DOI QR코드

DOI QR Code

The Effect of Radiated Electromagnetic Wave by Digital Modulation Signals on the Electronic Devices

디지털 변조 전자기파 방사에 의한 전자기기에 미치는 영향

  • 조원서 (한국산업기술시험원 정보통신기술센터) ;
  • 곽필근 (한국산업기술시험원 정보통신기술센터) ;
  • 박창열 (한국산업기술시험원 정보통신기술센터) ;
  • 양준규 (방송통신위원회 전파연구소 전파환경안전과) ;
  • 금홍식 (한국전파진흥협회 EMC기술지원센터)
  • Published : 2011.02.28

Abstract

With the rapid development of mobile communication technology, the technologies based on the diverse digital modulation schemes have been used for the frequency range of over 800 MHz. The only radiation immunity has been tested using only AM signal based on IEC 61000-4-3 without any consideration of the influence of electromagnetic radiation in Korea. However, it has not been tested by wideband digital modulation signals such as cdmaone(IS-95), WCDMA and PM signal. The purpose of this study was to review the standards. In addition, the input signals were analyzed and tested considering the environments in Korea. The results showed that the devices were influenced by digital modulation signal or PM signal more than by AM signal.

현대 이동 통신 기술의 급격한 발전과 함께 800 MHz 이상의 주파수 대역에서는 다양한 디지털 변조 방식에 의한 기술이 서비스되고 있다. 그러나 국내에서는 전자기파 방사의 영향에 대한 특별한 검토나 연구가 없이 IEC 61000-4-3에 기반한 방사 내성 시험이 AM 신호로만 수행되고 있으며, 광대역 디지털 변조 신호나 cdmaone(IS-95)나 WCDMA 접속 방식에 의한 PM 신호로는 시험되지 않고 있다. 본 연구는 전자기파 방사 내성 시험의 기술 표준을 검토하여, 국내 전파 환경에 적합한 인가 신호를 분석하고 시험하기 위해 수행되었다. 연구 결과로는 AM 신호보다 PM 신호나 디지털 변조 신호 인가 시, 더 큰 영향을 받는 것으로 확인되었다. 본 연구 결과는 국내 통신 기술의 환경에 맞는 정확하고 합리적인 방사 내성의 평가를 위해서는 단편적인 접근이 아닌 대역폭, 물리 채널, 변조 기술, 출력 전력 및 다중화에 의한 신호 등의 복합적 검토와 심층적 연구가 필요함을 보여준다.

Keywords

References

  1. 김남, 신국선, 박성욱, 주은정, "Bluetooth 환경을 고려한 방사 내성 시험 분석", 한국전자파학회 전자파기술, 13(1), pp. 11-18, 2002년 1월.
  2. 유승렬, "자동차 전장 부품의 무선 통신 기기 내성 평가에 관한 국제 규격 동향", 한국전자파학회지 전자파기술, 21(3), pp. 10-15, 2010년 5월.
  3. IEC 61000-4-3, "Electromagnetic compatibility(EMC) - Part 4-3: testing and measurement techniques - radiated, radio-frequency, electromagnetic field immunity test", 2010.
  4. ISO/DIS 11452-1, "Road vehicles - component test methods for electrical disturbances from narrowband radiated electromagnetic energy - part 1: general principles and terminology", 2005.
  5. ISO/DIS 11452-9, "Road vehicles - component test methods for electrical disturbances from narrowband radiated electromagnetic energy - part 9: portable transmitters", 2010.
  6. EN 301 489-6, "Electromagnetic compatibility and radio spectrum matters; electromagnetic compatibility standard for radio equipment and services; part 6: specific conditions for digital enhanced cordless telecommunications(DECT) equipment", 2008.
  7. EN 301 489-13, "Electromagnetic compatibility and radio spectrum matters; electromagnetic compatibility standard for radio equipment and services; part 13: specific conditions for citizens' band radio and ancillary equipment", 2002.