Journal of the Korean Geotechnical Society (한국지반공학회논문집)

Korean Geotechnical Society (한국지반공학회)
권호 표지
DOI QR코드

DOI QR Code

A Study on Vibratory Behavior of Steel Sheet Pile Installed in Sand Ground

모래지반에 대한 강널말뚝의 진통항타거동 연구

  • 이승현 (선문대학교 토목공학과) ;
  • 이종구 (포항산업과학연구원 강구조연구소) ;
  • 유완규 (명지대학교 토목환경공학과) ;
  • 김병일 (명지대학교 토목환경공학과)
  • Published : 2007.04.30
Download PDF
⟨ Previous Next ⟩

Abstract

Behaviors of instrumented steel sheet piles which are installed in sand ground by vibratory hammer were investigated. Especially, stresses acting on the pile during vibratory driving, efficiency factor which reflects differences between theoretical driving force and actually delivered acting force, justifiability of rigidity of steel sheet pile, dynamic resistance characteristics of soil and penetration characteristics of sheet pile were analysed. According to the field test results it is justifiable that steel sheet pile behaves as a rigid body during vibratory driving. And it can be seen that maximum stress acting on sheet pile section is far less than tensile strength of the material. Value of the maximum section force at sheet pile head was 72% of that estimated from theoretical equation. Magnitudes of displacement amplitudes computed from displacement-time history curve corresponding to four penetration depths were in the range of 16 $\sim$ 75% of that specified by manufacturer.

모래지반에 대하여 계측기를 부착한 강널말뚝을 진동항타하고 항타과정을 통해서 계측된 자료를 분석하여 진동항타시 강널말뚝의 진동항타거동을 살펴보았다. 특히, 강널말뚝에 대한 진동항타시 말뚝에 작용하는 응력, 이론적인 항타력과 실제 말뚝에 전달되는 힘의 차이를 반영하는 효율계수, 강널말뚝의 강체거동 여부, 지반의 동적 저항특성, 강널말뚝의 관입특성 등을 분석하였다. 강널말뚝의 진동관입시 말뚝은 거의 강체로 거동하였으며 말뚝머리부에 작용하는 응력의 최대값은 재료의 인장강도보다 상당히 작았다. 진동관입중 실제 말뚝머리부에 전달되는 최대하중은 이론식에 의해 계산된 값의 72% 정도였다. 가속도-시간이력곡선으로부터 4개의 관입깊이에 대해 유도된 변위-시간이력곡선에서의 변위진폭값은 진동기 공운전시의 진폭값의 약 16$\sim$75% 정도인 것으로 나타났다.

Keywords

References

  1. Barkan, D. D. (1957), 'Foundation engineering and drilling by vibration method', Proc., Fourth Int. Conf. on Soil Mech. and Found Engrg., 2, pp.3-7
  2. Cudmani, R., Hubert, G., and Gudehus, G. (2002), First International Conference on Vibratory Pile Driving and Deep Soil Compaction in Belgium, September 2002
  3. Holeyman, A. (1993), HYPERVIBI, An analytical model-based computer program to evaluate the penetration speed of vibratory driven sheet piles, Research report prepared for BBRI, June 1993, 16pp
  4. Jonker, G. (1987), 'Vibratory Pile Driving Hammers for Oil Installation and Soil Improvement Projects', Proc. of Nineteenth Annual Offshore Technology Conf., Dallas, Texas, OTC 5422, pp. 549-560
  5. Moulai-Khatir, Reda., O'Neill, Michael W. and Vipulanandan, C. (1994), Program VPDA Wave Equation Analysis for Vibratory Driving of Piles, Report to The U.A, Army Corps of Engineerings Waterways Experiments Station., Dept of Civil and Environmental Engineering, UHCE 94-1, Univ. of Houston, Texas, August 1994, pp.187
  6. Rao., Pramod M. (1993), Effect of pile geometry and soil saturation in the behavior of nondisplacement piles installed by vibration, MSc thesis presented to the Faculty of the Dept. of Civil and Environmental Engineering, University of Houston, Texas
  7. Roger, A.A., and Littlejohn, G. (1980), 'A Study of vibratory driving in granular soils', Geotechnique, Vol.30, No.3, pp.269-293 https://doi.org/10.1680/geot.1980.30.3.269
  8. Viking, K. and Bodare, A. (1998), 'Laboratory studies of dynamic shaft resistance response of a vibro-driven model pile in granular soil by varying the relative density', Proc. to XII European Conference on Soil and Foundation Engineering, pp.6
  9. Viking, K. (2002), Vibro-driveability -a field study of vibratory driven sheet piles in non-cohesive soils, Ph.D thesis 1002, Div. of Soil and Rock Mechanics, Royal Institute of Technology, Stockholm, Sweden, pp.281, ISSN 1650-9501
  10. Warrington, Don. C. (1989), 'Driveability of Piles by Vibration', Paper presented at Deep Foundation Institute 14th Annual Member Conf., pp.139-154
  11. Wong, D., O'Neill, Michael W. and Vipulanandan, C. (1992), 'Modelling of Vibratory Pile Driving in Sand', International Journal for Numerical and Analytical Methods in Geomechanics, Vol.16, 1992, pp.189-210 https://doi.org/10.1002/nag.1610160303