폴리머 피뢰기의 구조에 따른 온도와 누설전류 특성

Temperature and Leakage Current Characteristics with Structure of Polymeric Surge Arresters

  • Cho, Han-Goo (Korea Electrotechnology Research Institute) ;
  • Lee, Un-Yong (Korea Electrotechnology Research Institute) ;
  • Kim, Ha-Na (Korea Electrotechnology Research Institute)
  • 발행 : 2006.06.22

초록

This paper presents the temperature characteristics with the structure of 18 kV surge arresters for distribution system. Three types of polymer arrester were fabricated and a ceramic arrester was also prepared to investigate. Below $100^{\circ}C$, three types of polymeric arresters exhibited almost the same leakage current value, but above $100^{\circ}C$, the polymeric arresters whose module was injected into polymeric housing with the grease exhibited the highest leakage current. In contrary, the arresters being manufactured by directly injecting silicone rubber onto arrester module exhibited the lowest leakage current. The rapid rising of leakage current of the polymeric arresters with the grease at $120^{\circ}C$ was because of the deterioration of the insulation characteristics of the grease between the FRP module and the silicone housing. All polymeric arresters exhibited the same surface temperature characteristics but the ceramic arresters was slower than the polymer arrester in heat emission despite the lowest leakage current. It was thought that the air layer between ZnO varistor blocks and the ceramic housing prevented the heat emission.

키워드