)0733-9445(2010)136:1(12)
  9. Chen, Y., Feng, M.Q. and Soyoz, S. (2008), "large-scale shake table test verification of bridge condition assessment methods", J. Struct. Eng., 7, 1235-1245.
  10. Cheok, G.S. and Stone, W.C. (1990), "Behavior of 1/6-Scale model bridge columns subjected to inelastic cyclic loading", ACI Struct. J., 87(6), 630-638.
  11. El-Bahy, A., Kunnath, S.K., Stone, W.C. and Taylor, A.W. (1999a), "Cumulative seismic damage of circular bridge columns: benchmark and low-cycle fatigue tests", ACI Struct. J., 96 (4), 633-643.
  12. El-Bahy, A., Kunnath, S.K., Stone, W.C. and Taylor, A.W. (1999b), "Cumulative Seismic Damage of Circular Bridge Columns: Variable Amplitude Tests", ACI Struct. J., 96(5), 711-719.
  13. Eurocode 2 (2004), Design of Concrete Structures Part 1, European Standard ENV 1992-1-1, Brussels.
  14. Filippou, F.C., Popov, E.P. and Bertero, V.V. (1983), Effects of Bond Deterioration on Hysteretic Behavior of Reinforced Concrete Joints, Report EERC 83-19, Earthquake Engineering Research Center, University of California, Berkeley.
  15. Fujikura, S., Kawashima, K., Shoji, G., Zhang, J. and Takemura, H. (2000), "Effect of the interlocking ties and cross ties on the dynamic strength and ductility of rectangular reinforced concrete bridge columns", J. Struct. Mech. Earthq. Eng., 640(I-50), 71-88.
  16. Galal, K.E. and Ghobarah, A. (2003), "Flexural and shear hysteretic behaviour of reinforced concrete columns with variable axial load", Eng. Struct., 25, 1353-1367. https://doi.org/10.1016/S0141-0296(03)00111-1
  17. Han, Q., Du, X., Zhou, Y. and Lee, G. (2013), "Experimental study of hollow rectangular bridge column performance under vertical and cyclically bilateral loads", Earthq. Eng. Eng. Vib., 12(3), 433-445. https://doi.org/10.1007/s11803-013-0184-y
  18. Iranmanesh, A. and Ansari, F. (2013), "An energy based damage assessment methodology for structural health monitoring of modern reinforced concrete bridge columns", J. Bridge Eng., 10.1061/ (ASCE) BE.1943-5592.0000569.
  19. Kawashima, K., Shoji, G. and Sakakibara, Y. (2000), "A Cyclic Loading Test for Clarifying the Plastic Hinge Length of Reinforced Concrete Piers", J. Struct. Eng., 46A, 767-776.
  20. Mander, J.B., Priestley M.J.N. and Park, R. (1988), "Theoretical stress-strain model for confined concrete", J. Struct. Eng.ASCE, 114(8), 1804-1826. https://doi.org/10.1061/(ASCE)0733-9445(1988)114:8(1804)
  21. Menegotto, M. and Pinto, P. (1973), "Method of analysis for cyclically loaded reinforced concrete plane Frames Including Changes In Geometry And Non-Elastic Behavior Of Elements Under Combined Normal Force And Bending", Proceedings of the IABSE Symposium on Resistance and Ultimate Deformability of Structures Acted on by Well Defined Repeated Loads, Lisbon, 15-22.
  22. Mullapudi, T. and Ayoub, A. (2013), "Analysis of reinforced concrete columns subjected to combined axial, flexure, shear, and torsional loads", J. Struct. Eng., 139(4), 561-573. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000680
  23. Park, Y.J. and Ang, A.H.S. (1985), "Mechanistic seismic damage model for reinforced concrete", J. Struct. Eng. ASCE, 111(4), 722-739. https://doi.org/10.1061/(ASCE)0733-9445(1985)111:4(722)
  24. Park, Y.J., Ang, A.H.S. and Wen, K. (1985), "Seismic damage analysis of reinforced concrete buildings", J. Struct. Eng. ASCE, 111(4), 740-757. https://doi.org/10.1061/(ASCE)0733-9445(1985)111:4(740)
  25. Sakai, J. and Kawashima, K. (2002), "Effect of varying axial loads including a constant tension on seismic performance of reinforced concrete bridge piers", J. Struct. Eng. JSCE, 48A, 735-746.
  26. Salawu, O.S. and Williams, C. (1993), "Review of full-scale dynamic testing of bridge columns", Eng. Struct., 17 (2), 113-121. https://doi.org/10.1016/0141-0296(95)92642-L
  27. Seismo Struct, (2012), "A computer program for processing strong motion data", Seismosoft Ltd, website: www.seismosoft.com.
  28. Sezen, H. and Moehle, J.P. (2006), "Seismic tests of concrete columns with light transverse reinforcement", ACI Struct. J., 103(6), 842-849.
  29. Sheikh, S.A. (1978), "Effectiveness of rectangular ties as confinement", Ph.D. Dissertation, University of Toronto, Toronto.
  30. Sheikh, S.A. and Toklucu, M.T. (1993), "Reinforced concrete columns confined by circular spirals and hoops", ACI Struct. J., 90(5), 542-553.
  31. Shibata, A. and Sozen, M.A. (1976), "Substitute-structure method for seismic design in R/C", J. Struct. Div. ASCE, 102(ST1), 1-18.
  32. Tae, H.K., Dai, J.S. and Hyun, M.S. (2012), "Seismic performance assessment of hollow reinforced concrete and prestressed concrete bridge Columns", Int. J. Concrete Struct. Mater., 6(3), 165-176. https://doi.org/10.1007/s40069-012-0015-y
  33. Takemura, H. and Kawashima, K. (1997), "Effect of loading hysteresis on ductility capacity of reinforced concrete bridge piers", J. Struct. Eng., 43A, 849-858.
  34. Wei, D.Z. and Wu, H.Z. (2013), "Probabilistic seismic capacity models for RC bridge columns", Appl. Mech. Mater., 353(356), 2028-2032.