• Journal of Environmental Health Sciences
• /
• v.8 no.1
• /
• pp.31-43
• /
• 1982

Seventy-seven Mugil cephalus of spinal deformation, living in Hanam, Nogsan, and Myeongji area, the downstreams of the Nagdong River, were collected in order to determine their forms and the levels of heavy metal contamination between March and October, 1981. The specimens were examined by X-ray and content of cadmium, lead, copper, and zinc by atomic absorption spectrophotometer. The results were summarized as follows: 1. The rate of appearance of deformational fish to the total Mugil cephflus were 4.3% (13 fish), 5.7% (17 fish), relatively high in May and June (dry season). Meanwhile during March and October they were low by 1.0% (3 fish), 2.0% (6 fish). As far as the research areas are concerned, they appeared in larger numbers in downstreams than in upper streams Myeongji (39), Nogsan (25), and Hanam (13). 2. Concerning with fractured parts of vertebraes,86 percent (66 out of 77) had their caudal regions fractured and 72 percent (55) their first to seventh caudal regions fractured. 3. The average levels of cadmium, lead, copper, zinc detected from flesh were 0.26ppm, 2.06ppm, 6.35ppm, 0.85ppm on the other hand, they were 0.22ppm, 1.84ppm, 5.03ppm, 0.93ppm in normal fish. 4. The average levels of cadmium, lead, copper, zinc measured in the bones were 0.39ppm, 2.55ppm, 8.97ppm, 2.73ppm. Meanwhile, from normal fish they were 0.33ppm, 2.25ppm, 7.24ppm, 2.42ppm. 5. Compared with regional heavy metal contamination such as cadium, lead, zinc, Myeongji area had higher contamination content than Nogsan area Nogsan area than Hanam area. 6. Compared with heavy metal contamination level in their tissues, cadmium was highly found in bones Lead and copper were highly detected in viscera. Particularly in skeleton cadmium was 560 times, zinc 160 times in proportion to those in the downstreams of the Nagdong River.

• Journal of the Korean Ceramic Society
• /
• v.24 no.3
• /
• pp.227-234
• /
• 1987

With the content of ZnO varing from 10.5 to 47.4 wt%, the crystallization of lithium zinc silicate glass was investigated by DTA, XRD, and SEM. In this work P2O5 was used as nucleation agent. The crystallization temperature was found to increase with the content of ZnO and the microstructure of formed crystalling phases was studied through the scanning electron microscopy. According to the XRD analysis, the crystal phases formed are summarized as follows. 1) The major phases are lithium orthosilicate, lithium disilicate and quartz at 10.5 wt% ZnO. 2) Lithium zinc silicate polymorphous and cristobalite occur in the composition varying 21.3 to 30.8 wt% ZnO. 3) At composition containing 47.4wt% ZnO some quantity of willemite is formed.

• Journal of Nutrition and Health
• /
• v.17 no.2
• /
• pp.137-144
• /
• 1984

Due to the fact that blood gathering is not readily accepted by people, it has been difficult to make a full-scale study on zinc through blood analysis. For that reason, in this paper, a correlation of zinc contents in serum and hair was studied to find out whether only hair, which is relatively easy to collect, can be used for a measurement of zinc content. The subjects were 47 healthy female collegians selected at random whose average age was 22, mean height 159.1cm and average weight 49.7kg. The mean zinc value in serum of subjects was ${107.1}\pm{29.0}{\mu}g{/100ml}$, while the mean value in hair was ${150.2}\pm{42.7}ppm$. Correlation analysis shows that there was a significant correlation in zinc contents of serum and hair ( p<0.01). The results shows that measuring zinc level by using only hair samples would be satisfactory. But the use of hair sample for a measurement of zinc level has one demerit. That is, the method is more likely to be subjected to contamination because it makes more complicated procedures in sample preparation than the method of using blood sample.

• Journal of the Korean Applied Science and Technology
• /
• v.26 no.4
• /
• pp.440-450
• /
• 2009

Metal(Zinc) soap and mixed metal(Zn/Ba) soap were synthesized with good structures and characterized by IR and H-NMR. The H-NMR spectrums of the synthesized soaps were in very good accordance with the structures proposed by earlier workers. The mixed metal soaps with various costabilizers(acid or metal content effect), which added in order to investigate the thermal stabilization effect at low and high temperature, were investigated the thermal stabilization effect. The temperature effect is relation to the metal content effect than acid effect. In case of mixed metal soap, the high thermal stabilization effect improved with increasing Barium content. As the Zinc content increase the low temperature thermal stabilization effect improved, but the high temperature thermal stabilization effect showed an opposite tendency.

• Journal of the Korean Ceramic Society
• /
• v.31 no.11
• /
• pp.1396-1400
• /
• 1994

Electrical properties in the ZnO-Bi2O3-CoO-Zn7Sb2O12 system were investigated with Zn7Sb2O12 content (0.1~2 mol%). The increase of the Zn7Sb2O12 content inhibited the grain growth of ZnO, which showed a narrow grain size distribution of ZnO. The breakdown voltage (Vb) increased markedly with 1 mol% Zn7Sb2O12 addition due to the grain growth control behaviour of the Zn7Sb2O12 . The nonlinear I-V characteristic was significantly influenced by the Zn7Sb2O12 content (or Bi2O3/Zn7Sb2O12 ratio). Addition of 0.5 mol% Zn7Sb2O12 showed the highest nonlinear coefficient ($\alpha$) of 43. The leakage current in prebreakdown region was decreased with increasing Zn7Sb2O12 content.

• Journal of the Korean Ceramic Society
• /
• v.51 no.6
• /
• pp.612-617
• /
• 2014

The microstructure, nonlinear properties, and impulse clamping characteristics of Pr/Co/Cr/Al co-doped zinc oxide ceramics were investigated with various contents of $Er_2O_3$. Increasing $Er_2O_3$ content increased the density of the sintered pellets from 5.69 to $5.83g/cm^3$, and decreased the average grain size from 10.6 to $6.5{\mu}m$. With increased $Er_2O_3$ content, the breakdown field increased from 2318 to 4205 V/cm, and the nonlinear coefficient increased from 19.4 to 40.2. The clamp characteristics were improved with the increase of the content of $Er_2O_3$. The varistors doped with 2.0 mol% exhibited the best clamp characteristics, in which the clamp voltage ratio was 1.40-1.73 at 1-50 A in an impulse current.

• Korean Journal of Metals and Materials
• /
• v.47 no.7
• /
• pp.423-432
• /
• 2009

In the galvanizing coating process, the effects of the silicon content on the coatability and wettability of molten zinc were investigated on Dual-Phase High Strength Steels (DP-HSS) with various Si contents using the galvanizing simulator and dynamic reactive wetting systems. DP-HSS showed good coatability and a well-developed inhibition layer in the range of Si content below 0.5 wt%. Good coatability was the results of the mixed oxide $Mn_{2}SiO_{4}$, being formed by the selective oxidation on the surface, with a low contact angle in molten zinc and a large fraction of oxide free surface that provided a sufficient site for the molten zinc to wet and react with the substrate. On the other hand, with more than 0.5 wt%, DP-HSS exhibited poor coatability and an irregularly developed inhibition layer. The poor coatability was due to the poor wettability that resulted from the development of network-type layers of amorphous ${SiO}_{2}$, leading to a high contact angle in molten zinc, on the surface.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.23 no.5
• /
• pp.718-724
• /
• 1994

The study was conducted to investigated the effect of dietary levels of zinc (Zn) on lipid metabolism in cadmium (Cd) treated rats. Sixty male Sprague-Dawley rats weighing about 110$\pm$10g were divided into 6 groups. The Zn levels were low (0ppm), control (30 ppm) and Cd-treated groups were administrated with Cd chloride (5.0mg/kg of body weight) by oral intubation at the same time once a week. Serum total lipid, triglyceride , total cholesterol and DHL-cholesterol contents decreased significantly in low Zn group. In serum dietary high Zn group, it decreased significantly in the content of triglyceride but total cholesterol and HDL- cholesterol revealed increase slightly . Total lipid and triglyceride contents increased by Cd oral intubation, but triblyceride content of control group decreased significantly in Cd-treated groups. HDL-cholesterol content also decreased by Cd oral intubationl. Cd-treatment increased total cholesterol content in low Zn group. Liver triglyceride content increased as dietary Zn level became more increasing and total lipid was not influenced by dietary Zn levels. Liver cholesterol content was higher in low and high Zn groups than that of control group. Liver phospholipid content decreased in low Zn group . Oral intubation of Cd increased in the contents of triglyceride and total lipid. The content of liver Zn was not influenced by the dietary low Zn but that of serum showed a remarkable increased . Oral Cd intubation increased the Cd contents of liver and serum.

• Resources Recycling
• /
• v.13 no.2
• /
• pp.39-46
• /
• 2004

The amount of electric furnace dust has been steadily increasing due to the increase of iron scraps which are usually recycled by electric furnace melting process. To date, this electric furnace dust has usually been treated by landfilling, however, because of shortage of landfill sites and heavy metal leaching more desirable treatment schemes are urgently needed. Among several possible schemes for the proper treatment of electric furnace dust, its recycling can be said to be most desirable. In present study, the triboelectrostatic separation of zinc and zinc-containing components from electric furnace dust was attempted based on its physicochemical properties such as particle shape, size distribution, and chemical assay. The dust was found to be mixed with spherical and non-spherical shaped particles and its major component materials were $ZnFe_2$$O_4$, ZnO, Fe, Zn, and FeO. The content of zinc-containing components in the entire dust was observed to be in the range of 15～30 wt%, which reasonably justified that zinc is recyclable. The triboelectrostatic characteristic of each component material was found to be different each other since their work functions were different, and based on this characteristic zinc and zinc-containing component could be flirty separated from the dust. After selecting a proper tribo-elec-trification material, the separation features of zinc and zinc-containing component were examined by taking the distance of electrodes, electric field strength, and scavenging as the experimental variables. The highest zinc-content obtained under the optimal separating condition was found to be up to 50wt%.

• Corrosion Science and Technology
• /
• v.6 no.4
• /
• pp.147-153
• /
• 2007

This study sought to investigate the reaction of Co-binder containing tungsten with molten zinc. Four kinds of Co-W alloys (pure, 10%W, 20%W, 30%W) were prepared using the powder metallurgy method. The specimens were immersion-tested in molten pure zinc baths at $460^{\circ}C$. To evaluate the corrosion property in molten zinc, the weight loss of the specimen was measured after the immersion tests at different immersion times (10~300 min.). Co-10%W alloys, compared with pure cobalt, showed no effect of tungsten addition on the reaction rate in molten zinc. The relationship between the weight loss and the square root of immersion period represents a straight line in both pure cobalt and Co-10%W alloy. The Co-Zn reaction layer in Co- 1O%W alloy consists of $\gamma2$, $\gamma1$, $\gamma$ and ($\beta1$ phases. The rate of weight loss significantly increases and the weight loss behavior is not well accord with the linear relationship as the tungsten content in the Co-W alloy increases. The $\beta1$ layer was not formed on the Co-20%W alloy and neither was a stable Co-Zn intermetallic compound layer found on the Co-30%W alloy. The main cause of increase in reaction rate with increasing tungsten content is related with the instability of the Co-Zn reaction phases as seen on micro-structural analysis.