초록
강부재의 현장조립시 부재간의 불일치 등으로 인하여 볼트 구멍의 확장을 통해 볼트 삽입을 용이하게 할 필요가 발생한다. 그러나, 국내 시방기준에는 과대공에 대한 규정이 없고, 이에 대한 연구도 전무한 실정이다. 따라서 본 연구에서는 볼트 구멍의 크기, 표면처리 조건 및 볼트의 체결력을 변수로 하여 정적 인장시험을 실시하여 이들 인자가 이음부의 미끄러짐 거동에 미치는 영향을 조사하였다. 그 결과, 소정의 미끄러짐 하중을 확보하기 위해서는 표면을 숏블라스트 처리할 경우는 체결력이 충분히 확보되어야 하지만, 징크리치 프라이머의 경우는 체결력이 다소 떨어진다 하더라도 소정의 미끄러짐 하중을 확보하는데 있어 용이함을 알 수 있었다. 한편. 숏블라스트 및 징크리치 프라이머 시험편 모두 직경 26mm의 과대공에서의 미끄러짐 계수의 차이는 표준공과 비교하여 거의 없는 것으로 판단된다.
In field fabrication of steel members, the oversize hole is frequently required due to reaming and mismatching. But, there are no provisions and investigations about oversize hole in the Korean specifications. So, in this study, the tension test of friction type high-tention bolted joints is performed with parameters of bolt hole size, surface treatment and tightening force, and investigate the effect of slip behavior with those parameters. From the results, the enough tightening force is needed to obtain some degree slip load in shot blast treatment case, although tightening force is reduced somewhat, it is no problem to guarantee slip load in zincrich primer case. The slip behavior of joints with oversize hole(26mm) is similar to the slip behavior of joints with hole of nominal size.