DOI QR코드

DOI QR Code

The Effect of Mild Tensile Reinforcement and Effective Prestress on the Flexural Performance of the Prestressed Lightweight Concrete Beams with Unbonded Tendons

비부착 프리스트레스트 경량 콘크리트 보의 휨 거동에 대한 부착 철근과 유효 프리스트레스의 영향

  • Received : 2011.04.15
  • Accepted : 2011.06.13
  • Published : 2011.10.31

Abstract

Seven post-tensioned lightweight concrete (LWC) beam specimens were tested under a symmetrical two-point top loading system. The parameters investigated were the amounts of mild longitudinal reinforcement and effective prestressing. The design compressive strength and dry density of the LWC tested were 30 MPa and 1,770 $kg/m^3$, respectively. Similar to post-tensioned normal weight concrete (NWC) beams, the crack propagation and stress increase of the unbonded tendons were significantly affected by the amounts of mild longitudinal reinforcement and effective prestressing. With the increase in the amounts of mild longitudinal reinforcement and effective prestressing, the serviceability and flexural capacity of the beams were enhanced whereas the stress increase in the unbonded tendons decreased. To control the crack width in post-tensioned LWC beams, a minimum amount of mild longitudinal reinforcement specified in ACI 318-08 provision is required. The flexural behavior of post-tensioned LWC beams and stress increase of the unbonded tendons could be rationally predicted by the proposed non-linear two-dimensional analysis. On the other hand, ACI 318-08 flexure provision was too conservative about the post-tensioned LWC beams.

포스트텐션 경량 콘크리트(LWC) 보 시험체 7개가 상부 대칭 2점 집중 하중 하에서 실험되었다. 주요 변수는 부착 주철근 양 및 유효 프리스트레스 양이다. 경량 콘크리트의 설계강도 및 단위 용적 중량은 각각 30 MPa과 1,770 $kg/m^3$이다. 포스트텐션 보통 중량 콘크리트에서와 같이 균열 진전과 비부착 긴장재의 응력은 부착 철근 및 유효 프리스트레스 양에 의해 영향을 받았다. 부착 철근 및 유효 프리스트레스 양의 증가와 함께 보의 사용성과 휨 내력은 향상되는 반면 비부착 긴장재의 응력은 감소하였다. 포스트텐션 경량 콘크리트 보의 균열 제어를 위해서는 ACI 318-08에서 제시하는 최소 부착 철근이 요구되었다. 포스트텐션 경량 콘크리트 보의 휨 거동 및 비부착 긴장재의 응력 증가는 제시된 비선형 해석 모델에 의해 적절하게 예측될 수 있었다. 반면 ACI 318-08 기준은 포스트텐션 LWC 보의 휨 내력 및 비부착 긴장재의 응력 증가에 대해 지나치게 안전측에 있었다.

Keywords

References

  1. 심재일, 양근혁, "굳지 않은 경량 골재 콘크리트의 공기량, 유동성 및 블리딩 특성," 콘크리트학회 논문집, 22권, 4호, 2010, pp. 559-566.
  2. Kayali, O., "Fly Ash Lightweight Aggregates in High Performance Concrete," Construction and Building Materials, Vol. 22, No. 12, 2008, pp. 2393-2399. https://doi.org/10.1016/j.conbuildmat.2007.09.001
  3. 양근혁, 문주현, 변항용, "프리스트레스트 경량 콘크리트보의 휨 거동에 대한 부분 프리스트레싱 비와 유효 프리스트레스의 영향," 콘크리트학회 논문집, 23권, 1호, 2011, pp. 39-48.
  4. Tam, A. and Pannell, F. N., "The Ultimate Moment of Resistance of Unbonded Partially Prestressed Reinforced Concrete Beams," Magazine of Concrete Research, Vol. 28, No. 97, 1976, pp. 203-208. https://doi.org/10.1680/macr.1976.28.97.203
  5. Mattock, A. H., Yamakazi, J., and Kattula, B. T., "Comparative Study of Beams with and without Bond," Journal of the American Concrete Institute, Vol. 68, No. 2, 1971, pp. 116-125.
  6. Yang, K. H. and Kang, T. H.-K., "Equivalent-Strain Distribution Factor for Unbonded Tendon Stress at Ultimate," ACI Structural Journal, Vol. 108, No. 2, 2011, pp. 217-226.
  7. Warwaruk, J., Sozen, M. A., and Siess, C. P., Investigation of Prestressed Concrete for Highway Bridges, Part : Strength and Behavior in Flexure of Prestressed Concrete Beams, Bulletin No. 464, Engineering Experiment Station, University of Illinois, 1962, 105 pp.
  8. Naaman, A. E., Burns, N., French, C., Gamble, W. L., and Mattock, A. H., "Stresses in Unbonded Prestressing Tendons at Ultimate: Recommendation," ACI Structural Journal, Vol. 99, No. 4, 2002, pp. 518-529.
  9. Au, F. T. K. and Du, J. S., "Prediction of Ultimate Stress in Unbonded Prestressed Tendons," Magazine of Concrete Research, Vol. 56, No. 1, 2004, pp. 1-11. https://doi.org/10.1680/macr.2004.56.1.1
  10. Harajli, M. H., "On the Stress in Unbonded Tendons at Ultimate: Critical Assessment and Proposed Changes," ACI Structural Journal, Vol. 103, No. 6, 2006, pp. 803-812.
  11. Ozkul, O. K., Nassif, H. N., Tanchan, P. D., and Harajli, M. H., "Rational Approach for Predicting Stress in Beams with Unbonded Tendons," ACI Structural Journal, Vol. 105, No. 3, 2008, pp. 338-347.
  12. Du, G. and Tao, X., "Ultimate Stress of Unbonded Tendons in Partially Prestressed Concrete Beams," PCI Journal, Vol. 30, No. 6, 1985, pp. 72-91. https://doi.org/10.15554/pcij.11011985.72.91
  13. ACI Committee 318, Building Code Requirements for Structural Concrete (ACI 318-08) and Commentary (ACI 318R-08), American Concrete Institute, Farmington Hills, MI, 2008, 473 pp.
  14. ASTM A 416, Standard Specifications for Steel Strand, "Uncoated Seven-Wire for Prestressed Concrete," America Society for Testing and Materials, 1996, pp. 572-575.
  15. Collins, M. P. and Mitchell, D., Prestressed Concrete Structures, Prentice-Hall, USA, 1991, 766 pp.
  16. Slate, F. O., Nilson, A. H., and Martinez, S., "Mechanical Properties of High-Strength Lightweight Concrete," ACI Journal, Vol. 83, No. 4, 1986, pp. 606-613.
  17. Wang, P. T., Complete Stress-Strain Curve of Concrete and its Effect on Ductility of Reinforced Concrete Members, PhD thesis, University of Illinois, 1977, 257 pp.
  18. Menegotto, M. and Pinto, P. E., Method of Analysis for Cyclically Loaded Reinforced Concrete Plane Frames, IABSE Preliminary Report for Symposium on Resistance and Ultimate Deformability of Structures Acted on by Well-Defined Repeated Loads, 1973, pp. 15-22.