Imaging Science in Dentistry
- 제33권1호
- /
- Pages.35-41
- /
- 2003
- /
- 2233-7822(pISSN)
- /
- 2233-7830(eISSN)
치과 임플란트 수술 계획시 CT를 이용한 상악동 체적 및 치조골량 측정
Measurement of maxillary sinus volume and available alveolar bone height using computed tomography
- 이재학 (단국대학교 치과대학 구강악안면방사선학교실) ;
-
한원정
(단국대학교 치과대학 구강악안면방사선학교실) ;
- 최영희 (단국대학교 의과대학 진단방사선과학교실) ;
-
김은경
(단국대학교 치과대학 구강악안면방사선학교실)
- Lee Jae-Hak (Dept of Oral and Maxillofacial Radiology, School of Dentistry) ;
-
Han Won-Jeong
(Dept of Oral and Maxillofacial Radiology, School of Dentistry) ;
- Choi Young Hi (Dept of Diagnostic Radiology, School of Medicine, Dankook University) ;
-
Kim Eun-Kyung
(Dept of Oral and Maxillofacial Radiology, School of Dentistry)
- 발행 : 2003.03.01
초록
Purpose: To aid in determining the volume of graft bone required before a maxillary sinus lift procedure and compare the alveolar bone height measurements taken by panoramic radiographs to those by CT images. Materials and Methods : Data obtained by both panoramic radiographs and CT examination of 25 patients were used in this study. Maxillary sinus volumes from the antral floor to heights of 5 mm, 10 mm, 15 mm, and 20 mm, were calculated. Alveolar bone height was measured on the panoramic images at each maxillary tooth site and corrected by magnification rate (PBH). Available bone height (ABH) and full bone height (FBH) was measured on reconstructed CT images. PBH was compared with ABH and FBH at the maxillary incisors, canines, premolars, and molars. Results: Volumes of the inferior portion of the sinuses were 0.55 ± 0041 ㎤ for 5 mm lifts, 2.11 ± 0.68 ㎤ for 10 mm, 4.26 ± 1.32 ㎤ for 15 mm, 6.95 ± 2.01 ㎤ for 20 mm. For the alveolar bone measurement, measurements by panoramic images were longer than available bone heights determined by CT images at the incisor and canine areas, and shorter than full bone heights on CT images at incisor, premolar, and molar areas (p<0.001). Conclusion: In bone grafting of the maxillary sinus floor, 0.96 ㎤ or more is required for a 5 mm-lift, 2.79 ㎤ or more for a 10 mm-lift, 5.58 ㎤ or more for a 15 mm-lift, and 8.96 ㎤ or more for a 20 mm-lift. Maxillary implant length determined using panoramic radiograph alone could result in underestimation or overestimation, according to the site involved.