Abstract
The CellCaSi, a porous silicate material, was tested for the removal of phosphorus (P as phosphate) in water. The effect of the CellCaSi was investigated on the basis of both particle size (under 1,2, and 4 mm) and added amount (0, 1, 2.5, 5, and 10 g/1) of the CellCaSi. The removal efficiency of phosphorus was highest with a particle size of under 1 mm and also increased with an increasing amount of the CellCaSi. The pH change showed little effect on the phosphorus removal of the CellCaSi. The calcium ion was eluted from the CellCaSi into the water, while the aluminium and iron were not. The eluted calcium ion was combined with dissolved phosphorus and then precipitated. The highest removal efficiency of phosphorus was obtained by the combined addition of the CellCaSi, calcium chloride, and ferric chloride. That is, the phosphorus concentrations of 0.10 and 1.0 mg/1 decreased to 0.03 and 0.47 mg/l by the addition of the CellCaSi (1 g/l), calcium ion (30 mg/l), and ferric ion (1 mg/l) at day 8 after treatment. The water qualities at the end of the experiment were as follows: pH was 8.1 and conductivity was 318 ${\mu}$S/cm (a registered maximum conductivity of 500${\mu}$S/cm for raw and potable wafers).
녹조 제어를 위하여 수중의 인 제거에 관여하는 CellCaSi의 여러 가지 조건별 인 제거효과를 조사하였다. CellCaSi의 입도에 따른 인 제거효과는 직경 1, 2 그리고 4mm 이하의 3가지 중 1mm 이하의 작은 입자를 사용했을 때 가장 우수하였다. CellCaSi의 인 제거효과는 처리량의 증가에 비례하였다. 수중의 pH 5, 7, 9에서 초기 인 농도 0.20mg/l는 각각 0.09, 0.08및 0.08mg/l로 감소되어 상이한 pH조건에 따른 CellCaSi의 인 제거효과는 큰 차이를 보이지 않았다. CellCaSi에서 용출되는 양이온은 Ca이며, Al과 Fe양이온은 검출되지 않았다. 초기에 급격히 용출된 Ca양이온은 수중의 인과 반응하는 것으로 확인되었다. 초기 인 농도 0.10, 1.0mg/1는 CellCaSi와 Ca, Fe 화합물을 첨가한 처리구에서 8일 후 각각 0.03,0.47mg/l를 기록하며 가장 많이 감소하였다. 이에 따라 인 제거효과는 CellCaSi와 Ca, Fe 화합물을 동시에 처리하였을 때 가장 좋은 것으로 조사되었다. CellCaSi의 처리에 따라 pH가 약간 증가하였고, 전기전도도도 증가되지만 상수원수 기준 허용치 (500${\mu}$S/cm) 이내였다.