Wind and Structures

Techno-Press (테크노프레스)
권호 표지
DOI QR코드

DOI QR Code

A 6 m cube in an atmospheric boundary layer flow -Part 1. Full-scale and wind-tunnel results

  • Hoxey, R.P. (Silsoe Research Institute) ;
  • Richards, P.J. (Silsoe Research Institute) ;
  • Short, J.L. (Silsoe Research Institute)
  • Published : 2002.04.25
⟨ Previous Next ⟩

Abstract

Results of measurements of surface pressure and of velocity field made on a full-scale 6 m cube in natural wind are reported. Comparisons are made with results from boundary-layer wind-tunnel studies reported in the literature. Two flow angles are reported; flow normal to a face of the cube (the $0^{\circ}$ case) and flow at $45^{\circ}$. In most comparisons, the spread of wind-tunnel results of pressure measurements spans the full-scale measurements. The exception to this is for the $0^{\circ}$ case where the roof and side-wall pressures at full-scale are more negative, and as a result of this the leeward wall pressures are also lower. The cause of this difference is postulated to be a Reynolds Number scale effect that affects flow reattachment. Measurements of velocity in the vicinity of the cube have been used to define the mean reattachment point on the roof centre line for the $0^{\circ}$ case, and the ground level reattachment point behind the cube for both $0^{\circ}$ and $45^{\circ}$ flow. Comparisons are reported with another full-scale experiment and also with wind-tunnel experiments that indicate a possible dependency on turbulence levels in the approach flow.

Keywords

References

  1. Baines, W.D., (1963), "Effects of velocity distribution on wind loads and flow patterns on buildings", Proc. Symp. No. 16 Wind Effects on Buildings and Structures, NPL, UK.
  2. Castro, I.P. and Robins, A.G. (1977), "The flow around a surface-mounted cube in uniform and turbulent streams", J. Fluid Mech. 79 pt 2, 307-335. https://doi.org/10.1017/S0022112077000172
  3. Holscher, N. and Niemann, H-J., (1998), "Towards quality assurance for wind tunnel tests: A comparative testing program of the Windtechnologische Gesellschaft", J. Wind. Eng. Ind. Aerod., 74-76, 599-608. https://doi.org/10.1016/S0167-6105(98)00054-3
  4. Hunt, A., (1982), "Wind-tunnel measurements of surface pressures on cubic building models at several scales", J. Wind. Eng. Ind. Aerod. 10, 137-163. https://doi.org/10.1016/0167-6105(82)90061-7
  5. Minson, A.J., Wood, C.J. and Belcher, R.E., (1995), "Experimental velocity measurements for CFD validation", J. Wind Eng. Ind. Aerod., 58, 205-215. https://doi.org/10.1016/0167-6105(95)00025-9
  6. Moran, P. and Hoxey, R.P., (1979), "A probe for sensing static pressure in two-dimensional flow", J. Phys. E: Sci. Instrum., 12, 752-753. https://doi.org/10.1088/0022-3735/12/8/021
  7. Murakami, S. and Mochida, A., (1990), "3-D numerical simulation of airflow around a cubic model by means of the ${\kappa}-{\varepsilon}$ model", J. Wind Eng. Ind. Aerod., 31, 283-303, 1988.
  8. Ogawa, Y., Oikawa, S. and Uehara, K., (1983), "Field and wind tunnel studies of the flow and diffusion around a model cube - 1. Flow measurements", Atmospheric Environment, 17, 6, 1145-1159. https://doi.org/10.1016/0004-6981(83)90338-4
  9. Sakamoto, H. and Arie, M. (1982), "Flow around a cubic body immersed in a turbulent boundary layer", J. Wind Eng. Ind. Aerod. 9, 275-293. https://doi.org/10.1016/0167-6105(82)90020-4
  10. Simiu, E. and Scanlan, R.H. (1996), Wind Effects on Structures, Wiley-Interscience, 1996.
  11. Stathopoulos, T. and Dumitrescu-Brulotte, M. (1989), "Design recommendations for wind loading on buildings of intermediate height", Can. J. Civ. Eng., 16, 910-916. https://doi.org/10.1139/l89-134

Cited by

  1. Wind loads on the roof of a 6m cube vol.96, pp.6-7, 2008, https://doi.org/10.1016/j.jweia.2007.06.032
  2. Pressures on a cubic building—Part 1: Full-scale results vol.102, 2012, https://doi.org/10.1016/j.jweia.2011.11.004
  3. Numerical and wind tunnel simulation of pollutant dispersion in the near wake of buildings vol.8, pp.6, 2005, https://doi.org/10.12989/was.2005.8.6.427
  4. A wind-tunnel investigation into the pressure distribution around sheet-clad scaffolds vol.103, 2012, https://doi.org/10.1016/j.jweia.2012.03.004
  5. A 6 m cube in an atmospheric boundary layer flow -Part 2. Computational solutions vol.5, pp.2_3_4, 2002, https://doi.org/10.12989/was.2002.5.2_3_4.177
  6. Evaluation of a fast response pressure solver for flow around an isolated cube vol.10, pp.3, 2010, https://doi.org/10.1007/s10652-009-9152-5
  7. On the use of numerical modelling for near-field pollutant dispersion in urban environments − A review vol.208, 2016, https://doi.org/10.1016/j.envpol.2015.07.039
  8. Numerical Model Inter-comparison for Wind Flow and Turbulence Around Single-Block Buildings vol.16, pp.2, 2011, https://doi.org/10.1007/s10666-010-9236-0
  9. On the domain size for the steady-state CFD modelling of a tall building vol.15, pp.4, 2012, https://doi.org/10.12989/was.2012.15.4.313
  10. Measurements of the performance of a wind-driven ventilation terminal vol.163, pp.2, 2010, https://doi.org/10.1680/stbu.2010.163.2.129
  11. Influence of spacing between buildings on wind characteristics above rural and suburban areas vol.11, pp.5, 2008, https://doi.org/10.12989/was.2008.11.5.413
  12. Unsteady flow on the sides of a 6m cube vol.90, pp.12-15, 2002, https://doi.org/10.1016/S0167-6105(02)00293-3
  13. LES modelling of unsteady flow around the Silsoe cube vol.144, 2015, https://doi.org/10.1016/j.jweia.2015.03.018
  14. Study of Atmospheric Boundary Layer Flows over a Coastal Cliff vol.29, pp.1, 2005, https://doi.org/10.1260/0309524054353719
  15. Flow reattachment on the roof of a 6m cube vol.94, pp.2, 2006, https://doi.org/10.1016/j.jweia.2005.12.002
  16. A methodology for the measurement of distributed agricultural sources of ammonia outdoors—Part 1: validation in a controlled environment vol.39, pp.4, 2005, https://doi.org/10.1016/j.atmosenv.2004.10.023
  17. Detached Eddy Simulation of Atmospheric Flow About a Surface Mounted Cube at High Reynolds Number vol.133, pp.3, 2002, https://doi.org/10.1115/1.4003649
  18. Large eddy simulation of dispersion of hazardous materials released from a fire accident around a cubical building vol.28, pp.36, 2002, https://doi.org/10.1007/s11356-021-13604-3
  19. CFD simulation of flow fields and pollutant dispersion around a cubic building considering the effect of plume buoyancies vol.208, pp.None, 2002, https://doi.org/10.1016/j.buildenv.2021.108640