DOI QR코드

DOI QR Code

Preparation of ZnO Thin Film by Electrophoretic Deposition(EPD)

  • Jun, Byung-Sei (Nano Materials Science and Engineering Department, Kyungnam University)
  • Received : 2011.11.04
  • Accepted : 2012.01.18
  • Published : 2012.01.31

Abstract

The electrophoretic deposition(EPD) of ZnO nano-sized colloids is investigated by changing the colloid number concentration, applied force, and deposition time. The change of the colloid size in a suspension was examined by the different colloid number concentrations (N = $3.98{\times}10^{15}$, N = $3.98{\times}10^{14}$, and N = $3.98{\times}10^{13}$) with an increase of the deposition time and applied forces. Deposition behavior was investigated by changing the applied fields (from DC 5 V to 50 V) and the deposition time (5 min to 25 min). The surface microstructures of the as-deposited films were investigated by SEM. The dried films were sintered from $850^{\circ}C$ to $1,050^{\circ}C$ for 2 h and then the microstructures were also explored by SEM. The agglomeration rate was enhanced by increasing the colloid number concentration of colloids. Colloid number concentration in a suspension must be rapidly decreased at higher values of the electric field. ZnO nano-sized colloids had the highest zeta potential value of over -28 mV in methanol. A homogeneous microstructure was obtained at colloid number concentration of N = $3.98{\times}10^{13}$, applied DC field of 5 V/cm and 15 min of deposition time at an electrode distance of 1.5 cm. Under these conditions, the deposited films were sintered at $850^{\circ}C$ and $1,050^{\circ}C$ for 2 h. The results show a typical pore-free surface morphology of a uniform thickness of 400 nm under these experimental conditions.

Keywords

References

  1. Y. C. Wang, I. C. Leu, and M. H. Hon, "Effect of Colloid Characteristics on the Fabrication of ZnO Nanowire Arrays by Electrophoretic Deposition," J. Mater. Chem., 12 2439-44 (2002). https://doi.org/10.1039/b111189m
  2. M. Matsuoka, "Nonohmic Properties of Zinc Oxide Ceramics," Jpn. J. Appl. Phys., 10 736-46 (1971). https://doi.org/10.1143/JJAP.10.736
  3. D. R. Clarke, "Grain-boundary Segregation in a Commercial ZnO-based Varistor," J. Appl. Phys., 50 6829-32 (1979). https://doi.org/10.1063/1.325881
  4. W. D. Kingery, J. B. Vander Sande, and T. Mitamura, "Scanning Transmission Electron Microscopy Investigation of Grain-Boundary Segregation in a $ZnO-Bi_2O_3$ Varistor," J. Am. Ceram. Soc., 62 221-22 (1979). https://doi.org/10.1111/j.1151-2916.1979.tb19064.x
  5. E. Olsson and G. Dunlop, "The Effect of $Bi_2O_3$ Content on the Microstructure and Electrical Properties of ZnO Varistor Materials," J. Appl. Phys., 66 4317-24 (1989). https://doi.org/10.1063/1.343978
  6. Mel Schwartz, Encyclopedia of Smart Materials, pp.151-152, John Wiley and Sons, Hoboken, New Jersey, 2002.
  7. P. Sarkar and P. S. Nicholson, "Electrophoretic Deposition (EPD): Mechanisms, Kinetics, and Application to ceramics," J. Am. Ceram. Soc., 79 1987-2002 (1996). https://doi.org/10.1111/j.1151-2916.1996.tb08929.x
  8. J. Zhang and B. I. Lee, "Electrophoretic Deposition and Characterization of Micrometer-Scale $BaTiO_3$ Based X7R Dielectric Thick Films," J. Am. Ceram. Soc., 83 2417-22 (2000). https://doi.org/10.1111/j.1151-2916.2000.tb01570.x
  9. S. Okamura, Takeyo Tsukamoto and Nobuyuki Koura, "Fabrication of Ferroelectric $BaTiO_3$ Films by Electrophoretic Deposition," Jpn. J. Appl. Phys., 32 4182-85 (1993). https://doi.org/10.1143/JJAP.32.4182
  10. C. Allain, M. Cloitre, and F. Parisse, "Settling of Clusters in Aggregating Colloidal Suspensions," J. Colloid and Interface Science, 178 411-16 (1996). https://doi.org/10.1006/jcis.1996.0135
  11. A. R. Boccaccini and Igor Zhitomirsky, "Application of Electrophoretic And Electrolytic Deposition Techniques In Ceramics Processing", Current Opinion In Solid State & Materials Science, 6 251-60 (2002). https://doi.org/10.1016/S1359-0286(02)00080-3
  12. S. Lee, S. Lee, and B. Jun, "Fabrication of Nano-sized ZnO Colloids from Spray Combustion Synthesis(SCS)," J. Kor. Ceram. Soc., 41 [1] 76-80 (2004). https://doi.org/10.4191/KCERS.2004.41.1.076
  13. M.Giersig and P. Mulvaney, "Formation of Ordered Twodimensional Gold Colloid Lattices by Electrophoretic Deposition," J. phys. Chem., 97 6334-36 (1993). https://doi.org/10.1021/j100126a003
  14. P. Sakar and P. S Nicholson, "Electrophoretic Deposition(EPD): Mechanism, Kinetics, and Application to Ceramics," J. Am. Ceram. Soc., 79 [8] 1987-2002 (1996). https://doi.org/10.1111/j.1151-2916.1996.tb08929.x
  15. H. C. Harmaker and E. J. W. Verwey, "The Role of Forces Between the Particles in Eletrophoretic Deposition and Other Phenomena," J. Chem. Soc., Faraday Transaction, 36 180-85 (1940).
  16. H. Koelmans and J. Th. G. Overbeek, "Stability and Electrophoretic Deposition of Suspensions in Non-aqueous Media," Faraday Discussions of the Chemical Society, 18 52-63 (1954). https://doi.org/10.1039/df9541800052
  17. H. Koelmans, "Suspension in Non-aqueous Media," Philips Res. Rep., 10 [6] 93 (1955).
  18. J. Lyklema, "Principles of the Stability of Lyophobic Colloidal in Non-aqueous Media," J. Colloid Interface Science, 2 65-114 (1968).
  19. Y. Hirata, A. Nishnoto, and Y. Ishihara, "Forming of Alumina Powders by Electrophoretic Deposition," J. Ceram. Soc. Jpn., 99 108-13 (1991). https://doi.org/10.2109/jcersj.99.108
  20. Z. Zhang, Y. Huang, and Z. Jiang, "Reply to Comment on Electrophoretic Deposition Forming of SiC/TZP Composites in Nanoqueous Sol Media," J. Am. Ceram. Soc., 78 3167-68 (1995). https://doi.org/10.1111/j.1151-2916.1995.tb09107.x
  21. C. Y. Tai, W.-C. Chien, and P.-C. Chen, "Encyclopedia of Surface and Colloid Science," Vol. 3, pp.3903-18, John Wiley and Sons, New Jersey, 2002.

Cited by

  1. Particles and Electrophoretic Resin vol.50, pp.6, 2013, https://doi.org/10.4191/kcers.2013.50.6.460
  2. Single-step Zno nanorod bunches formation on p-type Si-conductive substrates by electrophoretic deposition vol.23, pp.None, 2012, https://doi.org/10.1016/j.surfin.2021.100930