DOI QR코드

DOI QR Code

Antimony Content of Natural Mineral Water in Korean Market and Migration into Water from Bottle Material

국내유통 먹는샘물 중의 안티몬 함량 및 용기 이행 특성

  • Huh, Yujeong (Environmental Infrastructure Research Department, National Institute of Environmental Research) ;
  • Yang, Mihee (Environmental Infrastructure Research Department, National Institute of Environmental Research) ;
  • Cho, Yangseok (Environmental Infrastructure Research Department, National Institute of Environmental Research) ;
  • Ahn, Kyunghee (Environmental Infrastructure Research Department, National Institute of Environmental Research) ;
  • Lee, Younhee (Environmental Infrastructure Research Department, National Institute of Environmental Research) ;
  • Chung, Hyunmee (Environmental Infrastructure Research Department, National Institute of Environmental Research) ;
  • Kwon, Ohsang (Environmental Infrastructure Research Department, National Institute of Environmental Research) ;
  • Park, Juhyun (Environmental Infrastructure Research Department, National Institute of Environmental Research)
  • 허유정 (국립환경과학원 환경기반연구부) ;
  • 양미희 (국립환경과학원 환경기반연구부) ;
  • 조양석 (국립환경과학원 환경기반연구부) ;
  • 안경희 (국립환경과학원 환경기반연구부) ;
  • 이연희 (국립환경과학원 환경기반연구부) ;
  • 정현미 (국립환경과학원 환경기반연구부) ;
  • 권오상 (국립환경과학원 환경기반연구부) ;
  • 박주현 (국립환경과학원 환경기반연구부)
  • Received : 2014.01.15
  • Accepted : 2014.03.03
  • Published : 2014.03.30

Abstract

The knowledge on the migration of antimony (Sb) from PET bottles into the water is of greate concern. Antimony in all bottled water marketed in korea and in raw water was analyzed. The detection rate of antimony in total bottled water was 88 % and 100% in PET (Polyethylene terephthalate, PET), 55% in PC (Polycarbonate, PC) bottled water. 55% of raw water contained antimony. The average concentration of Sb in PET bottled water was $0.39{\mu}g/L$, higher than PC bottles ($0.20{\mu}g/L$) and the raw water ($0.22{\mu}g/L$). The migration of Sb into water that is stored in different conditions (room temperature, $45^{\circ}C$, and direct sunlight exposure) was investigated for 180 days. The migration tendency increased with the storage time and temperature. PET bottles showed a sharp increase of Sb concentration at $45^{\circ}C$, but there was no differences between the room temperature and sunlight exposure. The Sb migration in all simulated solution(deionized water, 4% acetic acid, and 20% ethanol) also increased with storage time and temperature. The Sb migration values ranged from 0.35 to $0.49{\mu}g/L$ in all simulated solution, which was far below the permissible korean migration level of $40{\mu}g/L$. There was a tendency that the number of re-use of a bottle and the amount of leaching were in inverse proportion.

Keywords

References

  1. Bach, C., Dauchy, X., Severin, I., Munos, J. F., Etienne, S., and Chagnon, M. C. (2013). Effect of Temperature on the Release of Intentionally and Non-interntionally Added Substances from Polyethylene Terephthalate (PET) Bottles into Water : Chemical Analysis and Potential Toxicity, Food Chemistry, 139, pp. 672-680. https://doi.org/10.1016/j.foodchem.2013.01.046
  2. European Union (EU). (2003). European Commission Directive 2003/40/EC of 16 May 2003 Establishing the List, Concentration Limits and Labelling Requirements for the Constituents of Natural Mineral Waters and the Conditions for Using Ozone-enriched Air for the Treatement of Natural Mineral Waters and Spring Waters, European Union.
  3. European Union (EU). (2011). Commission Regulation (EU) No 10/2011, on Plastic Materials and Articles Intended to Come into Contact with Food, European Union.
  4. Hansen, H. R. and Pergantis, S. A. (2006). Detection of Antimony Species in Citrus Juices and Drinking Water Stored in PET Containers, Journal of Analytical Atomic Spectrometry, 21, pp. 731-733. https://doi.org/10.1039/b606367e
  5. International Agency for Research on Cancer (IARC). (1989). Monographs on the Evaluation of Carcinogenic Risk to Human: Some Organic Solvents, Resin Monomers and Related Compounds, Pigments and Occupational Exposures in Paint Manufacture and Paint, 47, International Agency for Research on Cancer.
  6. Jeong, C. D. (2008). Case Study of Hydrochemical Contamination by Antimony Waste Disposal in Korea, The Journal of Engineering Geology, 18(4), pp. 471-482. [Korean Literature]
  7. Lee, J. B., Park, J. H., Lee, Y. H., Seo, K. E., Ahn, K. H., Ahn, H. S., Choi, J. Y., Jheong, W. H., Park, S. J., Oh, J. H., Jang, S. J., Park, J. Y., Kim, G. S., Kim, J. H., Kwon, O. S., Kim, T. S., and Han, J. S. (2010). A Study on Securing Safety of Bottled Water, National Institute of Environmental Research. [Korean Literature]
  8. MacDonald, W. A. (2002). New Advances in Polyethylene Terephthalate Polymerization and Degradation, Polymer International, 51, pp. 923-930. https://doi.org/10.1002/pi.917
  9. Nishioka, K., Hirahara, A., and Iwamoto, E. (2002). Determination of Antimony in Polyethylene Terephthalate Bottles by Graphite Furnace Atomic Absorption Spectrometry Using Microwave Sample Preparation, Bulletin of Faculty of Human Life and Environmental Science, 8, pp. 35-42. [Japanese Literature]
  10. Park, J. H., Kim, H. G., Lee, J. B., Ahn, K. H., and Lee, Y. H. (2011). Antimony Contamination from PET of Bottled Tap Water, Proceedings of the 2011 Spring Co-Conference of the Korean Society on Water Environment and Korean Society of Water and Wastewater, Korean Society on Water Environment and Korean Society of Water and Wastewater, pp. 291-292 [Korean Literature].
  11. Reimann, C., Birke, M., and Filzmoser, P. (2012). Temperaturedependent Leaching of Chemical Elements from Mineral Water Bottle Material, Applied Geochemistry, 27, pp. 1492-1498. https://doi.org/10.1016/j.apgeochem.2012.05.003
  12. Reimann, C., Birke, M., and Filzmoser, P. (2010). Bottled Drinking Water: Water Contamination from Bottle Materials (glass, hard PET, soft PET), the Influence of Colour and Acidification, Applied Geochemistry, 25, pp. 1030-1046. https://doi.org/10.1016/j.apgeochem.2010.04.009
  13. Rungchang, S., Numthuan, S., Qiu, X., Li, Y., and Satake, T. (2013). Diffusion Coefficient of Antimony Leaching from Polyethylene Terephthalate Bottles into Beverages, Journal of Food Engineering, 115, pp. 322-329. https://doi.org/10.1016/j.jfoodeng.2012.10.025
  14. Sachez-Martinez, M., Perez-Corona, T., Camara, C., and Madrid, Y. (2013). Migration of Antimony from PET Containers into Regulated EU Food Simulants, Food Chemistry, 141, pp. 816-822. https://doi.org/10.1016/j.foodchem.2013.03.067
  15. Shotyk, W. and Krachler, M. (2007). Contamination of Bottled Waters with Antimony Leaching from Polyethylene Terephthalate( PET) Increases Upon Storage, Environmental Science & Technology, 41, pp. 1560-1563. https://doi.org/10.1021/es061511+
  16. Shotyk, W., S., Krachler, M., and Chen, B. (2006). Contamination of Canadian and European Bottled Waters with Antimony from PET Containers, Journal of Evironmental Monitoring, 8, pp. 288-292. https://doi.org/10.1039/b517844b
  17. Takahashi, Y., Sakuma, K., Itai, T., Zheng, G., and Mitsunobu, S. (2008). Speciation of Antimony in PET Bottles Produced in Japan and China by X-ray Absorption Fine Structure Spectroscopy, Environmental Science & Technology, 42, pp. 9045-9050. https://doi.org/10.1021/es802073x
  18. United States Environmental Protection Agency (U.S.EPA). (2009). National Primary Drinking Water Regulations, Washington (DC): U.S.EPA. Code of Federal Regulation, 40 CFR Part 141.
  19. United States Food and Drug Administration, HHS(U.S.FDA). (2012). Bottled Water Quality Standard, U.S. FDA. Code of Federal Regulation, 21 CFR Part 165.
  20. Wegelin, M., Canonica, S., Alder, A. C., Marazuela, D., Suter, M. J. F., Bucheli, Th. D., Haefliger, O. P., Zenobi, R., McGuigan, K. G., Kelly, M. T., Ibrahim, P., and Larroque, M. (2001). Does Sunlight Change the Material and Content of Polyetylene Terephthalate (PET) Bottles?, Journal of Water Supply: Research and Technology-AQUA, 50(3). pp. 125-133.
  21. Welle, F. and Franze, R. (2011). Migration of Antimony from PET Bottles into Beverages: Determination of the Activation Energy of Diffusion and Migration Modeling Compared with Literature Data, Food Additives and Contaminants, 28(1). pp. 115-126.
  22. Westerhoff, P., Prapaipong, P., Shock. E., and Hillaireau, A. (2008). Antimony Leaching from Polyethylene Terephthalate (PET) Plastic Used for Bottled Drinking Water, Water Research, 42, pp. 551-556. https://doi.org/10.1016/j.watres.2007.07.048
  23. World Health Organization (WHO). (2008). Antimony in Drinking- water, Background Document for Development of WHO Guidelines for Drinking-Water Quality, World Health Organization.
  24. World Health Organization (WHO). (2011). Guidelines for Drinking- Water Quality, 4th edition, World Health Organization.