Abstract
Depending on the underground load support mechanism, anchors are classified as friction anchors, bearing plate anchors and the recently developed combined friction-bearing plate anchors which combine the characteristics of both the friction and bearing plate type anchors. Even though numerous studies have been performed on bearing plate anchors, there were only few studies performed to observe the failure surface of bearing plate anchors. Furthermore most of the soil materials used on these tests were not real sand but carbon rods. In this study, sand was placed in the soil tank and laboratory tests were performed with bearing plate anchors installed with an embedment depth (H/h) ranging from 1~6. The variation in the pullout capacity and the behaviour of soil with the embedment depth (H/h) were observed. Ground deformation analysis program was also used to analyze soil displacement, zero extension direction, maximum shear strain contours. It was determined from the analysis of the results that at ultimate pullout resistance the deformation was 5 mm and the failure surface occurred in a narrower area when compared with results of the previous researches. It was also observed that the width of the fracture surface gradually becomes wider and expands up to the surface as the deformation increases from 10 mm to 15 mm.
앵커는 지중에서 힘을 받는 형태에 따라 마찰형 앵커, 지압형 앵커, 마찰지압병용형 앵커로 나눌 수 있으며 최근에는 두 가지 형태가 복합적으로 사용되어지는 앵커가 개발되고 있다. 지압형 앵커에 관하여도 많은 연구가 진행 되었지만, 파괴면을 직접 관찰한 예는 적었다. 그리고 지반재료도 주로 실제 모래가 아닌 탄소봉등을 이용하여 실험을 한 것이 대부분이다. 본 연구에서는 토조에 모래지반을 형성하고, 지압형 앵커를 토피비(H/h)에 따라 1~6까지 나누어 설치하고 각 토피비에 따른 인발력과 지반의 거동을 관찰하였다. 또한 지반변형해석 프로그램을 통해 지반 변위, 무신축 방향, 최대전단변형률 등고선에 대해서 분석하였다. 분석결과 극한 인발력의 발현시점인 변위 5mm에서는 파괴면의 폭이 기존의 이론보다 좁은 영역에서 진행되는 것을 관찰 할 수 있었고, 10, 15mm까지 변위가 증가할수록 파괴면의 폭이 넓어지고 지표면까지 확장하는 것을 확인할 수 있었다.