References
- S. Crutzen and P. Jehenson, 'The correlation between ultrasonic techniques, equipment, defect parameters and inspection performanceeffectiveness', Improving the Effectiveness and Reliability of Non-Destructive Testing, edited by W. E. Gardner, Pergamon Press., pp. 193-224 (1992)
- E. Borloo, F. Lakestani and F. Merli, 'PISC II - Parametric study on the effect of ultrasonic characteristics (EEC) on detection, location and sizing,' PISC 1lI Report No. 10 - Final report, Available from Commission of the European Communities, Joint Research Center, Ispra, Italy (July, 1988)
- D. E. MacDonald and S. M. Walker, 'Effects of ultrasonic equipment variations on crack length measurements,' EPRl NP - 5485, 1987, Available from EPRl Research Reports Center, PO Box 504901, Palo Alto, CA 94305
- G. J. Posakony, 'Experimental analysis of ultrasonic responses from artificial defects,' Materials Evaluation, Vol. 44, No. 13, pp. 1567-1572 (Dec., 1986)
- N. F. Haines, S. Cruzen and C. J. Vinehc, 'A review of the major PISC II Round-robin test results,' British Journal of NDT, pp. 411-417 (Nov., 1987)
- S. Crutzen, P. Jehenson and E. Borloo, 'The PISC II - RRT Plates and their intended defects', British Journal of NDT, pp. 307- 317 (Sep., 1987)
- E. R. Green, 'Worst case defects affecting ultrasonic inspection reliability,' Materials Evaluation, Vol. 47, pp. 1401-1407 (Dec.,1969)
- F. V. Ammirato, GEC, Knolls Atomic Power Laboratory, Schenectady, New York, 'The influencing of reference defect geometry, beam angle and frequency on shear wave ultrasonic test sensitivity,' Materials Evaluation, pp. 45-48 (Feb., 1976)
- ASME Section XI, Appendix III
- M. Manimohan, N. D hanasekaran, R J. Pardikar et aI., 'Reliability of manual ultrasonic testing in boiler and pressure vessels,' Journal of Non-Destructive Evaluation, Vol. 16, No.4, pp. 99-101 (Oct-Dec., 1996)
- E. E. Borloo, 'PISC II - Parametric studies, RRT on the measurement of ultrasonic instrument and transducer characteristics (MITC),' International Journal of Pressure Vessels & Piping, Vol. 35, Nos. 1-4
- A. B. Wooldridge and R. K. Chapman, 'The Effective use of ultrasonic for defect detection ands sizing in steel components,' Improving the Effectiveness and Reliability of Non-Destructive Testing, Edited by W. E. Gardner, Pergamon Press, Oxford, UK, pp. 87-136 (1992)
- B. Watkins, R. W. Errine and K. J. Cowburn, 'The UKAEA defect detection trials,' British Journal of Non-Destructive Evaluation, Vol. 25, No.4 (July, 1983)
- J. Krautkramer and H. Krautkramer, 'Ultrasonic testing of materials,' 3rd Edition, Springer-Verlag, Berlin, Germany (1983)
- Giuliano Canella, 'Resonance's and effects of couplant layers in ultrasonic contact testing', Materials Evaluation, pp. 61-66 (April, 1973)
- Johan Enkrist, Anne Edland and Ola Svenson, 'Operator performance in a blind test piece trial,' Materials Evaluation, Vol. 59, No.4, pp. 531-536 (April, 2001)
- R. A. Murgatroyd, H. Serd, S. Crutzen and Van Den Bergh, 'Human Reliability Studies in P1SC Ill,' 10th International Conference on NDE in the Nuclear and Pressure Vessel Industry, Glasgow, UK (June, 1990)
- T. T. Taylor, J. C. Spanner, Sh. P. G. Heasler, S. R. Doctor and J. D. Deffenbaugh, 'An evaluation of human reliability in ultrasonic In-service inspection for intergranular stress- corrosion cracks through round-robin testing,' Materials Evaluation, (March, 1989)