Smart Structures and Systems

Techno-Press (테크노프레스)
권호 표지
DOI QR코드

DOI QR Code

Identification of multiple sources in a plate structure using pre-filtering process for reduction of interference wave

  • Lee, S.K. (Department of Mechanical Engineering, Inha University) ;
  • Moon, Y.S. (Department of Mechanical Engineering, Inha University) ;
  • Park, J.H. (Department of Mechanical Engineering, Inha University)
  • Received : 2010.12.08
  • Accepted : 2011.05.24
  • Published : 2011.08.25
⟨ Previous Next ⟩

Abstract

This paper presents novel research into the source localization of multiple impacts. Source localization technology for single impact loads in a plate structure has been used for health monitoring. Most of research on source localization has been focused only on the localization of single impacts. Overlapping of dispersive waves induced by multiple impacts and reflection of those waves from the edge of the plate make it difficult to localize the sources of multiple impacts using traditional source localization technology. The method solving the overlapping problem and the reflection problem is presented in the paper. The suggested method is based on pre-signal processing technology using band pass filter and optimal filter. Results from numerical simulation and from experimentation are presented, and these verify the capability of the proposed method.

Keywords

Acknowledgement

Supported by : National Research Foundation of Korea (NRF)

References

  1. Alleyne, D. and Cawley, P.A. (1991), "Two-dimensional Fourier transform method for the measurement of propagating multimode signals", J. Acoust. Soc. Am., 89(3), 1159-1168. https://doi.org/10.1121/1.400530
  2. Balasubramaniam, K. and Rose, J.L. (1991), "Physically based dispersion curve feature analysis in the NDE of composites", Res. Nondestruct. Eval., 3(1), 41-67. https://doi.org/10.1080/09349849109409501
  3. Cohen, L. (1995), Time-Frequency Analysis , Prentice hall, New Jersey.
  4. Fonollosa, J.R. and Nikias, C.L. (1993), "Wigner-higher-order moment spectra definition, properties, computation and application to transient signal analysis", IEEE Transactions on Signal Processing, 41, 245-266. https://doi.org/10.1109/TSP.1993.193143
  5. Graff, K.F. (1953), Wave Motion in Elastic Solids, Dover Publications Inc., New York.
  6. Haykin, S. (2007), Adaptive Filter Theory , Prentice hall, New Jersey.
  7. Hellier, C.J. (2003), Handbook of nondestructive evaluation , McGraw-Hill company.
  8. Lee, S.K. (1998), Adaptive Signal Processing and Higher Order Time Frequency Analysis for Acoustic and Vibration Signatures in Condition Monitoring, Ph.D. Thesis, University of Southampton.
  9. Lee, S.K. and Whit, P.R. (2001), "Fault diagnosis of rotating machinery using wigner higher order moment spectra", Mech. Syst. Signal Pr., 11, 637-650.
  10. Lee, S.K. Banerjee, S. and Mal, S. (2007), "Identification of impact force on a thick plate based on the elastodynamics and higher-order time-frequency analysis" Proceedings of the Institution of Mechanical Engineers Part C-Journal of Mechanical Engineering Science. https://doi.org/10.1243/09544062JMES674
  11. Lih, S.S. and Mal, A.K. (1995), "On the accuracy of approximate plate theories for wave field calculations in composite laminates", Wave Motion, 21(1), 17-24. https://doi.org/10.1016/0165-2125(94)00038-7
  12. Loutridis, S. Douka, E. Hadjileontiadis, L.J. and Torchidis, A. (2005), "A two dimensional wavelet transform for detection of cracks in plates", Eng. Struct., 27(9), 1327-1338. https://doi.org/10.1016/j.engstruct.2005.03.006
  13. Mindlin, R.D. (1951), "Inluence of rotatory inertia and shear flexural motion of isotropic, elastic plate", J. Appl. Mech - T ASME, 18, 31-38.
  14. Park, J.H. and Kim, Y.H. (2006), "Impact source localization on an elastic plate in a noisy environment", Meas. Sci. Technol., 17(10), 2757-2766. https://doi.org/10.1088/0957-0233/17/10/030
  15. Park, S.W. and Lee, S.K. (2010), "Development of a new sound metric for impact sound in a passenger car using the wavelet transform", Int. J. Autom. Technol., 11, 809-818. https://doi.org/10.1007/s12239-010-0096-z
  16. Pham, D.T., Ji, Z., Yang, M., Wang, Z. and Al-Kuthbi, M. (2007), "A novel human-computer interface based on passive acoustic localization", Human-Computer Interaction LNCS 4551 901-909.
  17. Prosser, W.H. Seale, M.D. and Smith, B.T. (1999), "Time-frequency analysis of the dispersion of Lamb modes", J. Acoust. Soc. Am., 105(5), 2669-2676. https://doi.org/10.1121/1.426883
  18. Raghavan, A. and Cesnik, C.E.S. (2007), "Guided-wave signal processing using chirplet matching pursuits and mode correlation for structure health monitoring", Smart Mater. Struct., 16(2), 355-366. https://doi.org/10.1088/0964-1726/16/2/014
  19. Rolshofen, W., Pham, D.T., Yang, M., Ji. Z. and Al-Kutubi, M. (2005), "New approach in computer interaction with tangible acoustic interface", Proceedings of the IPROMs2005 Visual Conference.
  20. Tobis, A. (1976), "Acoustic Emission Source Location in two dimensions by an array of three sensors", Non-Destructive Testing, 9(1), 9-12. https://doi.org/10.1016/0029-1021(76)90027-X
  21. Ziola, S.M. and Gorman, M.R. (1991), "Source location in thin plates using cross-correlation", J. Acoust. Soc. Am., 90, 2551-2556. https://doi.org/10.1121/1.402348