초록
본 논문에서는 W-CDMA 이용한 10 [MHz]의 채널 대역폭을 갖는 다중채널 무선가입자망 단말기용 RF-모듈을 설계 제작하였다. RF-모듈은 송수신전단, 주파수합성기, 변복조기 및 전력제어회로로 구성하였다. 제작한 RF-모듈에 대한 시험결과 송신전력은 250 [mW], 통과대역내의 진폭과 위상왜곡을 측정한 전력의 평탄도는 ${\pm}1.5[dB]$를 얻었다. 또한 송신시 확산신호의 Chip Rate는 8.312 [Mcps]를 얻었고, 주파수합성기에 대한 측정결과는 RF 대역과 변복조를 위한 국부발진신호 주파수는 설계규격을 만족하였다. 수신전계강도특성과 AGC의 동작범위는 모두 60 [dB]로 만족하였고, RF-모듈과 기저대역과의 연동여부를 확인하기 위해 페이저도와 눈패턴을 측정한 결과 좋은 결과를 얻었다.
In this paper, the RF-modules composed of front-end, frequency synthesizer, modulator/demodulator and power control multi channel WLL personal system for W-CDMA using 10 [MHz] RF channel bandwidth has been implemented and considered. The measured transmission power is 250 [mW] which is very close to the required value. The measured flatness of power at the final output stage is ${\pm}1.5[dB]$ over the required bandwidth of the receiver. In addition, it is found that the chip rate transmitting spread signal is set to 8.192 [MHz], the required rate. The frequencies of RF_LO signal and LO signal of the modulator and the demodulator measured by a frequency synthesizer are satisfied with design requirements. The operating range of the receiving strength signal indicator and AGC units shows 60 [dB] respectively. Also the measured phasor diagram and eye pattern for deciding the RF modules compatible with baseband digital signal processing part are shown good results.