Tunnel and Underground Space (터널과지하공간)

Korean Society for Rock Mechanics and Rock Engineering (한국암반공학회)
권호 표지
DOI QR코드

DOI QR Code

Analysis for the Behavior of Ridge-Cut Rock Slope

능선부 개착에 의해 형성된 암반사면 거동해석

  • 조태진 (부경대학교 에너지자원공학과) ;
  • 황택진 (동의대학교 토목공학과) ;
  • 신선미 (부경대학교 에너지자원공학과) ;
  • 이근호 ((주)호승이앤씨)
  • Received : 2012.10.19
  • Accepted : 2012.11.06
  • Published : 2012.12.31
Download PDF
⟨ Previous Next ⟩

Abstract

A behavior of ridge-cut rock slope had been monitored by installing inclinometers and regional slope movement toward rear side of cut face was detected. To delineate the governing factors of slope behavior, especially backward slip of ridge-cut slope, petrographic characteristics of rock cores obtained from four drilled boreholes had been examined. BIPS images inside boreholes had been acquired and structural characteristics of slope rock had been studied. Mechanical properties of discontinuity planes distributed in the drilled core had been measured and the shear strength of coal seam imbedded-discontinuity planes also had been obtained by performing the direct shear test. Monitoring results of slope behavior had been analyzed by comprehensibly considering both the mechanical and structural characteristics of slope rock and coal seam-imbedded discontinuity planes, and the potential governance of coal seam and clay minerals embedded in the joint plane on the regional slope behavior has been also identified.

정상부가 개착된 암반사면에 지중경사계를 설치하여 개착사면의 내부 거동을 계측하였으며, 국지적으로 배후면 방향으로의 거동이 관찰되었다. 사면 거동, 특히 배후면 방향으로의 거동을 유발시키는 원인을 분석하기 위하여 시추작업을 수행하였다. 추출된 시추코어를 관찰하여 사면 암반의 암석학적 취약성을 조사하였으며, 공내 BIPS 영상을 취득하여 암반의 구조적 특성을 분석하였다. 코어 절리 시료를 이용하여 불연속면의 역학적 특성을 측정하였으며, 탄질물이 협재된 절리 시료에 대한 직접전단시험을 수행하여 전단강도를 측정하였다. 사면 거동에 대한 계측결과를 사면 암반과 탄질물이 협재된 절리들의 구조적 및 역학적 특성을 종합적으로 고려하여 해석하였으며, 절리에 협재된 탄질물 및 팽윤성 점토광물의 존재에 의해 국지적인 사면거동이 지배될 수 있는 잠재성을 확인하였다.

Keywords

References

  1. Bae, W.S., Kwon, Y.C., Oh, S.W., Lee, B.J., 2006, A case study on evaluation stability of slope in coaly shale, 2006 KSCE Annual Conference, 3821-3824.
  2. Bieniawski, Z.T., 1989, Engineering rock mass classification, John Wiley, New York, 237-247.
  3. Cho, T.F., Hwang, T.J., Lee, G.H., Cho, K.S., Lee, S.B., 2012, A study of the applicability of cross-section method for cut-slope stability analysis, Tunnel & Underground Space (Journal of Korean Society for Rock Mechanics), 21, 1, 20-32. https://doi.org/10.7474/TUS.2012.22.1.043
  4. Cho, T.F., Lee, S.B., Lee, G.H., Hwang, T.J., Kang, P.G., Won, B.N., 2011, Identification of dominant cause of cut-slope collapse and monitoring of reinforced slope behavior, Tunnel & Underground Space (Journal of Korean Society for Rock Mechanics), 21, 1, 20-32.
  5. Cho, T.F., Park, S.Y., Lee, S.B., Lee, G.H., Won, K.S., 2006, Monitoring of cut-slope behavior with consideration of rock structure and Failure Mode, Tunnel & Underground Space (Journal of Korean Society for Rock Mechanics), 16, 6, 451-466.
  6. Fukuzono, T., 1990, Recent studies on time prediction of slope failure, Landslide News, 4, 9-12.
  7. Hoek, E. and Bray, J., 1974, Rock slope Engineering, The Institution of Mining and Metallurgy, London, 300p.
  8. Hutchison, J.N., 1995, Landslide hazard assessment. In Landslides, Proc. Sixth Int. Symp. on Landslides(ed D.F. Bell), 3, 1805-1841.
  9. Kim, K.Y., Kim C.Y., Lee, S.D., Seo, Y.S., Lee, C.I., 2007, Measurement of tunnel 3-D displacement using digital photogrammetry, The Journal of Engineering Geology, 17, 4, 567-576.
  10. Kim, Y.J., Lee, Y.H., Kim, S.K., Kim, J.H., 2006, Case study on failure of rock slope caused by filling material of clay, Tunnel & Underground Space (Journal of Korean Society for Rock Mechanics), 16, 5, 368-376.
  11. Kwon, O.I., Back, Y., Park, C.H., 2010, A case study on stability analysis of tunnel portal slope, 2010 KSEG Conference, 249-253.
  12. Lollino, G., Arattano, M., Cuccureddu, M., 2002, The use of the automatic inclinometric system for landslide early warning: the case of Cabella Ligure(North-Western Italy), Physi cs and Chemistry of the Earth, 27, 1545-1550. https://doi.org/10.1016/S1474-7065(02)00175-4
  13. Mahtab, M.A. and Yegulalp, T.M., 1984, A similarity test for grouping orientation data in rock mechanics, Proc. of 25th U.S. Symposium on Rock Mechanics, 495-502.
  14. Mahtab, M.A. and Yegulalp, T.M., 1982, A rejection criterion for definition of clusters in orientation data, Proc. 22nd Symposium on Rock Mechanics, R. E. Goodman and F. E. Heuze ed., Berkeley, 116-123.
  15. Min, K.N., Ahn, T.B., Yang, S.J., Baek, S.G., Lee, T.S., 2007, A study on the analysis of the slope stability considering clay filling in discontinuity, Tunnel & Underground Space (Journal of Korean Society for Rock Mechanics), 17, 3, 175-185.
  16. Raax, 1996, Borehole Image Processing System Information. Sapporo, Japan.
  17. Yoon, W.S., 2002, Characterization of fracture distribution and its application to slope stability analysis, Seoul National University, 288p.