DOI QR코드

DOI QR Code

The tap-scan method for damage detection of bridge structures

  • Xiang, Zhihai (Applied Mechanics Laboratory, Department of Engineering Mechanics, Tsinghua University) ;
  • Dai, Xiaowei (Applied Mechanics Laboratory, Department of Engineering Mechanics, Tsinghua University) ;
  • Zhang, Yao (Applied Mechanics Laboratory, Department of Engineering Mechanics, Tsinghua University) ;
  • Lu, Qiuhai (Applied Mechanics Laboratory, Department of Engineering Mechanics, Tsinghua University)
  • 투고 : 2009.11.20
  • 심사 : 2010.01.20
  • 발행 : 2010.06.25

초록

Damage detection plays a very important role to the maintenance of bridge structures. Traditional damage detection methods are usually based on structural dynamic properties, which are acquired from pre-installed sensors on the bridge. This is not only time-consuming and costly, but also suffers from poor sensitivity to damage if only natural frequencies and mode shapes are concerned in a noisy environment. Recently, the idea of using the dynamic responses of a passing vehicle shows a convenient and economical way for damage detection of bridge structures. Inspired by this new idea and the well-established tap test in the field of non-destructive testing, this paper proposes a new method for obtaining the damage information through the acceleration of a passing vehicle enhanced by a tapping device. Since no finger-print is required of the intact structure, this method can be easily implemented in practice. The logistics of this method is illustrated by a vehicle-bridge interaction model, along with the sensitivity analysis presented in detail. The validity of the method is proved by some numerical examples, and remarks are given concerning the potential implementation of the method as well as the directions for future research.

키워드

과제정보

연구 과제 주관 기관 : National Science Foundation of China

참고문헌

  1. Allemang, R.J. and Brown, D.L. (1982), "Correlation coefficient for modal vector analysis", Proceedings of the 1st International Modal Analysis Conference, Society for Experimental Mechanics, Orlando, 110-116.
  2. Bu, J.Q., Law, S.S. and Zhu, X.Q. (2006), "Innovative bridge condition assessment from dynamic response of a passing vehicle", J. Eng. Mech., 132, 1372-1378. https://doi.org/10.1061/(ASCE)0733-9399(2006)132:12(1372)
  3. Carden, E.P. and Fanning, P. (2004), "Vibration based condition monitoring: a review", Struct. Health Monitor., 3, 355-377. https://doi.org/10.1177/1475921704047500
  4. Cawley, P. and Adams, R.D. (1988), "The mechanics of the coin-tap method of non-destructive testing", J. Sound Vib., 122, 299-316. https://doi.org/10.1016/S0022-460X(88)80356-0
  5. Cawley, P. and Adams, R.D. (1989), "Sensitivity of the coin-tap method of non-destructive testing", Mater. Eval., 122, 299-316.
  6. Farrar, C.R., Doebling, S.W. and Nix, D.A. (2001), "Vibration-based structural damage identification", Philos. T. R. Soc. A, 359, 131-149. https://doi.org/10.1098/rsta.2000.0717
  7. Farrar, C.R. and Worden, K. (2007), "An introduction to structural health monitoring", Philos. T. R. Soc. A, 365, 303-315. https://doi.org/10.1098/rsta.2006.1928
  8. Lin, C.W. and Yang, Y.B. (2005), "Use of a passing vehicle to scan the fundamental bridge frequencies", Eng. Struct., 27, 1865-1878. https://doi.org/10.1016/j.engstruct.2005.06.016
  9. Majumder, L. and Manohar, C.S. (2003), "A time-domain approach for damage detection in beam structures using vibration data with a moving oscillator as an excitation source", J. Sound Vib., 268, 699-716. https://doi.org/10.1016/S0022-460X(02)01555-9
  10. Majumder, L. and Manohar, C.S. (2004), "Nonlinear reduced models for beam damage detection using data on moving oscillator-beam interactions", Comput. Struct., 82, 301-314. https://doi.org/10.1016/j.compstruc.2003.08.007
  11. Xiang, Z.H. and Zhang, Y. (2009), "Change of modal properties of simply-supported plane beams due to damages", Interact. Multiscale Mech., 2, 153-175. https://doi.org/10.12989/imm.2009.2.2.153
  12. Yang, Y.B., Lin, C.W. and Yau, J.D. (2004), "Extracting bridge frequencies from the dynamic response of a passing vehicle", J. Sound Vib., 272, 471-493. https://doi.org/10.1016/S0022-460X(03)00378-X
  13. Yang, Y.B. and Chang, K.C. (2009), "Extraction of bridge frequencies from the dynamic response of a passing vehicle enhanced by the EMD technique", J. Sound Vib., 322, 718-739. https://doi.org/10.1016/j.jsv.2008.11.028
  14. Yang, Y.B. and Chang, K.C. (2009), "Extracting the bridge frequencies indirectly from a passing vehicle: Parametric study", Eng. Struct., 31, 2448-2459. https://doi.org/10.1016/j.engstruct.2009.06.001

피인용 문헌

  1. Using two connected vehicles to measure the frequencies of bridges with rough surface: a theoretical study vol.223, pp.8, 2012, https://doi.org/10.1007/s00707-012-0671-7
  2. Experimental study of a hand-drawn cart for measuring the bridge frequencies vol.57, 2013, https://doi.org/10.1016/j.engstruct.2013.09.007
  3. FREQUENCY VARIATION IN VEHICLE–BRIDGE INTERACTION SYSTEMS vol.13, pp.02, 2013, https://doi.org/10.1142/S0219455413500193
  4. A Smart Washer for Bolt Looseness Monitoring Based on Piezoelectric Active Sensing Method vol.6, pp.12, 2016, https://doi.org/10.3390/app6110320
  5. Mobile impact testing of a simply-supported steel stringer bridge with reference-free measurement vol.159, 2018, https://doi.org/10.1016/j.engstruct.2017.12.020
  6. Filtering techniques for extracting bridge frequencies from a test vehicle moving over the bridge vol.48, 2013, https://doi.org/10.1016/j.engstruct.2012.09.025
  7. Structural Damage Identification of Bridges from Passing Test Vehicles vol.18, pp.11, 2018, https://doi.org/10.3390/s18114035
  8. Effect of road surface roughness on the response of a moving vehicle for identification of bridge frequencies vol.5, pp.4, 2010, https://doi.org/10.12989/imm.2012.5.4.347
  9. Extraction of bridge fundamental frequency from estimated vehicle excitation through a particle filter approach vol.428, pp.None, 2010, https://doi.org/10.1016/j.jsv.2018.04.030