Design of the timing controller for automatic magnetizing system

In this paper a VLSI design for the automatic magnetizing system has been presented. This is the design of a peripheral controller, which magnetizes CRTs and computers monitors and controls the automatic inspection system. We implemented a programmable peripheral interface(PPI) circuit of the control and protocol module for the magnetizer controller by using a O.8um CMOS SOG(Sea of Gate) technology of ETRI. Most of the PPI functions has been confirmed. In the conventional method, the propagation/ramp delay model was used to predict the delay of cells, but used to model on only a single cell. Later, a modified "apos;Linear delay predict model"apos; was suggested in the LODECAP(LOgic Design Capture) by adding some factors to the prior model. But this has not a full model on the delay chain. In this paper a new "apos;delay predict equationapos;" for the design of the timing control block in PPI system has been suggested. We have described the detail method on a design of delay chain block according to the extracted equation and applied this method to the timing control block design.