• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.16 no.12
• /
• pp.1150-1154
• /
• 2003

The voltage profile during discharge of the zinc air battery has very flat pattern until reach to end of discharge voltage. But, when zinc air battery is discharged by high current, the discharge voltage and energy becomes low. Therefore, we focused on effects of catalyst size to solve this problems by increasing active sites of oxygen reduction reaction. The size of catalyst was reduced from 27 to l${\mu}{\textrm}{m}$ and we examined average discharge voltage, capacity, energy, resistance and characteristics during GSM pulse discharge of zinc air battery with change of current density. And we also measured porosity of the cathode according to the ASTM. So we have got improvement of average discharge voltage and energy when catalyst was minimized and we have got optimum size of catalyst at 5${\mu}{\textrm}{m}$.

• Transactions on Electrical and Electronic Materials
• /
• v.17 no.1
• /
• pp.46-49
• /
• 2016

A thin film transistor (TFT) has been fabricated using the amorphous 0.5 wt% Si doped zinc-tin-oxide (a-0.5 SZTO) with different electrodes made of either aluminium (Al) or titanium/aluminium(Ti/Al). Contact resistance and total channel resistance of a-0.5SZTO TFTs have been investigated and compared using the transmission line method (TLM). We measured the total resistance of 1.0×10² Ω/cm using Ti/Al electrodes. This result is due to Ti, which is a material known for its adhesion layer. We found that the Ti/Al electrode showed better contact characteristics between the channel and electrodes compared with that made of Al only. The former showed a less contact and total resistance. We achieved high performance of the TFTs characteristic, such as Vth of 2.6 V, field effect mobility of 20.1 cm² V⁻¹s⁻¹, S.S of 0.9 Vdecade⁻¹, and on/off current ratio of 9.7×10⁶ A. It was demonstrated that the Ti/Al electrodes improved performance of TFTs due to enhanced contact resistance.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.20 no.9
• /
• pp.798-801
• /
• 2007

Multilayer transparent electrodes, having a much lower electrical resistance than the widely used transparent conducting oxide electrodes, were prepared by using radio frequency magnetron sputtering. The multilayer structure consisted of five layers, indium tin oxided (ITO)/zinc oxide (ZnO)/Ag/zinc oxide (ZnO)/ITO. With about 50 nm thick ITO films, the multilayer showed a high optical transmittance in the visible range of the spectrum and had color neutrality. The electrical and optical properties of ITO/ZnO/Ag/ZnO/ITO multilayer were changed mainly by Ag film properties, which were affected by the deposition process of the upper layer. Especially ZnO layer was improved to adhesion of Ag and ITO. A high quality transparent electrode, having a resistance as low as and a high optical transmittance of 91% at 550 nm, was obtained. It could satisfy the requirement for the flexible OLED and LCD.

• Journal of the Korean Dietetic Association
• /
• v.13 no.4
• /
• pp.301-310
• /
• 2007

The purpose of this study was to analyze the relationships among zinc status, protein and phytate intake, and diabetic control indices of type 2 diabetic women. The mean age and the duration of diabetes were respectively 57.9±6.9 years old and 8.0±6.5 years. The mean daily energy intake of diabetic subjects was 1562 kcal. Both the zinc intake (6.2mg/day) and the zinc %RI (% of The Recommended Intake for zinc: 79.5%) of the diabetic participants were significantly lower than those of the control group (respectively p<0.01). As for the diabetic group, the higher the energy intake (kcal/day), the higher were the zinc intake (p<0.001) and %RI for zinc (p<0.001). Zinc intake was positively correlated with the protein (p<0.001), animal protein (p<0.001), and fat intake (p<0.001), but negatively correlated with the carbohydrate intake (p<0.001). Foods with high amount of phytate were the major source of zinc (p<0.01), but did not contribute to high zinc densities. The urinary zinc excretion was twice as high as in the diabetic group compared to the control group (p<0.001). In addition, the urinary zinc loss was positively correlated with the duration of diabetes (p<0.05), hyperglycemia (p<0.001) and insulin resistance (p<0.05). %RI for zinc was negatively correlated with the HbA1C (p<0.05). These results lead us to conclude that the appropriate intake of energy controlled by diet therapy could improve the total zinc intake and %RI for zinc in diabetic women. Also, normal blood glucose level controlled by diet therapy could improve the hyperzincuria. Dietetic practitioners should encourage consumption patterns that provide zinc-rich foods in the form of animal protein to improve the bioavailability as well as the total daily intake of zinc.

• International Journal of Korean Welding Society
• /
• v.2 no.1
• /
• pp.1-10
• /
• 2002

The thermal contact conductance at different temperatures and with different electrode forces and zinc coating morphology was measured by monitoring the infrared emissions from the one dimensionally simulated contact heat transfer experiments. The contact heat transfer coefficients were presented as a function of the harmonic mean temperature of the two contacting surfaces. Using these contact heat transfer coefficients and experimentally measured temperature profiles, the electrical contact resistivities both for the faying interface and electrode-workpiece interface were deduced from the numerical analyses of the one dimension simulation welding. It was found that the average value of the contact heat transfer coefficients for the material with zinc coating (coating weight from 0 g/$mm^2$to 100 g/$mm^2$) ranges from 0.05 W/$mm^2$$^{\circ}C$ to 2.0 W/$mm^2$$^{\circ}C$ in the temperature range above 5$0^{\circ}C$ harmonic mean temperature of the two contacting surfaces. The electrical contact resistivity deduced from the one dimension simulation welding and numerical analyses showed that the ratio of electrical contact resistivity at the laying interface to the electrical contact resistivity at the electrode interface is smaller than one far both bare steel and zinc coated steel.

• Journal of the Korean Professional Engineers Association
• /
• v.14 no.4
• /
• pp.15-25
• /
• 1981

Electrical behaviors of the divalent silver oxide-zinc cell were analyzed for imporving capacity and keeping electrodes from passivation or sharp increases of cell internal resistance in the course of discharge. One of primary factors in relation to lowering performance can be depicted by cell internal resistance increase being created by various routes, first by insufficiency and/or the carbonation of the electrolyte, secondly by barrier blockage, thirdly by electrode passivation which are due to improper material use of wrong processing, and by gassing as fourth cause. The carbonation causes electrobyte to have impedance up as well as poor amalgamation, resulting in vigorous corrosion reaction of copper plated inner top, evolving hydrogen gas. Electrical characteristics of the cell was reviewed to elucidate relationships between the discharge capacity and the cell internal resistance.

• Corrosion Science and Technology
• /
• v.11 no.1
• /
• pp.15-19
• /
• 2012

Both electrogalvanized and hot-dip galvanized steel sheets have been finally produced via organic-inorganic surface coating process on the zinc surface to enhance corrosion resistance and afford additional functional properties. Recently, POSCO has been developed a variety of chromate-free coated steels that are widely used in household, construction and automotive applications. New organic-inorganic hybrid coating solutions as chromate alternatives are comprised of surface modified silicate with silane coupling agent and inorganic corrosion inhibitors as an aqueous formulation. In this paper we have prepared new type of hybrid coatings and evaluated quality performances such as corrosion resistance, spot weldability, thermal tolerance, and paint adhesion property etc. The electrogalvanized steels with these coating solutions exhibit good anti-corrosion property compared to those of chromate coated steels. Detailed components composition of coating solutions and experimental results suggest that strong binding between organic-inorganic hybrid coating layer and zinc surface plays a key role in the advanced quality performances.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.59 no.7
• /
• pp.1259-1264
• /
• 2010

This paper was researched about effectiveness of the electrochemical cell which is composed of the sea water and the Cu/Zn electrode. The electric potential difference between copper and zinc finally reached 0.51 volts. Short current decreased with time. It might depend on the electromotive force decreasing. Confirmed the load resistance and electrode affect in electromotive force and electric current. The resistance which shows a maximum output power was 20[$\Omega$], and the maximum output power from this resistance was evaluated as 0.736mW. In order to calculate the energy which creates from electrochemical cell, charging voltage of the capacitor with various capacitance was investigated. It was found that energy harvesting possibility of the cell which is made of a sea water electrolyte and the copper/the zinc.

• Journal of Energy Engineering
• /
• v.12 no.4
• /
• pp.302-308
• /
• 2003

The peformence tests of zinc-based desulfurization sorbents using the yellow earth as support for the hot gas clean up were carried out. The zinc-based sorbent with 25 wt％ yellow earth was prepared, and their properties such as the reaction rate, the sulfur capacity and the attrition resistance, were investigated. The reactivity tests for hot gas desulfurization was performed at middle temperatures (sulfidation/regeneration：480$^{\circ}C$/580$^{\circ}C$). During multi-cyclic desulfurization, the deactivation of zinc-based sorbent was decreased by the addition of yellow earth, and their efficiency was enhanced. The ZnO/yellow earth sorbent had high reactivity, good regenerability, long-term durability (about 19 gS/100 g sorbent for 10-cycles) and high attrition resistance (AI=19.1％). It was concluded that the peroperties of zinc-based sorbent were improved by metal oxides (Fe$_2$O$_3$, Na$_2$O, MnO$_2$, etc) in the yellow earth. From these results, it was confirmed that the desulfurization properties of zinc-based sorbents at middle temperatures could be improved by the yellow earth using as support.

• Applied Chemistry for Engineering
• /
• v.10 no.2
• /
• pp.183-189
• /
• 1999

Zinc-based sorbents for $H_2S$ removal were prepared. The reactivity of sorbents was investigated by the successive cycles of sulfidation-regeneration at $650^{\circ}C$ in a fixed bed reactor. The desulfurization sorbents were prepared with granulation method to produce a spherical pellet with good attrition resistance. The fresh and reacted sorbents were characterized by X-Ray Diffraction (XRD) and X-Ray Photoelectron Spectroscopy (XPS) and the characteristics of sorbents on calcination conditons were analysed by Mercury Porosimetery and BET. The reactivity of sorbents decreased as the number of sulfidation-regeneration cycle increased. It is due to the zinc loss and the increase of the diffusion resistance by sintering, cracking and spalling of sorbents at the high temperature.