Journal of the Korean Institute of Electrical and Electronic Material Engineers (한국전기전자재료학회논문지)

The Korean Institute of Electrical and Electronic Material Engineers (한국전기전자재료학회)
권호 표지
DOI QR코드

DOI QR Code

A High Voltage LED Drive IC using Voltage Clamp Bias

Voltage Clamp Bias를 사용한 고전압 LED Drive IC

  • Published : 2009.07.01
Download PDF
⟨ Previous Next ⟩

Abstract

Due to the enormous progress achieved in light emitting diodes (LEDs) LEDs have been become a good solution for lightings. In LED driver for lighting applications, it is required high input voltage to drive more LEDs. Therefore, high-voltage should be changed to low-voltage to supply power for drive IC. In this paper, LED drive IC using voltage clamp bias circuit, it use a hysteretic-buck converter topology was proposed and verified through experiments.

Keywords

References

  1. H. Yamagata and N. Hoshimiya, 'Voltage clamp processor system', IEEE transactions of biomedical engineering, Vol. BME-30, No. 2, 1983
  2. R. Miftakhutdinov, 'Analysis of synchronous buck converter with hysteretic controller at high slew rate load current transients', Proc. of High Frequency Power conversion Conference, p. 55, 1999
  3. A. R. Brown and R. D. Middlebrook, 'Sampled- data Modeling of Switching Regulator', p. 349-3 69, 1981
  4. H. Broeck and G. Sauerlander 'Power driver topologies and control schemes for LEDs', IEEE APEC 2007, p. 1319, 2007
  5. K. Smedley and S. Cuk, 'One-cycle control of switching converters', IEEE Trans. Power Electron, Vol. 10, No. 6, p. 625, 1995 https://doi.org/10.1109/63.471281