대한기계학회논문집B (Transactions of the Korean Society of Mechanical Engineers B)

  • 제32권4호
  • /
  • Pages.307-316
  • /
  • 2008
  • /
  • 1226-4881(pISSN)
  • /
  • 2288-5324(eISSN)
대한기계학회 (The Korean Society of Mechanical Engineers)
권호 표지
DOI QR코드

DOI QR Code

냉장고용 핀-튜브 증발기의 착상 성능해석에 관한 연구

Numerical Analysis on the Frosting Performance of a Fin-tube Evaporator for a Refrigerator

  • 발행 : 2008.04.01
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

The objective of this study is to provide numerical and experimental data that can be used to investigate the performance characteristics of a flat plate fin-tube evaporator in household and commercial refrigerators under frosting conditions. Computer simulations with variations of operating conditions such as air inlet temperature, relative humidity, and geometries were performed to find out optimal design parameters of a fin-tube evaporator for household and commercial refrigerators. The tube-by-tube method was used in the simulation and the frost growth model was considered under frosting conditions. The developed analytical model predicted the decreasing rates of heat transfer capacity and air flow rate ratio within ${\pm}$10% compared to the experimental results for a refrigerator under real operating conditions. As a result, the frost thickness at $3^{\circ}C$ & 80% is increased 40% than that of $-3^{\circ}C$ & 80%, and the frost thickness at $3^{\circ}C$ & 90% is increased 30% than that of $3^{\circ}C$ & 60%. Accordingly, the operating time of the evaporator in the refrigerator was reduced with the increase of the decreasing rate of air flow rate ratio at each condition.

키워드

참고문헌

  1. Hiller, C. C. and Glicksman L. R., 1976, 'Improving Heat Performance Via Capacity Control-Analysis and Test,' Vol.I, MIT-EL 76-001, Energy Laboratory, Massachusetts Institute of Technology, pp. 87-98
  2. Fisher, S. K. and Rice, C. K., 1983, 'The Oak Ridge Heat Pump Models: I. A Steady-state Computer Design Model for Air-to-air Heat Pumps,' ORLN/CON-80/RI, Energy Division, Oak Ridge National Lab, pp. 47-64
  3. Chi, J. 1979, 'A Computer Model HTPUMP for Simulation of Heat Pump Steady State Performance,' NBS, Washington D.C
  4. Domanski, P. A., 1989, 'EVSIM-An Evaporator Simulation Model Accounting for Refrigerant and One Dimensional Air Distribution,' NISTIR 89-4133, NIST, Washington D.C
  5. Jonse, B. W. and Parker, J. D., 1975, 'Frost Formation with Varying Environmental Para meters,' Journal of Heat Transfer, Transaction of the ASME, pp. 255-259
  6. Bryan, R. B. and Brian, A. F., 1997, 'Modeling Transport Process in Heat and Mass Releasing Porous Media,' Int. Comm. Heat Mass Transfer, Vol. 24, pp. 439-448 https://doi.org/10.1016/S0735-1933(97)00029-8
  7. Sahin, A. Z., 2000, 'Effective Thermal Conductive of Frost During Crystal Growth Period,' Int. J. of Heat and Mass Transfer, Vol. 43, pp. 539-553 https://doi.org/10.1016/S0017-9310(99)00162-3
  8. Sanders, C. T., 1974, 'The Influence of Frost Formation and Defrosting on the Performance of Air Coolers,' Ph. D. Thesis, Delft Technical University
  9. Schmit, Th. E., 1949, 'Heat Transfer Calculations for Extended Surfaces,' Refrigerating Engineering, pp. 351-357
  10. Sheffield, J. W., Wood, R. A. and Sauer, Jr., H. J., 1989, 'Experimental Investigation of Thermal Conductance of Finned Tube Contacts,' Experimental Thermal and Fluid Science, pp. 894-1777
  11. Wang, C. C. and Chi, K. Y., 2000, 'Heat Transfer and Friction Characteristics of Plain Finand- tube Heat Exchangers, Part I New Exper imental Data,' Int. J. of Heat and Mass Transfer Vol. 43, pp. 2681-2691 https://doi.org/10.1016/S0017-9310(99)00332-4
  12. Wang, C. C., Chi, K. Y. and Chang, C. J., 2000, 'Heat Transfer and Friction Characteristics of Plain Finand- tube Heat Exchangers, Part II: Correlation,' Int. J. of Heat and Mass Transfer Vol. 43, pp. 2693 -2700 https://doi.org/10.1016/S0017-9310(99)00333-6
  13. Gunger, K. E. and Winterton, R. H. S., 1986, 'A General Correlation for Flow Boiling in Tubes and Annuli,' Int. J. Heat and Mass Transfer, Vol. 29, No. 3, pp. 351-358 https://doi.org/10.1016/0017-9310(86)90205-X
  14. Khanpara, J. C., Pate, M. B. and Bergles, A. E., 1987, 'Local Evaporative Heat Transfer in a Smooth and a Micro-fin Tube Using R-22 and R-113,' Winter Annual Meeting of ASME, Boston, Ma., December 13-18
  15. Friedel L., 1979, 'Improved Friction Pressure Drop Correlations for Horizontal and Vertical Two- Phase Pipe Flow,' European Two-Phase Flow Group Meeting, Italy, Paper E2
  16. McAdams, W. H., 1954, Heat Transmission, 3rd ed., McGraw-Hill, New York
  17. Kim Y. H., 2004, 'Study on the Frosting and Defrosting Performance of Finned Tube Heat Exchangers,' Ph. D. Thesis, Korea University, pp.117-127
  18. Lee H. S., 2005, 'Study on the Performance Analysis of Fin-tube Heat Exchangers Under Frosting Conditions,' Master. Thesis, Korea University