International Journal of Precision Engineering and Manufacturing

Korean Society for Precision Engineering (한국정밀공학회)
권호 표지

Development of a Virtual Machine Tool - Part 2: Dynamic Cutting Force Model, Thermal Behavior Model, Feed Drive System Model, and Comprehensive Software Environment

  • Published : 2003.05.01
Download PDF
⟨ Previous Next ⟩

Abstract

In Part 2 of this paper, the dynamic cutting force model, thermal behavior model, and feed drive model used in the development of a virtual machine tool (VMT) are briefly described. Some results are presented to verify the proposed models. Experimental data agreed well with the predicted results fer each model. A comprehensive software environment to integrate the models into a VMT is also proposed.

Keywords

References

  1. Ehmann, K. F., DeVor, R. E., De Meter, E. C., Domfeld, D., Kapoor, S. G., Ni, J., Rajukar, K., Shin, Y. and Sutherland, J., 'A Framework For a Virtual Machine Tool (VMT),' Trans. of NAMRI/SME, Vol. XXI, pp. 143-148, 1998
  2. Yun, W. S., Ko, J. H. and Cho, D. W., 'Development of a Virtual Machine Tool - Part 1,' International Journal of the KSPE, Vol. 4, No. 3, pp. 71-76, 2003
  3. Takata, S., Tsai, M. D. and Sata, T, 'A Cutting Simulation System for Machinability Evaluation using a Workpiece Model,' Annals of the CIRP, Vol. 38(1), pp. 417-420, 1989 https://doi.org/10.1016/S0007-8506(07)62736-X
  4. Hwang, C. H. and Cho, D. W, 'Chatter Prediction in End Milling Using Dynamic Cutting Force Modeling,' Journal of the KSPE, Vol. 16, No. 2, pp. 104-115, 1999
  5. Tlusty, J., Smith. S. and Zamudio, C., 'New NC Routines for Quality in Milling,' Annals of the CIRP, Vol. 40, No.1, pp. 517-521, 1990
  6. Kang, S. J., Cho, D.W. and Chun, C.K., 'Evaluation Stability of a Transient Cut during Endmilling using the Dynamic Cutting Force Model,' International Journal of the KSPE, Vol. 1, No. 2, pp. 67-75, 2000
  7. Yang, S., Yuan, J. and Ni, J., 'The Improvement of Thermal Error Modeling and Compensation on Machine Tools by CMAC Neural Network,' International Journal of Machine Tools and Manufacture, Vol. 36, No. 4, pp. 527-537, 1996 https://doi.org/10.1016/0890-6955(95)00040-2
  8. Lee, K. I. and Cho, D. W., 'Development of Thennally Induced Machine Tool Error Using Modified Neural Network,' KSPE Conference, Seoul, Korea Univ., pp. 226-230, 1999
  9. Ahn, K.G. and Cho, D.W., 'In-process Modeling and Estimation of Thermally Induced Errors of a Machine Tool During Cutting,' The International Journal of Advanced Manufacturing Technolo, Vol. 15, pp. 299-304, 1999 https://doi.org/10.1007/s001700050070
  10. Yun, S. H., 'Adaptive Control of Milling Force by Indirect Measurement of Cutting Forces,' M.S Thesis, POSTECH, 1999