DOI QR코드

DOI QR Code

Capacitive Readout Circuit for Tri-axes Microaccelerometer with Sub-fF Offset Calibration

  • Received : 2013.03.05
  • Accepted : 2013.11.10
  • Published : 2014.02.28

Abstract

This paper presents a capacitive readout circuit for tri-axes microaccelerometer with sub-fF offset calibration capability. A charge sensitive amplifier (CSA) with correlated double sampling (CDS) and digital to equivalent capacitance converter (DECC) is proposed. The DECC is implemented using 10-bit DAC, charge transfer switches, and a charge-storing capacitor. The DECC circuit can realize the equivalent capacitance of sub-fF range with a smaller area and higher accuracy than previous offset cancelling circuit using series-connected capacitor arrays. The readout circuit and MEMS sensing element are integrated in a single package. The supply voltage and the current consumption of analog blocks are 3.3 V and $230{\mu}A$, respectively. The sensitivities of tri-axes are measured to be 3.87 mg/LSB, 3.87 mg/LSB and 3.90 mg/LSB, respectively. The offset calibration which is controlled by 10-bit DECC has a resolution of 12.4 LSB per step with high linearity. The noise levels of tri-axes are $349{\mu}g$/${\sqrt}$Hz, $341{\mu}g$/${\sqrt}$Hz and $411{\mu}g$/${\sqrt}$Hz, respectively.

Keywords

References

  1. W. Bracke, P. Merken, R. Puers and C. Van Hoof, "On the optimization of ultra low power front-end interfaces for capacitive sensors," Sensors and Actuators A: Physical, Vol.117, No. 2, pp.273-285, Jan., 2005. https://doi.org/10.1016/j.sna.2004.06.011
  2. C. C. Enz and G. C. Temes, "Circuit techniques for reducing the effects of op-amp imperfections: Autozeroing, correlated double sampling, and chopper stabilization," Proceedings of IEEE, Vol.84, No.11, pp.1584-1614, Nov., 1996.
  3. J. Chen, X. Ni and B. Mo, "A low noise CMOS charge sensitive preamplifier for MEMS capacitive accelerometer readout," ASIC, 2007. ASICON '07, 7th International Conference on, pp.490-493, Oct., 2007.
  4. M. Lemkin and B.E. Boser, "A three-axis micromachined accelerometer with a CMOS position-sense interface and digital offset-trim electronics," Solid-State Circuits, IEEE Journal of, Vol.34, No.4, pp.456-468, Apr.,1999. https://doi.org/10.1109/4.753678
  5. H. Ko and D. Cho, "Low noise accelerometer microsystem with highly configurable capacitive interface," Analog Integrated Circuits and Signal Processing, Vol. 67, No.3, pp.365-373, June, 2011. https://doi.org/10.1007/s10470-010-9539-8
  6. H. Rodjegard and A. Loof, "A differential chargetransfer readout circuit for multiple output capacitive sensors," Sensors and Actuators A, Vol.119, No.2, pp.309-315, Apr., 2005. https://doi.org/10.1016/j.sna.2004.10.003
  7. H. Ouh, et al., "Sub-fF trimmable readout circuit for tri-axes capacitive microaccelerometers," Sensors, 2012 IEEE, pp.1-4, Oct., 2012.

Cited by

  1. Capacitive analog front-end circuit with dual-mode automatic parasitic cancellation loop vol.23, pp.2, 2017, https://doi.org/10.1007/s00542-017-3288-x
  2. Fully Integrated Low-Noise Readout Circuit with Automatic Offset Cancellation Loop for Capacitive Microsensors vol.15, pp.10, 2015, https://doi.org/10.3390/s151026009